Coleman Sundome Handleiding

Coleman Tent Sundome

Lees hieronder de 📖 handleiding in het Nederlandse voor Coleman Sundome (4 pagina's) in de categorie Tent. Deze handleiding was nuttig voor 57 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/4

Connect Frame to Tent

– Insert one end of main tent pole

onto pin of pin & ring system at tent

corner. (illus. 3)

– Go to opposite end of pole and

gradually apply pressure to the pole

forming an arch until you are able to

insert the pin into the pole.

– Repeat for second pole. (illus. 4)

1Layout & Positioning

of Tent, Pole Assembly

– Layout and position tent with door

facing desired direction. (illus. 1)

– Unzip door.

– Stake down tent using the rings of the

pin & ring system at the corners of the

tent. Keep the floor taut. (illus. 2)

– Assemble frame poles by

interlocking shock-corded poles.

This will make two long poles.

– Insert the poles diagonally into pole

sleeves.The center of the poles should

cross forming an “X” in the middle of

tent. (illus. 1)

Assembled poles

inserted through

pole sleeves

illus. 1

illus. 4

Tent frame set-up

illus. 2

Tent stake through ring

illus.3

Insert pole end onto

pin & ring

SUNDOME®7’x7’

When You Are Ready To Set

Up Your Tent

– Select a level campsite clear of

rocks, branches and other hard

or sharp objects.

– Do not set up your tent under trees.

– For best results in windy conditions,

do not position the door of tent

into the wind.

Rainfly

Pole

Rainfly Part No.

9180-3041

Main Tent

Poles

POLE ASSEMBLY PARTS

Instructions apply to Part Number 2000001114

Part No. 9180-3061

Part No. 9180-3051

Stake down doormat

IMPORTED BY

SUNBEAM CORPORATION (CANADA) LIMITED

DBA JARDEN CONSUMER SOLUTIONS

20B Hereford Street, Brampton, Ontario L6Y 0M1

1-800-387-6161 • www.colemancanada.ca

MADE IN CHINA

PRINTED IN CHINA REV. 11/05

Things You Should Know

• Under certain conditions (cold weather, high humidity, etc.)

condensation will form on the inside surfaces of your tent. Condensation is

caused by water vapor from your breath, perspiration, or any wet clothing

inside your tent. It is NOT LEAKAGE through the tent fabric. It can be

minimized by removing wet clothing from your tent and by providing good

ventilation through the tent.

• Never store tent, even for a short period of time, without drying it

thoroughly and brushing off caked dirt. Do not pack stakes or poles inside

your tent. Use a separate storage bag.

• STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.

NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO

REMOVE STAKE.

• TENT POLES SHOULD NOT BE LEFT TELESCOPED

TOGETHER DURING STORAGE.

• Seam sealer has not been provided with your tent. For additional

protection we recommend seam sealing your tent prior to camping.

Seam sealer may be purchased through your local retailer or at your

local sporting goods store.

• Do not leave your tent set-up for weeks at a time, be aware that

exposure to the ultraviolet rays of the sun can seriously damage material

and/or cause it to become discolored.

WARNING: KEEP ALL FLAME AND HEAT SOURCES

AWAY FROM THIS TENT FABRIC. This tent meets the

flammability requirement s of CPAI-84. The fabric will burn if

left in continuous contact with any flame source. The

application of any foreign substance to the tent fabric may

render the flame -resistant properties ineffective.

Attach Tent to Frame

Using Frame Clips

– Attach frame clips along

the edges of tent to frame poles.

(illus. 5), (illus. 6)

– Make any adjustments to the tent

corner stakes that are needed.

4Attach Rainfly

– Assemble rainfly pole by

interlocking shock-corded pole.

– Insert rainfly pole into reinforced

pockets located at the center edges

of the underside of rainfly.

(illus. 7), (illus. 8)

– Attach underside of rainfly to the

rainfly pole. (illus. 8)

– Drape rainfly over tent frame, pole

side down. Rainfly pole should

point out over door and rear window.

– Connect the four elastic loops with

“S” hooks, (found at the rainfly

corners) to the fabric loops

near frame clips. (illus. 9)

– Secure rainfly with attachments

located on underside of fly. (illus. 10)

– Stake out the tent with (2) side

guylines. (illus. 10)

illus. 6

Assembled tent without rainfly.

illus. 5

Frame clips

illus. 7 Insert rainfly

pole into pocket on

underside of rainfly

illus. 10

Completed tent with rainfly.

illus. 8

Underside

of rainfly

attaches to

frame poles

Side guyline

Rainfly pole pockets

Rainfly pole pocket

Pole

attachments

illus. 9

“S” hooks

Fixez l’armature à la toile

– Introduisez un bout du mât de la tente

sur la cheville de l’ensemble cheville et

bague, au coin de la tente (ill. 3).

– Allez à l’autre bout du mât et arquez

progressivement le mât afin de pouvoir

insérer la cheville dans le mât.

– Agissez de la même façon avec l’autre

mât (ill. 4).

1Étalez et positionnez la

tente et les mâts

– Étalez et positionnez la tente en orientant

la porte dans la direction désirée (ill. 1).

– Ouvrez la glissière de la porte.

– Ancrez les coins de la tente à l’aide des

bagues des ensembles cheville et bague

se trouvant aux coins de la tente. Tendez

bien le tapis de sol (ill. 2).

– Emboîtez les mâts solidarisés de

l’armature pour les assembler. Vous

obtiendrez ainsi deux longs mâts.

– Enfilez les mâts diagonalement dans les

passants, afin qu’ils se croisent en leur

milieu, au centre de la tente (ill. 1).

Mâts assemblés, enfilés

dans les passants

ill. 1

ill. 4

Armature

de la tente montée

ill. 2

Piquet passé dans une bague

ill. 3

Insérez le bout

du mât sur la cheville

SUNDOME

2,1 x 2,1 m

Quand vous êtes prêt

à monter votre tente

– Choisissez un endroit propice:

de niveau et sans pierres, branches

ou matières dures et pointues

– Ne placez pas la tente sous les arbres

– Pour obtenir les meilleurs résultats s’il

y a du vent, mettez l’arrière au vent

Mât du

double toit

Double toit –

Pièce no9180-3041

Mâts de

la tente

PIÈCES VARIÉES

Instructions relatives au modèle 2000001114

Pièce no9180-3061

Pièce no9180-3051

Product specificaties

Merk:	Coleman
Categorie:	Tent
Model:	Sundome
Gewicht:	1900 g
Soort:	Strandtent
Afmetingen verpakking (BxDxH):	510 x 110 x 110 mm
Frame type:	Stevig frame
Bedoeld voor:	Strand
Opbergetui:	Ja
Frame materiaal:	Glasvezel
Merkspecifieke technologieën:	Coleman WeatherTec
Aantal slaapplaatsen:	2 persoon/personen
Waterdichtheid tentdoek:	500 mm
Brandvertragend canvas:	Ja
Buitenkant afwerkingsmateriaal:	Polyester