Chief SLB275 Handleiding

Chief Flat panel steun SLB275

Lees hieronder de 📖 handleiding in het Nederlandse voor Chief SLB275 (1 pagina's) in de categorie Flat panel steun. Deze handleiding was nuttig voor 15 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/1
I N S T A L L A T I O N I N S T R U C T I O N S
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8802-002072 Rev00
©2010 Milestone AV Technologies,
a Duchossois Group Company
11/10
SSB-275, SSM-275, SLB-275 and SLM-275 Interface Brackets
SSB-275, SSM-275, SLB-275 and SLM-275 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation Instructions
WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface brackets.
NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place the interface bracket onto the bottom of the projector, aligning the mounting holes in the bracket with the threaded inserts in the
bottom of the projector and ensuring that triangle in bracket points towards front of projector.
4. Position M6 x 10mm mounting screws with M6 flat washers into the threaded inserts and three bracket side tabs. Position 1/2" tall spacer
underneath threaded insert and mounting hole at front of interface bracket. Place the M6 x 20mm screw into the threaded insert and
mounting hole at front of interface bracket and through 1/2" spacer. Tighten all fasteners at this time, securing the bracket to the projector.
NOTE: Security screws can be substituted when mounting Interface bracket to projector by using the parts and installation
instructions in the All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket (3) Screw, Phillips Pan Head, Machine, M6 x 10mm
(4) 10-24 Thumb Nuts ** (1) Screw, Phillips Flat Head, Machine, M6 x 20mm
(3) Washer, M6
(1) All-Points Security Kit (1) 5/32" Hex Key
**Only used when installing SLB/SSB interface brackets.
NOTE: Specific to SSB-style and SSM-style interface bracket installation: All appropriate screws come pre-installed in the circled locations above.
DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style interface bracket installation.
Note: SSB-style interface bracket connections are circled. Note: SSM-style interface bracket connections are circled.
SLB-275 SLM-275
Towards front
of projector
Towards front
of projector
(1) Nylon Spacer, 1/2" x .316" x 1/2"

Product specificaties

Merk: Chief
Categorie: Flat panel steun
Model: SLB275

Heb je hulp nodig?

Als je hulp nodig hebt met Chief SLB275 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Flat panel steun Chief

Chief

Chief TS218SU Handleiding

9 December 2024
Chief

Chief K1D120BXDL Handleiding

17 November 2024
Chief

Chief RPMA204 Handleiding

17 November 2024
Chief

Chief LCB1U Handleiding

17 November 2024
Chief

Chief RPA640 Handleiding

17 November 2024
Chief

Chief FSBI2TB Handleiding

17 November 2024
Chief

Chief XCB1U Handleiding

17 November 2024
Chief

Chief RSA213 Handleiding

17 November 2024
Chief

Chief RSMBU Handleiding

17 November 2024
Chief

Chief PFQUB Handleiding

27 Juni 2024

Handleiding Flat panel steun

Nieuwste handleidingen voor Flat panel steun

Rocstor

Rocstor Y10N027-B1 Handleiding

10 December 2024
Gabor

Gabor TM-UL Handleiding

10 December 2024
Gabor

Gabor FPS-L Handleiding

10 December 2024
Gabor

Gabor FPC-85 Handleiding

10 December 2024
CTA Digital

CTA Digital ADD-AVPMB Handleiding

10 December 2024
StarTech.com

StarTech.com ARMQUADSS Handleiding

9 December 2024
Gabor

Gabor FSM-L Handleiding

9 December 2024
Kanto

Kanto FMX2 Handleiding

8 December 2024
SunBriteTV

SunBriteTV SB-WM-F-XL-BL Handleiding

7 December 2024
Atdec

Atdec AD-WFP-5040 Handleiding

7 December 2024