Dreadbox Disorder Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Dreadbox Disorder (3 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 42 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/3
Accepts a wide range of levels.
There is an inner trimmer
that sets the gain of the effect.
For more info, check page 3.
Sends 0 - 5 V
Filter Mode
and Cut Off Amount
At about 50%, the Filter switches
through modes internally
(a short click might be audible
when doing this)
Modulations (Filter CV and Envelope)
only affect the current filter mode selected
Fuzz Amount
At about 50%, the Fuzz Gate kicks in.
Below that amount the Gate is open
and a low level of hum might be audible
(and expected)
Set the Filter’s Feedback amount
On higher levels, depending on the Filter’s frequency,
self-oscillation starts
Positive works best for Low Pass,
while negative for the High Pass Filter
Controls the envelope amount
and sensitivity going to the filter
Set the Effect Level
Select the Envelope’s Polarity
The disturbance in physical or mental health or functions. It could be defined as a set
of problems, which result in causing significant difficulty, distress, impairment
and/or suffering in a person's daily life.
Located inside the pedal, there is a small trimpot that allows you to set the initial input gain of the effect.
This process will not break the warranty.
To gain access :
With a HEX M11 nut driver
remove the back jack nuts
With a philips PH1 screwdriver
remove the 4 side bolts
Using a small flat screwdriver
set the initial gain of the pedal.
To set the gain correctly, there are two methods. The choice of method depends on your playing style.
Method A
If you like to keep the fuzz level down for low gain sounds, power up the pedal and set it as following:
FILTER= 50% SENSE = 0% RESON = 0% FUZZ = 0% LEVEL = 50%
Be careful not to touch the green PCB area or any other visible vias on the PCB. Hold the pedal’s enclosure on the sides if you have to.
Now play your guitar (or any other instrument). Your goal is to set the gain so that your signal gets slightly distorted.
Of course, you are free to set it up any way that sounds better for you, the above is just a suggestion.
Method B
If you like the fuzz levels to be extreme, power up the pedal and set it as following:
FILTER= 50% SENSE = 0% RESON = 0% FUZZ = 100% LEVEL = 50%
Be careful not to touch the green PCB area or any other visible vias on the PCB. Hold the pedal’s enclosure on the sides if you have to.
Now do not play your guitar, but keep its strings muted with your hand. Find the point where the gain allows some random noise elements to pass,
even with your guitar muted. Then set the trimpot exactly before those noise elements appear.
Of course, you are free to set it up any way that sounds better for you, the above is just a suggestion.


Product specificaties

Merk: Dreadbox
Categorie: Niet gecategoriseerd
Model: Disorder

Heb je hulp nodig?

Als je hulp nodig hebt met Dreadbox Disorder stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Dreadbox

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd