DSC EV-DW4975 Handleiding

DSC Deur-/raamsensor EV-DW4975

Lees hieronder de 📖 handleiding in het Nederlandse voor DSC EV-DW4975 (1 pagina's) in de categorie Deur-/raamsensor. Deze handleiding was nuttig voor 39 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/1
EV-DW4975 Vanishing Door/Window Contact
Installation Manual
Introduction
The EV-DW4975 is the industries thinnest supervised
door/window contact allowing a multitude of applications
while hiding the transmitter on a door or window frame. The
EV-DW4975 uses a replaceable lithium battery and should
last 5 years under normal usage.
Install or Replacing the Battery
The EV-DW4975 uses a Panasonic CR2032 Lithium Battery
and is shipped not installed to save battery life.
Follow the steps below to install or replace the battery.
1) Using a coin (Figure 1) or a flat head screw driver (Figure 2)
insert into the notch located on the case and gently twist to
open. Lift up and pull the case outward to open (Figure 3).
2) Insert Battery (figure 4) + side facing UP.
Use care when installing the battery and observe the correct
polarity when the battery is inserted. Use only Panasonic
Lithium CR2032 batteries for replacement.
WARNING!: Battery may explode if mistreated.
Do not recharge, disassemble or dispose of in fire.
Mount Transmitter and Magnet
1) Mount the EV-DW4975 on any window or door frame using the supplied
double strick tape or screws (Figure 5).
2) Find the notch on the outside of the EV-DW4975 enclosure. Align the
magnet with the notches and ensure that the distance is no greater than
5/8 of an inch (Figure 6).
Enrolling
Refer to your installation manual for enrolling wireless devices into a
DSC control panel.
Specifications
• Frequency 433.92
• Transmission: ASK
• Operating Temperature: -10C-+50C
• Nominal Battery Life: 5 Years. Varies with Usage and Temperature
• Battery Type: Panasonic CR2032
FCC COMPLIANCE STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
IC: The term ‘IC:’ before the radio certification number only signifies that Industry Canada technical specifications were met.
Figure 3 Figure 4
Figure 1 Figure 2
Figure 5
Figure 6
Technical Support:
(866) 908-TECH (8324)
©2006 Secure Wireless
EV-DW4975 Vanishing Door/Window Contact
Installation Manual
Introduction
The EV-DW4975 is the industries thinnest supervised
door/window contact allowing a multitude of applications
while hiding the transmitter on a door or window frame. The
EV-DW4975 uses a replaceable lithium battery and should
last 5 years under normal usage.
Install or Replacing the Battery
The EV-DW4975 uses a Panasonic CR2032 Lithium Battery
and is shipped not installed to save battery life.
Follow the steps below to install or replace the battery.
1) Using a coin (Figure 1) or a flat head screw driver (Figure 2)
insert into the notch located on the case and gently twist to
open. Lift up and pull the case outward to open (Figure 3).
2) Insert Battery (figure 4) + side facing UP.
Use care when installing the battery and observe the correct
polarity when the battery is inserted. Use only Panasonic
Lithium CR2032 batteries for replacement.
WARNING!: Battery may explode if mistreated.
Do not recharge, disassemble or dispose of in fire.
Mount Transmitter and Magnet
1) Mount the EV-DW4975 on any window or door frame using the supplied
double strick tape or screws (Figure 5).
2) Find the notch on the outside of the EV-DW4975 enclosure. Align the
magnet with the notches and ensure that the distance is no greater than
5/8 of an inch (Figure 6).
Enrolling
Refer to your installation manual for enrolling wireless devices into a
DSC control panel.
Specifications
• Frequency 433.92
• Transmission: ASK
• Operating Temperature: -10C-+50C
• Nominal Battery Life: 5 Years. Varies with Usage and Temperature
• Battery Type: Panasonic CR2032
FCC COMPLIANCE STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
IC: The term ‘IC:’ before the radio certification number only signifies that Industry Canada technical specifications were met.
Figure 3 Figure 4
Figure 1 Figure 2
Figure 5
Figure 6
Technical Support:
(866) 908-TECH (8324)
©2006 Secure Wireless

Product specificaties

Merk: DSC
Categorie: Deur-/raamsensor
Model: EV-DW4975
Kleur van het product: Wit
Connectiviteitstechnologie: Draadloos
Accu/Batterij voltage: 3 V
Ondersteund aantal accu's/batterijen: 1
Geschikt voor: Deur/raam
Levensduur van de batterij: 95 maand(en)
Frequentie: 433 MHz
Bedrijfstemperatuur (T-T): -10 - 50 °C
Relatieve vochtigheid in bedrijf (V-V): 5 - 93 procent
Batterijtechnologie: Lithium
Type batterij: CR2032

Heb je hulp nodig?

Als je hulp nodig hebt met DSC EV-DW4975 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Deur-/raamsensor DSC

DSC

DSC EV-DW4975 Handleiding

28 Maart 2023

Handleiding Deur-/raamsensor

Nieuwste handleidingen voor Deur-/raamsensor

Optex

Optex OA-Edge T Handleiding

5 December 2024
Optex

Optex OM-106C Handleiding

5 December 2024
Optex

Optex OA-6500 Handleiding

5 December 2024
Pentatech

Pentatech MA80KM Handleiding

24 November 2024
Optex

Optex OA-4500 Handleiding

15 November 2024
Schwaiger

Schwaiger HSA250 532 Handleiding

6 Oktober 2024
Kidde

Kidde K10LLDCO Handleiding

13 September 2024
Kidde

Kidde 2030-DCR Handleiding

12 September 2024
ORNO

ORNO OR-SH-17600 Handleiding

22 Augustus 2024
ORNO

ORNO OR-SH-17601 Handleiding

22 Augustus 2024