Coby CR-A50 Handleiding

Coby Radio CR-A50

Lees hieronder de 📖 handleiding in het Nederlandse voor Coby CR-A50 (3 pagina's) in de categorie Radio. Deze handleiding was nuttig voor 57 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/3

CR-A54

CR-A50

The lightning ﬂash with arrowhead symbol within an equilateral tri-

angle is intended to alert the user to the presence of uninsulated

“dangerous voltage” within the product’s enclosure that may be of

sufﬁcient magnitude to constitute a risk of electric shock.

The exclamation point within an equilateral triangle is intended to

alert the user to the presence of important operation and servicing

instructions in the literature accompanying the appliance.

For Customer Use:

Enter below the serial number that is located on the bottom of

the unit. Retain this information for future reference.

Model No. CR-A54 / CR-A50

Serial No.

For recycling or disposal information about this product,

please contact your local authorities or the Electronics In-

dustries Alliance: www.eiae.org.

WARNING:

To prevent ﬁre or shock hazard, do not expose this device to rain or moisture. Dangerous high

voltage is present inside the enclosure. Do not open the cabinet.

CAUTION: To prevent electric shock, match wide blade of plug to wide slot of outlet and fully

insert.

Protect your hearing: Hearing experts advise against the constant use of personal stereos

played at high volume. Constant exposure to high volumes can lead to hearing loss. If you should

experience ringing in the ears or hearing loss, discontinue use and seek medical advice.

Important Safety Instructions

PRECAUTIONS

FCC Statement:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation.

Note:

This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help

Use of shielded cable is required to comply with Class B limits in Subpart B of Part 15 of the FCC rules.

Do not make any changes or modifications to the equipment unless otherwise specified in the manual. If such changes or modifications should be made, you could be

required to stop operation of the equipment.

Read Instructions: All the safety and operating instructions should be read before the

product is operated.

Retain Instructions: The safety and operating instructions should be retained for future

reference.

Heed Warnings: All warnings on the product and in the operating instructions should

be adhered to.

Follow Instructions: All operating and usage instructions should be followed.

Cleaning: Unplug this product from the wall outlet before cleaning. Do not use liquid

cleaners or aerosol cleaners. Use a damp cloth for cleaning.

Attachments: Use only attachments recommended by the manufacturer. Use of other

attachments may be hazardous.

Water and Moisture: Do not use this product near water (e.g., near a bath tub, washbowl,

kitchen sink, laundry tub, in wet basements, or near a swimming pool and the like).

Accessories: Do not place this product on an unstable cart, stand, tripod, bracket, or

table. Use only with carts, stands, tripods, brackets, or tables recommended by the

manufacturer or sold with the product. Any mounting of the product should follow the

manufacturer’s instructions and should use a mounting accessory recommended by

the manufacturer.

A product and cart combination should be moved with care. Quick stops,

excessive force, and uneven surfaces may cause the product and cart

combination to overturn.

Ventilation: Slots and openings in the cabinet are provided for ventilation

to ensure reliable operation of the product and to protect it from overheat-

ing. These openings should never be blocked by placing the product on a bed, sofa,

rug, or other similar surface. This product should not be placed in a built-in installation

such as a bookcase or rack unless proper ventilation is provided or the manufacturer

instructions have been adhered to.

Power Sources: This product should be operated only from the type of power source

indicated on the rating label. If you are not sure of the type of power supply to your home,

consult your product dealer or local power company. For products intended to operate

from battery power or other sources, refer to the operating instructions.

Grounding or Polarization: This product may be equipped with a polarized alternating-

current line plug that has one blade wider than the other. This plug will only ﬁt into the

power outlet in one direction. This is a safety feature. If you are unable to insert the plug

fully into the outlet, try reversing the direction of the plug. If the plug should still fail to ﬁt,

contact an electrician to replace the obsolete outlet. Do not defeat the safety purpose

of the polarized plug.

Power-Cord Protection: Power supply cords should be routed so that they are not likely

to be walked on or pinched by items placed upon or against them, paying particular

attention to cords at plugs, convenience receptacles, and at the point which they exit

from the product.

10.

11.

12.

13.

Speciﬁcations and manual are subject to change without prior notice.

If you have a problem with this unit, please read the troubleshooting guide below and check our website at www.cobyusa.com for Frequently Asked

Questions (FAQs) and ﬁrmware updates. If these resources do not resolve the problem, please contact Technical Support.

The unit does not turn on.

Make sure the unit has been powered on manually.•

•

COBY Electronics Technical Support

56-65 Rust Street

Maspeth, NY 11378

Email: techsupport@cobyusa.com

Web: www.cobyusa.com

Phone: 800-727-3592 (8:00 AM–11:00 PM EST, seven days a week)

800-681-2629 (8:00 AM–5:30 PM EST, Monday to Friday)

718-416-3197 (8:00 AM–5:30 PM EST, Monday to Friday)

There is no sound.

Ensure that the volume of CR-A54/50 and or external device has been set to a

reasonable listening level.

•

Lightning: For added protection for this product, unplug it from the wall outlet and discon-

nect the antenna or cable system during a lightning storm or when it is left unattended

and unused for long periods of time. This will prevent damage to the product due to

lightning or power-line surges.

Power Lines: An outside antenna system should not be located in the vicinity of over-

head power lines or other electric light or power circuits, or where it can fall into such

power lines or circuits. When installing an outside antenna system, extreme care should

be taken to keep from touching such power lines or circuits, as contact with them might

be fatal.

Overloading: Do not overload wall outlets, extension cords, or integral convenience

receptacles as this can result in a risk of re or electric shock.ﬁ

14.

15.

16.

Object and Liquid Entry: Never push objects of any kind into this product through open-

ings as they may touch dangerous voltage points or shout-out parts that could result in

a ﬁre or electric shock. Never spill liquid of any kind on the product.

Servicing: Do not attempt to service this product yourself as opening or removing covers

may expose you to dangerous voltage or other hazards. Refer all servicing to qualiﬁ ed

service personnel.

Damage Requiring Service: Unplug this product from the wall outlet and refer servicing

to qualiﬁed service personnel under the following conditions: a) when the power-supply

or plug is damaged; b) if liquid has been spilled or if objects have fallen into the product;

c) if the product has been exposed to rain or water; d) if the product does not operate

normally by following the operating instructions. Adjust only those controls that are cov

ered by the operating instructions as improper adjustment of other controls may result

in damage and will often require extensive work by a qualiﬁed technician to restore the

product to its normal operation; e) if the product has been dropped or damaged in any

way; f) when the product exhibits a distinct change in performance—this indicates a

need for service.

Replacement Parts: When replacement parts are required, be sure that your service

technician has used replacement parts speciﬁed by the manufacturer or have the same

characteristics as the original part. Unauthorized substitutions may result in ﬁre, electric

shock, or other hazards.

Safety Check: Upon completion of any service or repairs to this product, ask the service

technician to perform safety checks to ensure that the product is in proper operating

condition.

Wall or Ceiling Mounting: The product should be mounted to a wall or ceiling only as

recommended by the manufacturer.

Heat: The product should be situated away from heat sources such as radiators, heat

registers, stoves, or other products (including ampliﬁers) that produce heat.

17.

18.

19.

20.

21.

22.

23.

Make sure the external device has been properly connected to CR-A54/50 by

audio cable.

Troubleshooting

Specifications

Power supply: CR-A54: 120V 60Hz or 220V 50Hz

CR-A50: 120V 60Hz

Back-up battery: DC 9 V

Frequencies: FM 88 - 108MHz

AM 530 - 1700KHz

Power consumption: 3W

Output power: 0.5W

Speaker: 8 ohm

Ensure that the power cord has been properly connected to the power outlet

and the power supply for CR-A54 is 120V 60Hz or 220V 50Hz and for CR-A50

is 120V 60Hz.

LOCATION OF CONTROLS and PARTS

LED Display

Frequency Display

1415

Function switch

Minute button ( M )

Hour button ( H )

Alarm button

Clock button

Sleep button

Tuning dial

AM / FM / AUX Switch

AUX IN jack

Volume dial ( Buzzer On )

Battery compartment

Ventilation Slots

Snooze button

Speaker

POWER SUPPLY

The CR-A54 operates from AC 120V 60Hz or 220V 50Hz household

mains supply.

The CR-A50 operates from AC 120V 60Hz household mains supply.

Before connecting to the power supply, ensure the rated voltage of this

unit matches your local voltage.

Warning: Disconnect the mains plug from the wall outlet when it is not in

use to avoid the risk of electric shock.

BATTERY BACK-UP

Install a 9V type 006P battery in the battery compartment for clock

backup (not for radio operation). The time will be preserved in the

case of a power failure. Replace the battery every 6 months for best

performance. Remove the battery if the unit will not be in use for a

long period of time.

SETTING THE CORRECT TIME

Hold the CLOCK button [8] and simultaneously press the HOUR button

[6] or MINUTE button [5] until the desired time is displayed.

RADIO OPERATION:

1. To turn the radio on, set the FUNCTION switch [4] to the “ON”

position.

2. To select the AM or FM radio band, set the AM/FM/AUX switch [11] to

the AM or FM position.

3. To tune to a radio station, turn the TUNING dial [10].

4. To adjust the volume level, turn the VOLUME dial [13].

5. To turn the radio off, set the FUNCTION switch [4] to the “OFF”

position.

ALARM TIMER (WAKE TO RADIO OR BUZZER)

1. To set the alarm timer: hold the ALARM button [7] and simultaneously

press the HOUR button [6] or MINUTE button [5] until the desired time is

displayed.

2. To wake to radio: Turn the radio on to tune to the desired radio station

and set the desired volume level.

To wake to buzzer: Turn the VOLUME dial [13] all the way down until it

clicks into the “BUZZER ON” position.

3. To activate the alarm timer, set the FUNCTION switch [4] to the

“AUTO” position. The ALARM INDICATOR will light up. When the alarm

timer reaches the set time, the radio or buzzer will activate to wake you

up.

4. To turn off the alarm timer, set the FUNCTION switch [4] to the “OFF”

position.

SNOOZE DELAYED ALARM

1. To delay the alarm timer (snooze), press the SNOOZE button [16]

when the alarm timer sounds. The alarm timer will sound again 9

minutes later.

2. To cancel the snooze operation and turn the alarm timer off

completely, set the FUNCTION switch [4] to the "OFF" position.

SLEEP OR SLEEP-AND-WAKE TO RADIO

1. Turn the radio on to tune to the desired radio station and set the

desired volume

level.

2. To Sleep to Radio: Set the FUNCTION switch [4] to the “OFF”

position.

To Sleep-and-Wake to Radio: Set the FUNCTION switch [4] to the

“AUTO”

position.

3. To activate the Sleep timer, press the SLEEP button [9]. The clock

will display

“0:59” to indicate the default sleep period. The radio will turn off

automatically

when the sleep period is over (59 minutes).

4. To increase the sleep period: Hold the SLEEP button [9] and

simultaneously press the HOUR button [6]. The sleep timer will

increase by one hour to “1:59” (1 hour and 59 minutes).

To reduce the sleep period: Hold the SLEEP button [9] and

simultaneously press the MINUTE button [5]. The sleep timer will

decrease by one minute.

5. To turn the radio off before the sleep timer is over, press the

SNOOZE button [16].

AUXILIARY AUDIO INPUT FROM EXTERNAL DEVICE

1. Set the AM/FM/AUX switch [11] to the "AUX" position.

2. Set the FUNCTION switch [4] to the "ON" position.

3. Use a 3.5mm male to male audio cable to connect the Headphone /

Audio Out jack of the external device to the AUX IN jack [12] of the

CRA-54/50.

4. Adjust the volume to a comfortable listening level and start playback

on the external device. You may also use the VOLUME dial [13] of the

CRA-54/50 to adjust the volume level.

907-CRA5-4S01-00

Product specificaties

Merk:	Coby
Categorie:	Radio
Model:	CR-A50
Kleur van het product:	Zwart
Ingebouwd display:	Ja
Geïntegreerde klok:	Ja
Type aansluitplug:	3,5 mm
Waarschuwingssignaal:	Ja
Snooze functie:	Ja
Ingebouwde luidsprekers:	Ja
Gemiddeld vermogen:	- W
Hoofdtelefoonuitgangen:	1
Certificering:	CE, FCC
Soort tuner:	Digitaal
Ingangsspanning:	110 V
Wekker:	Ja
MP3 afspelen:	Nee
Ondersteunde frequentiebanden:	AM, FM
Radio:	Klok
Apple docking-compatibiliteit:	Niet ondersteund
PLL-synthesizer:	Nee
Slaaptimer:	Ja
Type beeldscherm:	LED