Digitus DK-1P32-S-100 Handleiding

Digitus Acculader DK-1P32-S-100

Lees hieronder de 📖 handleiding in het Nederlandse voor Digitus DK-1P32-S-100 (9 pagina's) in de categorie Acculader. Deze handleiding was nuttig voor 11 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/9
E-Mobility Charging cable –
t ype 2 to type 2
Quick Instalation Guide
DK 1P32 1P32 1P32 100/ - -050/ DK- -075/ DK- -
DK 1P32 1P32 1P32 100/- -S-050/ DK- -S-075/ DK- -S-
DK 3P16 3P16 3P16 100/ - -050/ DK- -075/ DK- -
DK 3P16 3P16 3P16 100/ - -S-050/ DK- -S-075/ DK- -S-
DK 3P32 3P32 3P32 100/ - -050/ DK- -075/ DK- -
DK 3P32 3P32 3P32 100 1.0- -S-050/ DK- -S-075/ DK- -S- – . Rev
2
Please read this manual carefully before installation and use,
otherwise, it may interfere with the normal use of the equipment
and even risk causing personal injury.
1. Safety and Points for Attention
1.1. Installation & Maintenance
 Before installation, please visually inspect the
appearance to check whether the equipment is
damaged during transportation. If it is damaged, please
immediately notify the carrier or the manufacturer.
 Do not drop any foreign objects, especially metal
objects, into the charging plug or connector pins.
 Do not step on the cable and do not violently pull out
the charging connector
 Please do not use the charging cable outside its normal
operating range of - 30 to +50°C.
 The Charging cable has an IP rating of IP55 for dust
and waterproof. Please use it with care under this
IP55 rating.
 IP55 is ensured only when the products are engaged
with vehicle inlets with protection degree higher or
equal to IP55.
 When the products are fully engaged with the vehicle
inlets with protection degree lower than IP55, the lower
protection degree of the two accessories shall be
checked.
3
 Please do not dismantle the protective cap. To protect
the charging connector from moisture and dirt, after
every use, put the protective caps back on.
 Please do not withdraw the connector and plug out of
EV inlet and socket while under load.
 Additional adaptors and conversion adapters are not
allowed to be used with this cable.
 Cord extension sets are not allowed to be used with this
cable assembly.
 The max cable length shall not exceed 5m when used in
Switzerland.
 Please make sure that the charging adapters and the
cable are free from any signs of scratches, rust, cracks
before usage.
 Before charging, please make sure the power plug and
outlet are compatible as IEC 62196-2.
 DO not insert any fingers into the charging plug.
 Use the product under normal away from high
temperature erosive materials or ignition source.
 Please make sure that the plug & connector are fully
inserted until it clicks into place.
 It is recommended that routine safety inspection on the
cable.


Product specificaties

Merk: Digitus
Categorie: Acculader
Model: DK-1P32-S-100
Snoerlengte: 10 m
Gebruikershandleiding: Ja
Internationale veiligheidscode (IP): IP55
Aantal per verpakking: 1 stuk(s)
Beschermkap: Ja
Kleur kabel: Zwart
Operating voltage: 240 V
Bedrijfstemperatuur (T-T): -30 - 50 °C
Relatieve vochtigheid in bedrijf (V-V): 5 - 95 procent
Aantal fases: 1
Aansluiting 1: Type 2
Aansluiting 2: Type 2
Connector 1 vormfactor: Recht
Connector 2 vormfactor: Recht
Diameter van de kabel: 16.8 mm
Maximale bedrijfsstroom per fase: 32 A

Heb je hulp nodig?

Als je hulp nodig hebt met Digitus DK-1P32-S-100 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Acculader Digitus

Handleiding Acculader

Nieuwste handleidingen voor Acculader