Da-Lite Motorized Scenic Roller Handleiding

Da-Lite Projectiescherm Motorized Scenic Roller

Lees hieronder de 📖 handleiding in het Nederlandse voor Da-Lite Motorized Scenic Roller (8 pagina's) in de categorie Projectiescherm. Deze handleiding was nuttig voor 16 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/8

INSTRUCTION BOOK FOR

Motorized Scenic

Roller Screen

Important Safety Instructions

When using your video equipment, basic safety precautions

should always be followed, including the following:

1. Read and understand all instructions before using.

2. Position the cord so that it will not be tripped over, pulled, or

contact hot surfaces.

3. If an extension cord is necessary, a cord with a current rating

at least equal to that of the appliance should be used. Cords

rated for less amperage than the appliance may overheat.

4. To reduce the risk of electric shock, do not disassemble this

appliance. Contact an authorized service dealer when repair

work is required. Incorrect reassembly can cause electric

shock when the appliance is used subsequently.

5. The use of an accessory attachment not recommended by

the manufacturer may cause a risk of ire, electric shock, or

injury to persons.

WARNING: Before obtaining access to terminals, all

supply circuits must be disconnected.

ATTENTION! Avant d’accéder au bloc d’alimentation,

veuillez couper l’alimentation électrique.

6. An appropriate disconnect device shall be provided as part

of the building installation.

7. Failure to provide adequate structural strength for this

component can result in serious personal injury or damage

to equipment! It is the installer’s responsibility to make sure

the structure to which this component is attached can

support the weight of all equipment. Reinforce the structure

as required before installing the component.

8. Use this projection screen only for its intended use as

described in these instructions. Do not use attachments not

recommended by the manufacturer.

Save These Instructions

Original Instructions

Disclaimer

Milestone and its ailiated corporations and subsidiaries

(collectively "Milestone"), intend to make this manual accurate

and complete. However, Milestone makes no claim that the

information contained herein covers all details, conditions or

variations, nor does it provide for every possible contingency in

connection with the installation or use of this subject to change

without notice or obligation of any kind. Milestone makes no

representation of warranty, expressed or implied, regarding the

information contained herein. Milestone assumes no

responsibility for accuracy, completeness or suiciency of the

information contained in this document.

Da-Lite® is a registered trademark of Milestone AV Technologies.

Before proceeding with the installation please read the installation and operating instructions thoroughly. Make sure

to recheck measurements of screen and hanger locations before installation. Area must be clear for screen to operate.

With all lid sections removed from shipping container, remove the screws holding the frame to the shipping container

(2 per cross brace). The screen can now be carefully lifted out of the container.

Method A

The frame can be mounted to ceiling with 5/16" diameter

threaded rods. Level frame from front to back and left to right.

Mount from all cross braces (Figure 1).

Method B

Hang from a pipe (ly the screen). Level frame from front to

back and left to right. Mount from all cross braces (Figure. 2).

NOTE: Motor pulley must clear pipe. Chains must clear

motor tubes.

Screen motors have been internally wired at Da-Lite. Wiring

designated “external” is completed by installer conforming to

local and national codes. Refer to wiring diagram on next page.

Check for satisfactory condition by operating the screen. Be

prepared to stop screen. Standard Duty Cycle:

1 MIN. 30 SEC. ON / 45 MIN. OFF.

CAUTION! Excessive continuous operation may cause

overheating and motors will shut of.

Let motors cool 10 to 15 minutes and continue test.

ATTENTION! Le fonctionnement continu et excessif peut

provoquer une surchaufe et l'arrêt du moteur. Laissez le

moteur refroidir pendant 10 à 15 minutes et poursuivez le

test.

Check the cables to make sure they are winding on the motor

and roller pulleys properly.

1. With screen in complete unrolled position, examine the

screen surface carefully. If fabric does not hang lat, loosen

the nuts on the eyebolts of the black clamps. Adjust the

wingnuts to pull or relax the fabric as needed. Several clamp

heights may be adjusted depending on the severity of the

hang. After adjustment, tighten the nuts against the

underside of the frame. Caution stage hands and others to

check area before lowering screen. Do not bump screen with

ladders, scenery, etc.

Installation

Electrical Installation Screen Adjustment

Figure 1 Figure 2

Suggested Method Of Installation

Method A – Secure To Ceiling

Suggested Method Of Installation

Method B – “Flying Pipe”

Ceiling

Secure To Suit

Front

⁄" Threaded Rod

(Not Furnished)

Safety Switch Trigger

Back

Cross

Brace

Secure To

Suit

Cable

15"

Ceiling Pipe To Suit

Front

Chain To Suit

(Not Furnished)

Eye Bolts For Leveling

(Not Furnished)

Safety Switch

Trigger

Back

Cross

Brace

Product specificaties

Merk:	Da-Lite
Categorie:	Projectiescherm
Model:	Motorized Scenic Roller
Kleur van het product:	Wit
Gewicht:	- g
Breedte:	5840 mm
Oorspronkelijke beeldverhouding:	1:1
Diagonaal:	- "
Totale grootte van het scherm (hoogte x breedte):	549 x 549 cm
Formaat:	Vierkant
Schermgain:	1