Da-Lite Designer Contour Electrol 89758W Handleiding
Da-Lite
Projectiescherm
Designer Contour Electrol 89758W
Lees hieronder de 📖 handleiding in het Nederlandse voor Da-Lite Designer Contour Electrol 89758W (8 pagina's) in de categorie Projectiescherm. Deze handleiding was nuttig voor 27 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/8
INSTRUCTION BOOK FOR
Designer Contour® Electrol®
With Built-In Infared Remote
2
Important Safety Instructions
When using your video equipment, basic safety precautions
should always be followed, including the following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over, pulled,
or contact hot surfaces.
3. If an extension cord is necessary, a cord with a current rating
at least equal to that of the appliance should be used. Cords
rated for less amperage than the appliance may overheat.
4. To reduce the risk of electric shock, do not disassemble this
appliance. Contact an authorized service dealer when repair
work is required. Incorrect reassembly can cause electric
shock when the appliance is used subsequently.
5. The use of an accessory attachment not recommended by
the manufacturer may cause a risk of ire, electric shock,
or injury to persons.
Save These Instructions
3
Installation
Carefully unpack screen and remove outer wrapping from case.
Remove the black tape from the slat bar after the case has been
installed.
There are three ways to install the Designer Contour® Electrol® with
built-in Infrared Remote: Wall Mount, Ceiling Mount, or Ceiling Hook.
Procedures for each method are as follows:
Wall Mount
1. Secure the wall mount bracket to the wall at the desired height.
Bracket should be fastened to wall studs or some reinforcement
within the wall. Concrete or brick walls require special fasteners
and anchors.
2. Make sure the bracket is level. See igure 1 for reference
dimensions.
3. Keep in mind you will need at least 5/8" between the ceiling and
the top of the wall mount bracket to be able to position the case
on the bracket.
4. Mount the screen case on the wall bracket as shown in igure 1.
Be sure the case is fully seated on the bracket. Tighten the stop
screws against the wall bracket.
Ceiling Mount
1. Do not remove the wall mount bracket, even if you are not using
it for mounting. This provides structural stability to the case.
2. Be sure the ceiling has adequate reinforcement to attach the
screen brackets.
3. The top of the screen case has a channel that the ceiling mount
brackets slide into. Remove the end cap on the right end of the
case and insert the brackets into the case channel. Lock the
brackets in place by tightening two set screws. Refer to igure 2.
Mount can not be more than 12" from end of case.
4. Hold the screen case up to the ceiling and mark the hole
locations. Drill holes into the ceiling and attach screen with the
appropriate fasteners for your ceiling.
Ceiling Hook
1. Do not remove the wall mount bracket, even if you are not using
it for mounting. This provides structural stability to the case.
2. Be sure the ceiling has adequate reinforcement to attach a hook
anchor.
3. The top of the screen case has a channel that the ceiling hook
brackets slide into. Remove the end cap on the right end of the
case and insert the brackets into the case channel. Lock the
brackets in place by tightening two set screws. Refer to igure 3.
4. The brackets can be attached anywhere within 12" of the end of
the case.
5. Attach an S-hook or similar fastener to the large center hole on
the bracket.
Figure 1
⁄" ⁄"
Case Hook
Wall Mount
Bracket
4 ¼"
4 ⅝"
Stop Screw
Figure 2
Set Screws (2)
Ceiling
Mount Holes
Endcap
Endcap
Screws (3)
Figure 3
Set Screws (2)
Hook Mount
Hole
Endcap
Endcap
Screws (3)
Product specificaties
Merk: | Da-Lite |
Categorie: | Projectiescherm |
Model: | Designer Contour Electrol 89758W |
Heb je hulp nodig?
Als je hulp nodig hebt met Da-Lite Designer Contour Electrol 89758W stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Projectiescherm Da-Lite
7 Augustus 2024
24 Juni 2023
4 Juni 2023
31 Mei 2023
30 Mei 2023
25 Mei 2023
21 Mei 2023
Handleiding Projectiescherm
- Projectiescherm Duronic
- Projectiescherm Elite
- Projectiescherm GPX
- Projectiescherm Kodak
- Projectiescherm Nec
- Projectiescherm Pyle
- Projectiescherm Vestel
- Projectiescherm Optoma
- Projectiescherm Oregon Scientific
- Projectiescherm Luxburg
- Projectiescherm Draper
- Projectiescherm AV:link
- Projectiescherm Projecta
- Projectiescherm Elite Screens
- Projectiescherm EluneVision
- Projectiescherm Celexon
- Projectiescherm Lumene
- Projectiescherm Stewart
- Projectiescherm Avers
- Projectiescherm Instaal
- Projectiescherm Elite ProAV
- Projectiescherm KHOMO GEAR
- Projectiescherm EPV
Nieuwste handleidingen voor Projectiescherm
18 Augustus 2024
18 Augustus 2024
20 Juni 2024
20 Juni 2024
4 Mei 2024
4 Mei 2024
4 Mei 2024
4 Mei 2024