Duracell Jump-Starter 900 Handleiding

Duracell Accu Jump-Starter 900

Lees hieronder de 📖 handleiding in het Nederlandse voor Duracell Jump-Starter 900 (2 pagina's) in de categorie Accu. Deze handleiding was nuttig voor 44 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/2

Portable Emergency Jump-starter

1. Features

1: Emergency light

button.

2: Battery Level button and

USB on/off switch

turns

on the battery level indicator.

Turns on power to the USB

charge port

3: LED fuel gauge. Battery

level indicator shows

battery fuel level.

4: USB charge port.

Supplies up to 2.1 Amps

of charging power for your

USB devices.

5: 12V DC power socket

powers 12V DC devices and

appliances.

6: Emergency light

provides bright LED

illumination in dark locations.

7: Jump-starter ON/OFF

switch

8: Negative jump starting

clamp

connects to the

negative

battery terminal OR

engine block

(see Section 6)

9: AC battery charger port

recharges the jump-starter’s

internal battery from a

standard AC wall outlet.

10:

AC power cord

11: Positive jump starting

clamp

connects to the

positive

battery terminal (see

Section 6)

2. Important Safety Information

Misusing or incorrectly connecting the Duracell® jump-starter may damage other equipment or

create hazardous conditions for users.

WARNING: ELECTRICAL SHOCK HAZARD

The jump-starting clamps may spark if touched together. Always keep the clamps in their

storage holsters when they are not being used.

3. Charging/Recharging the Jump-starter

► Charge before rst use

IMPORTANT

Prior to using the jump-starter for the rst time, ensure that the battery of the jump-starter is

fully charged. If the battery has been fully discharged, charging with the AC battery charger

may take up to 12 hours.

► Charging with the internal charger

Charging with the internal charger is a true “plug-in-and-forget” charging method. We

recommend leaving the AC battery charger connected when the jump-starter is not in use.

1. Disconnect any USB and 12V DC appliances from the DC power outlets.

2. Insert the included AC cord end into the AC cord input port, then plug AC cord into a

standard AC wall outlet.

3. The charging LED shows the charging status.

4. Recharging time should be approximately 12 hours if the jump-starter battery is fully

discharged.

7. Maintenance

Routine maintenance is required to keep your Duracell® jump-starter operating properly.

Occasionally clean the exterior of the unit with a damp cloth to remove the accumulated dust

and dirt.

WARNING: SHOCK HAZARD

Disconnect all sources of AC power and DC power before performing any type of

maintenance.

► Battery maintenance

All rechargeable batteries gradually discharge when left standing, and you need to recharge

them periodically to maintain maximum battery capacity. The charger within the jump-starter

is designed to regulate the charging process, ensuring that the battery is always fully charged

but never overcharged. To ensure safe recharging and maximum battery life, recharge the

jump-starter only with the supplied charger or approved battery charger.

CAUTION

Due to inherent self-discharge, lead acid batteries must be charged at least every 3

months, especially in a warm environment. Leaving a battery in a discharged state, or not

recharging every 3 months, may result in permanent battery damage and poor jump-

starting performance.

CAUTION

Do not attempt to recharge the jump-starter battery if it is frozen. Gradually warm the frozen

battery to 32 °F (0 °C) before recharging.

8. Specications

Electrical specications

12V DC section

Internal battery type Sealed/non-spillable, AGM

(Absorbed Glass Mat) lead-acid

Internal battery voltage (nominal) 12V DC

Internal battery capacity (minimum) 12Ah

DC power socket (maximum continuous

load)

11A with automatic reset

Battery charging controller

system

AC input voltage 100 - 240V AC

Nominal output voltage 12V DC

Empty load power < 0.35W

Safety certications / efciency

certications

ETL

Physical specications

Length 13.6" (34.4 cm)

Width 6.8" (17.3 cm)

Height 9.8" (24.9 cm)

Weight 12.6 lbs. (5.72 kg)

IMPORTANT

If you keep the jump-starter in storage, the battery will discharge over time. Remember to

recharge the battery every three months to keep the jump-starter operational.

4. Checking the Jump-Starter’s Battery Level

To check the battery’s charge level, press the Battery Level button. The digital readout will

display the approximate charge level.

Note: The level is approximate. You may see sudden small changes up to 20%

when loads are applied or removed, this is only due to voltage changes and does not

indicate sudden drops in charge state. It is recommended to maintain a full charge

on the jump-starter at all times for optimal jump starting and device charging.

Note: Battery Fuel Gauge status is only accurate when the jump-starter has been

disconnected from all appliances and all charging sources for 15 minutes.

5. Using the Jump-Starter’s Light / Power Ports

► Using the built-in light

The Duracell® jump-starter has a built-in emergency light to provide a safe, bright work light on

the roadside and in other outdoor environments.

1. Push the "Emergency Light" button to turn on the LED light.

2. When done, push the "Emergency Light" to turn the LED light off.

► Using the USB port

The USB port provides up to 2.1 Amps of power to charge cell phones, smartphones, tablets

and other devices.

To charge USB devices:

1. Connect your USB device (smartphone, tablet etc.) to the USB port using the USB cable

supplied with your device.

2. Push the “Battery Level USB on/off” button.

3. Charging will start and up to 2.1 Amps of current can be supplied by the port. The USB

device controls the amount of current supplied.

4. The USB port never “pushes” more current than required by the devices.

5. Push the “Battery Level USB on/off” button again when done to turn the USB port off.

► Using the 12V DC power socket

The jump-starter can operate 12V DC appliances that draw 11A or less.

CAUTION: EQUIPMENT DAMAGE

The DC power outlet does not automatically switch off when the internal battery is

discharged. Check the battery status periodically to prevent total battery discharge.

To operate a 12V DC appliance:

1. Open the protective cover on the jump-starter’s DC power socket.

2. Plug the 12V DC appliance into the DC power outlet on the side of the unit, and turn the

12V DC appliance on (if required).

3. Fully recharge the jump-starter as soon as possible after each use.

4. As the DC power socket is internally wired directly to the jump-starter’s battery, extended

operation of a 12V DC appliance may result in excessive battery discharge. See

“Caution: Equipment Damage” above.

6. Jump-Starting A Vehicle’s Engine

You can use the Duracell® jump-starter with the supplied jump-start cables to jump-start a

vehicle or boat engine that has a 12V starting battery.

WARNING: FIRE HAZARD

Never allow jump-start cables’ red and black clamps to touch each other or another

common metal conductor. This could cause damage to the unit and/or create a sparking/

explosion hazard.

WARNING: FIRE HAZARD

Jump-start cable clamps’ connection to the vehicle’s battery terminals must be positive

to positive (red clamp to battery “+”) and negative to engine block. A reverse polarity

connection (positive to negative) may cause damage to the unit and/or create a sparking/

explosion hazard.

WARNING: FIRE HAZARD

Do not crank the engine for more than 4 seconds. The jump-start feature is designed for

short term operation only. Operating the jump-start feature for more than 4 seconds may

cause damage to the unit. Allow the jump-starter to cool down for at least 30 seconds after

each jump-start.

► To jump-start a vehicle engine:

1. Turn OFF the vehicle or boat ignition and all accessories.

2. Engage the park or emergency brake and place the transmission in park for an

automatic or neutral for a manual.

3. If jump-starting a boat engine, purge the engine compartment and bilge of all fumes.

4. Position the jump-starter on a at, stable surface near the battery and away from all

moving parts of the engine.

5. Make sure the red jump-starter switch is in the OFF position then connect the red

positive (+) clamp of the cables to the positive (+) terminal of the engine battery. The

battery’s positive terminal is usually larger in diameter than the negative terminal. In

most vehicles, the battery’s positive terminal has a red wire connected to it. (Refer to

your vehicle’s owner manual).

6. Connect the black negative (–) clamp of the cables to the negative battery terminal,

engine block, cylinder head, or other stationary heavy metal part of the motor.

7. Correct polarity must be established before proceeding. Re-check your connections

before starting your engine. If the clamps are reversed, an alarm will sound and

“CLAMPS REVERSED” LED illuminate. Disconnect the jump-start clamps from the

vehicle’s battery and redo steps 5 and 6 in this procedure.

8. Before starting the engine, make sure the jump-starter and the cables are clear of belts

and fans.

9. Turn the jump-starter switch to the ON position and turn over the engine for 4 seconds or

until it starts, whichever is rst.

10. Turn the jump-starter switch to the OFF position and remove the red positive (+) clamp

and then the black negative (–) clamp from the vehicle.

11. Store the jump-start clamps in the appropriate holder on each side of the jump-starter.

IMPORTANT

If you keep the jump-starter in storage, the battery will discharge over time. Remember to

recharge the battery every three months to keep the jump-starter operational.

Red POSITIVE (“+”)

clamp

connects

positive

battery

terminal

Black NEGATIVE (“

”) clamp

connects to the battery negative

terminal OR

metal part of car

(block, cylinder, etc)

9. General Warnings and Cautions

IMPORTANT: Please read these general usage-related warnings and cautions thoroughly

before using this jump-starter.

WARNING: Shock hazard. Keep away from children.

Do not insert foreign objects into the DC power socket, the USB port, or the ventilation

holes. Do not expose this product to water, rain, snow, or spray. Do not open the unit.

There are no user serviceable parts inside the unit.

CAUTION

Do not operate the jump-starter in temperatures under 0°C (32°F) or over 40°C (104°F).

WARNING: Explosion hazard

Do not use this product where there are ammable fumes or gases, such as in the bilge of

a gasoline-powered boat, or near propane tanks. Use caution when using this product in an

enclosure containing automotive-type lead-acid batteries. These batteries, unlike the sealed

AGM battery in the Jump-starter, vent explosive hydrogen gas which can be ignited by

sparks from electrical connections. When working on electrical equipment, always ensure

someone is nearby to help you in an emergency.

WARNING: Proper application

Do not use the appliance for any application except that for which it is intended.

WARNING: Medical equipment

This product is NOT tested, designed nor intended to be used with life support systems or

any other medical devices.

10. Recycling

Battery-Biz is committed to environmental responsibility and recommends that electronic

devices be disposed of properly. Please contact your local city ofces for information on

recycling and disposal programs for e-waste.

For instructions on how to recycle this product visit

http://www.call2recycle.org.

11. Contacting Customer Support

If you experience any problems or have any questions regarding your DURACELL® product,

free technical support is available. Call from a phone where you have access to your mobile

device.

Be prepared to provide the following information:

• Name, address and telephone number

• Name of the DURACELL® product

• Make and model of your device

• Symptoms of the problem(s) and what led to them

Technical Support is available by telephone:

U.S. and Canada (800) 300-1857

Outside of the US/Canada: (805) 437-7765

Written inquires should be directed to:

Battery-Biz Inc.

DURACELL® Product Inquiry

1380 Flynn Road, Camarillo, CA 93012, USA

12. Warranty and Return Information

Two Year Limited Warranty

The DURACELL® product carries a limited warranty against defects in material and

workmanship under normal use and service for two years from the original date of purchase.

The manufacturer or distributor, at its option, shall repair or replace the defective unit covered

by this warranty. Please retain the dated sales receipt as evidence of the date of purchase

as it will be required for any warranty service. In order to keep the warranty in effect, the

product must have been handled and used as described in the instructions accompanying

this warranty. This warranty does not cover any damage due to accident, misuse, abuse or

negligence.

Disclaimer Of Warranty

The limited warranty described herein is your sole remedy. To the extent permitted by law,

the manufacturer and distributor disclaim all other implied or express warranties including all

warranties of merchantability and/or tness for any particular purpose.

Limitation Of Liability

Except to the extent of repairing or replacing this product as expressly stated in the limited

warranty described herein, the manufacturer and distributor shall not be liable for any

damages, whether direct, indirect, incidental, special, consequential, exemplary, or otherwise,

including lost revenues, lost prots, loss of use of software, loss or recovery of data, rental

of replacement equipment, downtime, damage to property, and third-party claims, arising

out of any theory of recovery, including statutory, contract or tort. Not withstanding the

term of any limited or implied warranty, or in the event that any limited warranty fails of its

essential purpose, in no event will the manufacturer’s and distributors entire liability exceed

the purchase price of this product. Some states and provinces do not allow the exclusion or

limitation of incidental or consequential damages so the above limitations or exclusions may

not apply to you. This limited warranty gives you specic legal rights. You may have other

rights which vary from state to state and province to province.

WARNING

This product contains chemical(s) known to the State of California to cause cancer, birth

defects, or other reproductive harm.

® is a registered trademark of Duracell U.S. Operations, Inc., used under

registered trademarks of their respective holders. Distributed under license by Battery-Biz Inc., 1380 Flynn Road, Camarillo, CA

93012

UM-DRJS30 Rev 20161205

Product specificaties

Merk:	Duracell
Categorie:	Accu
Model:	Jump-Starter 900
Kleur van het product:	Black, Red
Gewicht:	5720 g
Breedte:	173 mm
Diepte:	344 mm
Hoogte:	249 mm
Capaciteit van de accu/batterij:	12000 mAh
Accu/Batterij voltage:	12 V
Aantal inbegrepen batterijen:	1 stuk(s)
Batterijtechnologie:	Sealed Lead Acid (VRLA)