Chief RPMA024 Handleiding

Chief Flat panel steun RPMA024

Lees hieronder de 📖 handleiding in het Nederlandse voor Chief RPMA024 (1 pagina's) in de categorie Flat panel steun. Deze handleiding was nuttig voor 25 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/1

I N S T A L L A T I O N I N S T R U C T I O N S

• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918

8850-000021

06/06

Installation:

WARNING: OVERTIGHTENING OF SCREWS CAN DAMAGE PARTS AND LEAD TO SERIOUS PERSONAL INJURY AND DAMAGE

TO EQUIPMENT! DO NOT over tighten screws when installing Interface bracket.

NOTE: Step 1 is only required when installing an SLB Interface bracket. If an SLM bracket is being installed proceed to step 2.

1. Screw four thumb screws onto four 10-24 x 5/8" Philips pan head screws. DO NOT fully tighten thumb screws at this time.

2. Turn projector upside down.

3. Place the four 1/2" spacers on the bottom of the projector over the four threaded mounting inserts.

4. Place the interface bracket onto the four spacers on the bottom of the projector, lining up the four threaded inserts in the bottom of the

projector with the four mounting holes in the bracket.

5. Using the four M4 x 20mm mounting screws and washers, start them into the mounting holes by hand and secure all four fasteners at this

time.

NOTE: Security screws can be substituted when mounting Interface bracket to projector by using the parts and installation instructions in the

All-Points Security Kit.

CSAV, Inc., and its affiliated corporations and subsidiaries (collectively, "CSAV"), intend to make this manual accurate and complete. However, CSAV makes

no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with

the installation or use of this product. The information contained in this document is subject to change without notice or obligation of any kind. CSAV makes no

representation of warranty, expressed or implied, regarding the information contained herein. CSAV assumes no responsibility for accuracy, completeness or

sufficiency of the information contained in this document.

SLB-024 and SLM-024 Interface Brackets