Dickert DZS25 Handleiding
Dickert
Garagepoortopener
DZS25
Lees hieronder de 📖 handleiding in het Nederlandse voor Dickert DZS25 (4 pagina's) in de categorie Garagepoortopener. Deze handleiding was nuttig voor 43 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/4
EN Ceiling pull switch DZS25
28510670_DZS25_EN_2015-02-18.doc 1 / 4
Ceiling pull switch DZS25
Mounting and Operating Instructions
(Translation of original operating manual)
Always read before initial operation!
Ceiling pull switch DZS25
2 / 4 28510670_DZS25_EN_2015-02-18.doc
+
-
AA alkaline
+
-
AA alkaline
ON
12
ON
12345678910
DIP
2
1
34
5
6
7
1 Intended use
Wireless remote control units are only approved for use with devices and systems where a
functional problem in the transmitter or receiver does not result in a hazard for people, animals or
property hazard or if this risk is covered by other safety equipment. The user must be informed that
the wireless remote control of door systems with a risk of accidents is only permissible, if at all,
with direct eye contact to the door system and when the motion range must be free of people,
animals and objects. Store the hand-held transmitter so that unwanted activation, e.g. by children
or animals, is impossible. The wireless remote control units in use work on generally-approved
frequencies (ISM bands). The operator of such wireless remote control units is not protected from
faults caused by other wireless systems or devices (e.g., wireless systems being operated in the
same frequency range such as baby phones, intercoms, etc.).
Any use other than the intended use shall be considered improper use for which the manufacturer
is not liable. The fitter, electrician or operating organisation bears the risk and the liability here.
2 Functional description
10 pin coding switch linear code
For setting the code with 18 bit linear operation.
"Unsymmetrical" coding must be set in transmitters which have a coding
switch!
Ceiling pull switch DZS25
28510670_DZS25_EN_2015-02-18.doc 3 / 4
2 pin DIP switch linear/Keeloq
DIP1 "OFF“ – Linear code
The coding switch provides the option to set 1024 different safety codes. At the
same time, you can also set several transmitters with the same code to control the
same receiver with all transmitters. If you leave all switches on "ON" or "OFF" at the
coding switch, then the sender works with one of 262,000 possible codes that are
sequentially programmed at the factory. In this case, the ceiling pull switch transmits a
coding that is equivalent to button 1 at the hand transmitter.
DIP1 "ON“ – Keeloq code
Function KeeLoq / change code
The transmitter works in accordance with the state of the art KeeLoq process. A new
code is calculated with each actuation. During normal use (garage door, etc.) it takes
more than 20 years before a code is repeated! Teach the transmitter in accordance
with the receiver instructions. The receiver checks the radio signal before the output
switches and it controls your unit. To do that, keep the transmit key pressed for at least
2 seconds. If the battery is charged, then the LED at the transmitter is illuminated
during this time.
DIP2 without function.
Radio transmission module with antenna
Transmission switch
Transmission duration as long as the switch is actuated, min. 3 data words, max 3 min.
Transmission LEDs
Illuminated during actuation, flashing alternatively during initialization.
Green - linear code is transmitted
Red - Keeloq code is transmitted
The respective LED flashes in transmission mode if the battery charge is weak.
The initialization is performed during the switch-over of the DIP1 coding switch , or
during battery change. The radio command is only provided during the next actuation
of the transmission switch.
Batteries
2 units AA Alkaline-Manganese required
Antenna:
Must be aligned at full length.
3 Range
Typical ranges are:
50 m in open space.
The range achieved at the usage location depends on the receiver and transmitter
positions as well as the antenna installation of the receiver.
Product specificaties
| Merk: | Dickert |
| Categorie: | Garagepoortopener |
| Model: | DZS25 |
Heb je hulp nodig?
Als je hulp nodig hebt met Dickert DZS25 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Garagepoortopener Dickert
4 Mei 2023
4 Mei 2023
4 Mei 2023
4 Mei 2023
4 Mei 2023
Handleiding Garagepoortopener
- Garagepoortopener Abon
- Garagepoortopener Aperto
- Garagepoortopener Berner
- Garagepoortopener Budgetgaragedeuren
- Garagepoortopener DITEC
- Garagepoortopener Doco
- Garagepoortopener Doorsystems
- Garagepoortopener Einhell
- Garagepoortopener Entrematic
- Garagepoortopener FAAC
- Garagepoortopener Geba Tronic
- Garagepoortopener Goris
- Garagepoortopener Homentry
- Garagepoortopener Hormann
- Garagepoortopener Liftmaster
- Garagepoortopener MAC
- Garagepoortopener Marantec
- Garagepoortopener Novoferm
- Garagepoortopener Novotecnica
- Garagepoortopener Profitech
- Garagepoortopener Rademacher
- Garagepoortopener Seculux
- Garagepoortopener Silver
- Garagepoortopener Skylink
- Garagepoortopener Somfy
- Garagepoortopener Sommer
- Garagepoortopener Superrollo
- Garagepoortopener Tormatic
- Garagepoortopener Univer
- Garagepoortopener Craftsman
- Garagepoortopener Chamberlain
- Garagepoortopener Maveo
Nieuwste handleidingen voor Garagepoortopener
15 November 2024
28 September 2024
1 December 2023
2 Oktober 2023
2 Oktober 2023
16 September 2023
16 September 2023
16 September 2023
16 September 2023
16 September 2023