Chief RPA293 Handleiding

Chief Flat panel steun RPA293

Lees hieronder de 📖 handleiding in het Nederlandse voor Chief RPA293 (8 pagina's) in de categorie Flat panel steun. Deze handleiding was nuttig voor 14 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/8

I N S T A L L A T I O N I N S T R U C T I O N S

Projector Mount

Spanish Product Description

German Product Description

Portuguese Product Description

Italian Product Description

Dutch Product Description

French Product Description

RPA Series

RPA Series Installation Instructions

DISCLAIMER

Milestone AV Technologies and its affiliated corporations and

subsidiaries (collectively "Milestone"), intend to make this

manual accurate and complete. However, Milestone makes no

claim that the information contained herein covers all details,

conditions or variations, nor does it provide for every possible

contingency in connection with the installation or use of this

product. The information contained in this document is subject

to change without notice or obligation of any kind. Milestone

makes no representation of warranty, expressed or implied,

regarding the information contained herein. Milestone assumes

no responsibility for accuracy, completeness or sufficiency of

the information contained in this document.

Chief® is a registered trademark of Milestone AV Technologies.

IMPORTANT SAFETY INSTRUCTIONS

WARNING: A WARNING alerts you to the possibility of

serious injury or death if you do not follow the instructions.

CAUTION: A CAUTION alerts you to the possibility of

damage or destruction of equipment if you do not follow the

corresponding instructions.

WARNING: Failure to read, thoroughly understand, and

follow all instructions can result in serious personal injury,

damage to equipment, or voiding of factory warranty! It is the

installer’s responsibility to make sure all components are

properly assembled and installed using the instructions

provided.

WARNING: Failure to provide adequate structural strength

for this component can result in serious personal injury or

damage to equipment! It is the installer’s responsibility to

make sure the structure to which this component is attached

can support five times the combined weight of all equipment.

Reinforce the structure as required before installing the

component.

WARNING: Exceeding the weight capacity can result in

serious personal injury or damage to equipment! It is the

installer’s responsibility to make sure the combined weight of

all components attached to the RPA does not exceed 50 lbs

(22.7 kg).

• The weight capacity of the RPA may be LIMITED to the

lowest weight capacity of any other components

located between the RPA and the supporting structure!

WARNING: Use this mounting system only for its intended

use as described in these instructions. Do not use

attachments not recommended by the manufacturer.

WARNING: Never operate this mounting system if it is

damaged. Return the mounting system to a service center for

examination and repair.

WARNING: Do not use this product outdoors.

IMPORTANT ! : The RPA mounts are designed to be:

• mounted to a 1-1/2" NPT or NPSM following ANSI/

ASME B1.20.1 (Schedule 40, 0.154" minimum

thickness steel or aluminum - ASTM B221) threaded

extension column (not included); or

• mounted to a double 2" x 4" wood joist with a maximum

drywall covering of 5/8"; or

• suspended from four 1/4-20 Grade ASTM A307 or

better threaded rods (not included) which are secured

to unistrut by 1/4-20 Grade 2 or better channel nuts (not

included), or to angle or channel assembly overhead

structural members (trusses or I-beams) by 1/4-20

Grade 2 or better jam nuts (not included).

NOTE: RPA Series may be used with Listed Chief models

WM110S, WM120S, WM130S, WM210S, WM220S,

WM230S, WM240S, WM210SI, WM220SI, WM230SI,

WM240SI, CMA151, and LSB100 (not included).

--SAVE THESE INSTRUCTIONS--

DIMENSIONS

5.02

4.38

1.75

1 ½" NPT

5.50

3.25

4.50

5.50

3.75

BOLT CIRCLE

2.25

2.75

3.50

1.25

.75

ACCESS HOLE

STUDS ON SLB CENTER

IN THESE SLOTS

2.77

3.10

NOTE: CUSTOM INTERFACE BRACKET

NOT SHOWN. THE CUSTOM INTERFACE

BRACKET NEEDED FOR YOUR PROJECTOR

WILL ADD DEPTH TO INTALLATION AND

WILL AFFECT LOCATION OF PROJECTOR

ON MOUNT.

SEE SLB-XXXX DRAWING ALSO.

DIMENSIONS: INCHES

Installation Instructions RPA Series

LEGEND

TOOLS REQUIRED FOR INSTALLATION / PARTS

Tighten Fastener

Apretar elemento de fijación

Befestigungsteil festziehen

Apertar fixador

Serrare il fissaggio

Bevestiging vastdraaien

Serrez les fixations

Loosen Fastener

Aflojar elemento de fijación

Befestigungsteil lösen

Desapertar fixador

Allentare il fissaggio

Bevestiging losdraaien

Desserrez les fixations

Phillips Screwdriver

Destornillador Phillips

Kreuzschlitzschraubendreher

Chave de fendas Phillips

Cacciavite a stella

Kruiskopschroevendraaier

Tournevis à pointe cruciforme

Open-Ended Wrench

Llave de boca

Gabelschlüssel

Chave de bocas

Chiave a punte aperte

Steeksleutel

Clé à fourche

Adjust

Ajustar

Einstellen

Ajustar

Regolare

Afstellen

Ajuster

Security Wrench

Llave de seguridad

Sicherheitsschlüssel

Chave de segurança

Chiave di sicurezza

Veiligheidssleutel

Clé de sécurité

Hex-Head Wrench

Llave de cabeza hexagonal

Sechskantschlüssel

Chave de cabeça sextavada

Chiave esagonale

Zeskantsleutel

Clé à tête hexagonale

Socket Wrench

Clé à douilles

Steckschlüssel

Chave de caixa

Chiave a brugola

Dopsleutel

Clé à douilles

A (1)

[RPA]

7/16"

1/8" (wood)

7/16"

B (1)

[Example of SLB bracket]

Hardware required - not included

(dependent on installation method)

1. Install to threaded extension column

• 1-1/2" NPT or NPSM following ANSI/ASME

B1.20.1 (Schedule 40, 0.154" minimum

thickness steel or aluminum - ASTM B221)

threaded extension column (not included)

2. Install to wood ceiling joists (Qty. of 4 each)

• 1/4" x 2" (minimum length) Grade 2 lag bolts

•1/4" Grade 2 nuts

• 1/4" Grade 2 washers

3. Install to threaded rod

• 1/4-20 steel threaded rods (Qty. 4)

• 1/4-20 Grade 2 channel nuts (Qty. 4)

• 1/4-20 Grade 2 jam nuts (Qty. 8)

• 1/4" Grade 2 washers (Qty. 8)

5/32"

Product specificaties

Merk:	Chief
Categorie:	Flat panel steun
Model:	RPA293
Kleur van het product:	Zwart
Gewicht verpakking:	2000 g
Montagewijze:	Plafond
Maximale gewichtscapaciteit:	- kg