Da-Lite Designer Contour Manual 91984 Handleiding

Da-Lite Projectiescherm Designer Contour Manual 91984

Lees hieronder de 📖 handleiding in het Nederlandse voor Da-Lite Designer Contour Manual 91984 (4 pagina's) in de categorie Projectiescherm. Deze handleiding was nuttig voor 42 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/4

INSTRUCTION BOOK FOR

Designer Contour® Manual

Care in mounting and care in correct operation will mean a long and satisfactory life for your Da-Lite wall/ceiling screen. Locate the

screen where the audience can best see it and where other furnishings in the room permit. Mount the screen so that bottom of picture

surface, when fully extended, will be above heads of viewers.

There are three ways to install the Designer Contour® Manual:

Wall Mount, Ceiling Mount, or Ceiling Hook. Procedures for each

method are as follows:

Wall Mount

1. Secure the wall mount bracket to the wall at the desired

height. Bracket should be fastened to wall studs or some

reinforcement within the wall. Concrete or brick walls require

special fasteners and anchors.

2. Make sure the bracket is level. See Figure 1 for

reference dimensions.

3. Keep in mind you will need at least 7/8" between the

ceiling and the top of the wall mount bracket to be able

to position the case on the bracket.

4. Mount the screen case on the wall bracket as shown in

Figure 1. Be sure the case is fully seated on the bracket.

Tighten the stop screws against the wall bracket.

Ceiling Mount

1. Do not remove the wall mount bracket, even if you are

not using it for mounting. This provides structural stability

to the case.

2. Be sure the ceiling has adequate reinforcement to attach

the screen brackets.

3. The top of the screen case has a channel that the ceiling

mount brackets slide into. Loosen the two set screws on

the brackets and slide bracket so it extends over the end of

the case. Lock the brackets in place by tightening two set

screws. Refer to Figure 2. Mount cannot be more than

12" from end of case.

4. Hold the screen case up to the ceiling and mark the hole

locations. Drill holes into the ceiling and attach screen with

the appropriate fasteners for your ceiling.

Installation

Set Screws (2)

Ceiling

Mount

Holes

Figure 2

Figure 1

⁄"

Case

Hook

Wall

Mount

Bracket

Stop Screw

⁄"

4 ¼"

45

Ceiling Hook

1. Do not remove the wall mount bracket, even if you are

not using it for mounting. This provides structural stability

to the case.

2. Be sure the ceiling has adequate reinforcement to attach

a hook anchor.

3. The top of the screen case has a channel that the ceiling

hook brackets slide into. The brackets can be attached

anywhere within 12" of the end of the case. Loosen the set

screws on the brackets and slide the brackets to the desired

location. Lock the brackets in place by tightening two set

screws. Refer to Figure 3.

4. Attach an S-hook or similar fastener to the large center

hole on the bracket.

To Lower Picture Surface

Pull screen down all the way. HESITATE – then allow screen to

retract VERY SLOWLY until it locks in place.

To Raise Picture Surface

Pull down on the pull bail, then release quickly. The screen will

retract gently into the case.

To Adjust Retraction Speed

Use a large lat screwdriver to turn the adjustment knob on the

right end of the screen (see Figure 2 or 3). To increase the travel

speed turn counterclockwise. To decrease the travel speed turn

clockwise. Adjustments should be made in half turn increments

and travel speed checked before adjusting further.

If screen locks at the bottom and will not retract, turn

adjustment knob one quarter turn counterclockwise.

Wall Brackets – (75# per pair maximum)

Da-Lite No. 6 and No. 11 Non-adjustable wall brackets and

No. 23 adjustable extension wall brackets are ideal for keystone

elimination, clearance, or corner mounting. The screen brackets

should be fastened to the studding or other solid surface and

not in the plaster only.

Installation

Operating Instructions

Screen Accessories

Hook Mount Hole

Set Screws (2)

Figure 3

No. 23 Adjustable

Wall Brackets

Screen can be extended

10", 14", 15¾", 18¼", 20" or

24" from wall by wing nut

and bolt adjustment.

No. 11 Wall Brackets

Screen can be extended

10" or 14" from wall by

changing position

of bracket.

No. 6 Wall Brackets

Screen can be extended

6" from wall.

T-Bar Clip

For Dropped Ceilings

50 Lb. Max. load capacity.

Tilt Lock

For Keystone Elimination

Holds back bottom of

screen in tilted position

to eliminate keystoning.

SHook

TBar clip

Ceiling

Product specificaties

Merk:	Da-Lite
Categorie:	Projectiescherm
Model:	Designer Contour Manual 91984
Kleur van het product:	Black, White
Vermogen:	- W
Oorspronkelijke beeldverhouding:	16:9
Montagewijze:	Plafond/muur
Aantal per verpakking:	1 stuk(s)
Ingangsspanning:	- V
Frequentie:	- Hz
Op afstand bedienbaar:	Nee
Zichtbare schermhoogte (h):	1320 mm
Zichtbare schermbreedte (b):	2336 mm
Diagonaal:	106 "
Type aandrijving:	Handmatig
Totale grootte van het scherm (hoogte x breedte):	- cm
Formaat:	HDTV
Grenzen:	- mm
Black drop:	- mm
Schermoppervlak:	Mat wit
Randen:	Ja
Tijd nodig voor op-/afrollen scherm:	- s