CRUX RVCCH-75EC Handleiding
CRUX
Achteruitrijcamera
RVCCH-75EC
Lees hieronder de 📖 handleiding in het Nederlandse voor CRUX RVCCH-75EC (7 pagina's) in de categorie Achteruitrijcamera. Deze handleiding was nuttig voor 52 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/7
RVCCH-75EC
Rear View Integration Interface
for CHRYSLER & DODGE Vehicles with 8.4” Screen
R
INTERFACING SOLUTIONS
Sightline
Multi View Integration
Crux Interfacing Solutions • 6860 Canby Ave., Suite 104, Reseda, CA 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.010319
1 of 4
• Adds reverse camera to the Uconnect Touchscreen Radio
• Aermarket rear-view Camera included
• Automacally switches to rear-view when car is in reverse gear
• Plug & Play Installaon
PRODUCT FEATURES:
PARTS INCLUDED:
RVCCH-75EC Module RVCCH-75EC Harness CUB-01 Bullet Camera
INSTALLATION DIAGRAM:
WHITE Wire
Parking Guideline
DP
ON
DIP
SWITCH
LED* *LED RED = Power ON Status
LED BLUE = Data Bus ON Status
Regulator
20 Ft. Coax Cable
8-Pin Molex
Represents Solder Joint
TO RADIO
WHITE
22-PIN
(MALE)
GRAY
22-PIN
(MALE)
WHITE
22-PIN
(FEMALE)
GRAY
22-PIN
(FEMALE)
TO FACTORY
HARNESS
GROUND
WHITE Wire*
(Camera Power Output
+12V 250mA)
RED Wire
Tape O
(Not Used)
CUB-01 Camera
Included
*White wire does not supply Reverse Trigger on Manual Transmissions.
Camera power must be connected to factory reverse light wire instead.
Crux Interfacing Solutions • 6860 Canby Ave., Suite 104, Reseda, CA 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.010319
2 of 4
R
INTERFACING SOLUTIONS
Sightline
Multi View Integration
DIP SWITCH SETTINGS:
INSTALLATION INSTRUCTIONS:
INSTALLING THE BULLET CAMERA AND CABLE
The kit includes a universal bullet camera that can be mounted in dierent ways. On way is to mount
it on the third brake light. Please see page 3 for installaon instrucons. Once the camera has been
installed, route the camera cable towards the radio.
INSTALLING THE RVCCH-75EC MODULE
Remove the radio to gain access to the connectors. Unplug the factory WHITE and GRAY connectors and
plug them into the WHITE and GRAY connectors of the RVCCH-75EC T-harness. Mate the YELLOW male
and female video RCAs of the RVCCH-75EC T-harness and the camera cable. Use the thin RED wire on
the camera cable to power the camera. Connect the thin RED wire to the WHITE wire on the RVCCH-
75EC harness. The RED wire near the camera is not used and needs to be insulated with tape. Connect
the BLACK ground wire near the camera to chassis ground. See diagram on page 1. Test the system for
funconality before reinstalling the radio.
DIP SWITCH FUNCTIONS:
DIP 1 = Set to OFF
DIP 2 = Rear View Camera ON / OFF
DIP 3 = Set to OFF
DIP 4 = Set to OFF
DIP 5 = Varies - Defaulted to OFF*
DIP 6 = Varies - Defaulted to OFF*
RVCCH-75EC
Rear View Integration Interface
for CHRYSLER & DODGE Vehicles with 8.4” Screen
*DIP 5 & 6
If the radio is having turn-on issues, please try the following:
Aempt 1: Set 5 & 6 to ON
Aempt 2: Set 5 to ON and 6 to OFF
Aempt 3: Set 5 to OFF and 6 to ON
1 2 3 4 5 6
ON
Crux Interfacing Solutions • 6860 Canby Ave., Suite 104, Reseda, CA 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.010319
3 of 4
R
INTERFACING SOLUTIONS
Sightline
Multi View Integration
RVCCH-75EC
Rear View Integration Interface
for CHRYSLER & DODGE Vehicles with 8.4” Screen
1. Remove the third brake light assembly. Use the supplied
drill saw and drill a hole on the back side of the third brake
light housing.
2. Connue drilling unl the pilot drill bit is visible on the
front side of the third brake light.
3. Turn over the third brake light assembly start drilling from
the front side. Carefully drill thru the red plasc lens.
4. Insert the camera cable and the camera thru the hole
but DO NOT FULLY INSERT. This will allow you to rotate the
camera to the right posion. Turn the ignion key to ON but
do not start the engine. Put the gear in reverse and check
the camera view. Adjust as necessary.
6. The CUB-01 bullet camera has parking guide lines that
can be turned ON or OFF. The parking guide line is defaulted
to ON from the factory. To turn OFF the parking guide lines,
cut the thin WHITE wire on the camera cable around 4 feet
away from the camera. Insulate with tape. Unplug the 4-pin
barrel connector near the thin WHITE wire. Align the arrows
on the 4 pin barrel connector and plug them together.
Make sure that the connectors are plugged in all the way.
5. Route the camera cable towards the radio/RVCCH-75EC
locaon.
INSTALLING THE CAMERA:
Product specificaties
| Merk: | CRUX |
| Categorie: | Achteruitrijcamera |
| Model: | RVCCH-75EC |
Heb je hulp nodig?
Als je hulp nodig hebt met CRUX RVCCH-75EC stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Achteruitrijcamera CRUX
17 November 2024
17 November 2024
17 November 2024
17 November 2024
20 Juni 2023
18 Juni 2023
18 Juni 2023
16 Juni 2023
16 Juni 2023
14 Juni 2023
Handleiding Achteruitrijcamera
- Achteruitrijcamera AEG
- Achteruitrijcamera Garmin
- Achteruitrijcamera Kenwood
- Achteruitrijcamera Pioneer
- Achteruitrijcamera Alpine
- Achteruitrijcamera Dometic
- Achteruitrijcamera Elro
- Achteruitrijcamera Hikvision
- Achteruitrijcamera Luis
- Achteruitrijcamera Maginon
- Achteruitrijcamera Marquant
- Achteruitrijcamera Pro-User
- Achteruitrijcamera Pyle
- Achteruitrijcamera Trebs
- Achteruitrijcamera VDO Dayton
- Achteruitrijcamera Waeco
- Achteruitrijcamera Clarion
- Achteruitrijcamera Conrad
- Achteruitrijcamera Tracer
- Achteruitrijcamera Furrion
- Achteruitrijcamera Valueline
- Achteruitrijcamera Boyo
- Achteruitrijcamera Camos
- Achteruitrijcamera AutoXtreme
Nieuwste handleidingen voor Achteruitrijcamera
5 December 2024
25 November 2024
15 November 2024
6 September 2024
6 September 2024
6 September 2024
6 September 2024
8 Augustus 2024
6 Augustus 2024
4 Mei 2024