Dimplex DXUC2B Handleiding

Dimplex Heater DXUC2B

Lees hieronder de 📖 handleiding in het Nederlandse voor Dimplex DXUC2B (4 pagina's) in de categorie Heater. Deze handleiding was nuttig voor 22 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/4

08/51936/0 Issue 8

The product complies with the European Safety Standards EN60335:2-30 and the European Standard Electromagnetic Compatibility (EMC) EN55014:1,

EN55014:2, EN61000:3-2 and EN61000:3-3 which cover the essential requirements of EMC Directive 2014/30/EU and the LVD Directive 2014/35/EU.

As with all portable heang appliances: This product is suitable only for well insulated spaces or occasional use.

Installation and Operating Instructions

DXUC2B

Important Safety Advice

DO NOT use the heater in the immediate

surroundings of a bath, a shower or a swimming

pool.

DO NOT place the heater directly below a xed

socket outlet.

The socket-outlet must be accessible at all times

to enable the mains plug to be disconnected as

quickly as possible.

WARNING: In order to avoid a hazard due to

inadvertent resetting of the thermal cut-out,

this appliance must not be supplied through an

external switching device, such as a timer, or

connected to a circuit that is regularly switched

on and off by the utility.

WARNING: In order to avoid overheating, do not

cover the heater.

The heater carries the warning symbol

indicating that it must not be covered.

IMPORTANT: If the mains lead of this appliance is

damaged, it must be replaced by the manufacturer

or its service agent or a similarly qualied person

in order to avoid a hazard.

CAUTION: Some parts of this product can

become very hot and cause burns. Particular

attention has to be given where children and

vulnerable people are present.

WARNING: To avoid danger of suffocation please

remove all packaging materials particularly plastic

and EPS and keep these away from vulnerable

people,children and babies.

WARNING: To avoid the risk of accidental

strangulation from the supply cord all children and

vulnerable people must be supervised when in the

vicinity of the product whether it is working or not.

IMPORTANT: Avoid use of and extension cord

because the extension cord may overheat and

cause risk of re.

IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE

This appliance can be used by children aged from

8 years and above and persons with reduced

physical, sensory or mental capabilities or lack of

experience or knowledge if they have been given

supervision or instruction concerning the use of

the appliance in a safe way and understand the

hazards involved. Children shall not play with the

appliance. Cleaning and user maintenance shall

not be made by children without supervision.

Children of less than 3 years should be kept away

unless continuously supervised. Children aged

from 3 years and less than 8 years shall only

switch on/off the appliance provided that it has

been placed or installed in its intended normal

operating position and they have been given

supervision or instruction concerning the use of

the appliance in a safe way and understand the

hazards involved. Children aged from 3 years and

less than 8 years shall not plug in, regulate and

clean the appliance or perform user maintenance.

The heater should always be used on a at, stable

surface.

DO NOT use the heater on deep pile carpets or

the long hair type of rugs, or less than 750mm

(30”) away from any overhanging surface. Keep

combustible materials such as drapes and other

furnishings clear from the front, sides and rear of

the heater.

DO NOT use heater to dry your laundry.

The instruction leaet belongs to the appliance

and must be kept in a safe place. If changing

owners, the leaet must be surrendered to the

new owner.

DO NOT COVER or obstruct in any way the air

inlet slots in the top and bottom of the heater, or

the air outlet slots at the front of the heater.

DO NOT operate the heater with the mains lead

overhanging the front outlet grille.

Model s( )  Specication

DXUC2B 2.0kw Switch & Thermostat

DXUC2B Ceramic Fan Heater

Dimensions

(millimetres)

H W D

258 185 185

Fig. 1

6ZLWFK.QRE 7KHUPRVWDW.QRE

DO NOT CO VER

Electrical connection

This heater must be used on an ~ supply only and the

voltage marked on the heater must correspond to the

supply voltage. This heater is tted with a rewirable plug

incorporating a 13 amp fuse. In the event of replacing the

fuse in the plug supplied, a 13 amp fuse approved by ASTA

to BS 1362 must be used. If any other type of plug is used,

a 15 amp fuse must be tted in the plug, the adaptor, or at

the distribution board.

IMPORTANT : If the plug is not suitable for your socket,

the 13 amp plug should be removed. Before wiring the

appropriate plug, please note that the wires in this mains

lead are coloured in accordance with the following code :

BLUE : NEUTRAL

BROWN : LIVE

As the colours of the wires in the mains lead may not

correspond with the coloured markings in your plug, proceed

as follows :

Connect the wire to the terminal marked ‘ ’ or coloured BROWN L

RED BLUE. Connect the wire to the terminal marked ‘N’ or

coloured .BLACK Note : ‘L’ or ‘N’ wire must not be connected to

the EARTH terminal marked ‘E’ or ‘ ’ or coloured or GREEN

GREEN AND YELLOW. If in doubt, consult your electrician.

Operation

Switch – see Fig. 1

With the selector switch, the fan can be switched on or the

heat setting selected. The power indicating light illuminates

when the Switch is turned on.

Thermostat – see Fig. 1

In order to maintain a certain room temperature, set the

controller to ‘max.’. Operate the appliance at full power

until the required room temperature is reached. Set back

the thermostatic controller until the appliance switches off

with an audible ‘click’. This temperature will be kept almost

constant by the thermostatic control switching on and off

automatically. Please note that the appliance can only be

switched on when the thermostat setting is higher than the

room temperature.

With the thermostat knob set to ‘ ’ and the switch knob

set to the required heating output the appliance switches

on automatically when the temperature falls below +5°C -

+8°C.

Safety

Overheat Protection

For your safety, this appliance is tted with a thermal cut-out.

In the event that the product overheats, the cut-out switches

the heater off automatically.

To bring the heater back into operation, remove the cause of

the overheating, then unplug or turn off the electrical supply

to the heater for a few minutes. When the heater has cooled

sufciently, re-connect and switch on the heater.

Fuselink

A thermal fuse link is provided as an added safety feature.

If the fuse link operates and opens circuit it is the result of

abnormal overheating within the appliance and servicing

of the appliance by a competent service engineer will be

required in order to ensure the future safe operation of the

heater. Customer services should be contacted, who will

arrange the replacement of any faulty parts and the tting

of a new fuse link.

Cleaning

Switch off the appliance rst and disconnect the plug from

the socket. Clean the housing with a moist cloth, vacuum

cleaner or brush. Do not use any abrasive or caustic

cleaning agents. Do not use any flammable cleaning

agents e.g. petrol or spirit for cleaning the appliance.

Never immerse the appliance in water. Air inlet and outlet

area should be cleaned with a vacuum cleaner regularly. If

the appliance is not used for extended periods, it must be

protected against excessive dust and dirt.

Recycling

For electrical products sold within the

European Community. At the end of the

electrical products useful life it should not

be disposed of with household waste.

Please recycle where facilities exist. Check

with your Local Authority or retailer for

recycling advice in your country.

ModelIdentier(s): DXUC2B

Heat output

Nominal heat output Pnom 2.0 kW

Minimum heat output (indicative) Pmin 1.1 kW

Maximum continuous heat output Pmax,c 2.0 kW

Auxiliary electricity Consumption

At nominal heat output 0.0elmax kW

At minimum heat output elmin 0.0 kW

In standby mode elSB 0.0 kW

Type of heat output/ room temperature control

Mechanical thermostat room temperature control Yes

Contact details

GDC Group Limited

Millbrook House, Grange Drive, Hedge

End, Southampton.

SO30 2DF

Telephone: 0844 879 3588

Email: customer.services@gdcgroup.co.uk

Visit: www.gdcgroup.co.uk

Product specificaties

Merk:	Dimplex
Categorie:	Heater
Model:	DXUC2B
Soort bediening:	Draaiknop
Kleur van het product:	Zwart
Aantal vermogenniveau's:	2
Gewicht:	1990 g
Breedte:	205 mm
Diepte:	205 mm
Hoogte:	274 mm
Snoerlengte:	1.5 m
Breedte verpakking:	215 mm
Diepte verpakking:	215 mm
Hoogte verpakking:	290 mm
Soort:	Ventilator elektrisch verwarmingstoestel
Aantal snelheden:	2
Automatisch uitschakelen:	Ja
Indicatielampje:	Ja
Geschikt voor:	Binnen
Instelbare thermostaat:	Ja
Certificering:	CE
AC-ingangsspanning:	230 - 240 V
Bevriezings beveiliging:	Ja
Verwarmingsvermogen:	2000 W
Plaatsingsopties:	Vloer
Verwarmingselement type:	Keramisch