Cotech 36-4137 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Cotech 36-4137 (12 pagina's) in de categorie Verlichting. Deze handleiding was nuttig voor 36 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12
Important!
Read the entire instruction manual carefully
and make sure that you fully understand
it before you use the equipment. Keep the
manual for future reference.
Viktig information:
LĂ€s hela bruksanvisningen noggrant och
försÀkra dig om att du har förstÄtt den
innan du anvÀnder utrustningen. Spara
bruksanvisningen för framtida bruk.
Viktig informasjon:
Les disse anvisningene nĂžye og forsikre deg om
at du forstÄr dem, fÞr du tar produktet i bruk.
Ta vare pÄ anvisningene for seinere bruk.
TÀrkeÀÀ tietoa:
Lue nÀmÀ ohjeet huolellisesti ja varmista
ettÀ olet ymmÀrtÀnyt ne, ennen kuin alat
kÀyttÀÀ laitetta. SÀilytÀ ohjeet myöhempÀÀ
tarvetta varten.
Wichtiger Hinweis:
Vor Inbetriebnahme die komplette
Bedienungsanleitung durchlesen und
aufbewahren.
ENGLISHSVENSKANOR SKSUOMIDEUTSCH
Halogenbelysning
Halogeenivalaisin
Halogenbeleuchtung
Art.no
36-4137, 36-4138
Halogen
Floodlight
Ver. 20140307
Original instructions
Bruksanvisning i original
Original bruksanvisning
AlkuperÀinen kÀyttöohje
Original Bedienungsanleitung
2
ENGLISH
At least
20 cm
± 4 degrees At least 90 degrees At least 1 m
ABC
Halogen Floodlight
Art.no 36-4137, 36-4138
Please read theentire instruction manual before using and save it for future use. We apologise for
any text or photo errors and any changes of technical data. If you have any questions concerning
technical problems please contact our Customer Services (see address on reverse).
Theproduct is rated IP44 and is suitable for outdoor use. Installation should only be carried out
by aqualiïŹed electrician. Do not use amore powerful bulb than thelight ïŹtting is intended for.
Thelight should be connected to anearthed 230 V power point. For best results and your own
safety, we kindly ask you to follow these instructions carefully. Do not try to modify theproduct in
any way.
Positioning
When choosing aplace to mount thelight it is important to see that thelight is not more than
± 4° from thehorizontal lengthways (see ïŹg. A). Thelight must NOT be fastened to or pointed
towards aî˜ŸïŹ‚ammable surface. (see ïŹgs. B and C).
Installation
Installation should only be carried out by aqualiïŹed electrician.
Before beginning any electrical work, make sure that theelectric cables are not live by turning off
thepower and therespective fuse for thecircuit.
1. Use thewall bracket as atemplate for marking out thescrew holes. Use a8 mm drill bit and
drill to adepth of about 4 cm. Mount thewall bracket using suitable screws and wall plugs.
Attach thelight temporarily to thebracket. If you are working from below thelight, it might be
easier to attach thelight upside down whilst completing step 2 and 3, below.
2. Remove thecover plate from theconnection box on theback of thelight and feed in thepower
cable through thecable gland in thebottom of theconnection box. Pass thecable under
thecable clamp and connect thecable to theterminal block as follows:
3
ENGLISH
To the power supplyTo the light
(already connected)
(to the bulb holder)
(earth)
(to the bulb holder)
Blue (neutral)
Yellow / green (earth)
Brown (live phase)
N
L
White
Yellow/green
White
3. Tighten thecable clamp/strain relief and then thecable gland for awatertight seal. It might
be necessary to apply asealant to help stop moisture from getting into thelight ïŹtting.
REMARKS
If you have turned thelight upside down it is now time to turn it theright way up. Make sure
that thecable enters thelight ïŹtting from below. If necessary, make aU-bend in thecable
before it enters thelight ïŹtting.
4. Insert thelight bulb as follows: Undo thescrews on thetop of thelight and open thefront.
Insert thebulb in thespring-loaded bulb holder and make sure that thebulb makes agood
contact with theterminals. Do not touch any part of thebulb with your bare hands. If thebulb
should accidentally touch your hands it must be cleaned using methanol and alint-free cloth.
Close thelamp cover and tighten thescrews. Do not tighten thecover too much, theglass
might crack.
5. Adjusting thebeam angle: undo thenuts on theside, adjust thelight beam to thedesired
angle and tighten thenuts again.
6. Replace thefuse and turn thepower back on.
Warning: Do not touch thelight until it has cooled down.
Disposal
Follow local ordinances when disposing of this product.
If you are unsure about how to dispose of this product contact your municipality.
Specifications
220–240 V, 50 Hz
Max. 400 W linear halogen bulb, 118 mm R7S (suitable for 400 W ïŹ‚oodlight 36-4138)
Max. 120 W linear halogen bulb, 78 mm R7S (suitable for 120 W ïŹ‚oodlight 36-4137)


Product specificaties

Merk: Cotech
Categorie: Verlichting
Model: 36-4137

Heb je hulp nodig?

Als je hulp nodig hebt met Cotech 36-4137 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Verlichting Cotech

Handleiding Verlichting

Nieuwste handleidingen voor Verlichting