Chief PRO2000B Handleiding

Chief Flat panel steun PRO2000B

Lees hieronder de 📖 handleiding in het Nederlandse voor Chief PRO2000B (6 pagina's) in de categorie Flat panel steun. Deze handleiding was nuttig voor 41 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/6

I N S T A L L A T I O N I N S T R U C T I O N S

Large Flat Panel Wall Mount

Model: PRO-2000 Series

PRO-2000 Series Wall Mount Features:

• Accommodates large flat screens weighing up to

200 lbs (90.7 kg).

• Mounting brackets adapt to either 16" or 24" on

center dual stud wood framework; integrated

lateral shift adjusts ± 4.5" (16" on center) or ± 0.5"

(24" on center).

• Infinite tilt and lock adjustment between 0-15

degrees.

• Chief's exclusive Q-Latch mounting system

provides convenient and secure display connect/

disconnect; optional padlock provides additional

display security.

Q-Latch® is a registered trademark of Chief Mfg.

! IMPORTANT: If the installation of this product requires

OSHPD seismic approval, refer to OSHPD pre-approval

documents and drawings before beginning installation.

OSHPD documents and drawings are available at

www.chiefmfg.com, and are also located on the product

information page for the mount. PRO-2000 Series

BEFORE YOU BEGIN

CAUTION: To prevent damage to your monitor and PRO-2000, which could affect or void the Factory warranty,

thoroughly study all instructions and illustrations before you begin to install the mount. Pay particular attention to the

Warnings and Cautions in this document.

• The mount is designed to be installed using wall studs or supporting framework. The fasteners used to anchor

the mount must be capable of supporting five times the total weight of the equipment.

• The maximum weight to be installed on the PRO-2000 wall mount is 200 lbs (90.7 kg).

• If you have any questions about this installation, contact Chief Manufacturing at 1-800-582-6480 or 952-582-

6480.

CHIEF MANUFACTURING INC.

1-800-582-6480 952-894-6280 FAX 952-894-6918

8401 EAGLE CREEK PARKWAY, STE 700

SAVAGE, MINNESOTA 55378 USA

8805-000140 (Rev. E)

2007 Chief Manufacturing

www.chiefmfg.com

10/07

Installation Instructions

IMPORTANT WARNINGS AND CAUTIONS!

WARNING: A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions.

CAUTION: A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not follow the

corresponding instructions.

WARNING: It is the installer’s responsibility to make sure structure to which this mount is attached can support five

times the combined weight of all equipment. Reinforce the structure as required before installing the accessory.

Failure to provide adequate structural strength for the mount can result in serious personal injury or damage to

equipment!

WARNING: It is the installer’s responsibility to make sure all components are properly assembled and installed using

instructions provided. Failure to follow instructions can result in serious personal injury or damage to equipment!

WARNING: It is the installer’s responsibility to make sure combined weight of mount, display, and all attached

equipment must not exceed 200 lbs (90.7 kg), the maximum support weight of this mount. Exceeding maximum

support weight can result in serious personal injury or damage to equipment!

WARNING: Watch for pinch points. Do not put your fingers between movable parts.

WARNING: Make sure the Q-Latches securing the display are fully latched at all times except when removing or

installing the display. The Q-Latches must be fully latched when installing/removing cables.

CAUTION: Check the unit for shipping damage before you begin the installation.

DIMENSIONAL DRAWING

Installation Instructions

TOOLS REQUIRED FOR INSTALLATION

• Drill and drill bit set

• Socket wrench set

NOTE: Other tools may be required depending on your method of installation.

PARTS

Unpack carton, inspect and verify contents.

Read installation instructions completely. If any listed

parts are missing, contact Chief Customer Service at

1-800-582-6480.

Table 1: Parts

10 MOUNT, PRO-2000 Series 1

20 BOLT, Lag, 5/16" x 2-½" 4

30 WASHER, 5/16" 4

20 - 4 Lag Bolts

30 - 4 Washers

Product specificaties

Merk:	Chief
Categorie:	Flat panel steun
Model:	PRO2000B
Kleur van het product:	Zwart
Breedte:	660 mm
Diepte:	39 mm
Hoogte:	467 mm
Materiaal behuizing:	Metaal
Montagewijze:	Muur
Geschikt voor schermmaten:	42 - 71 "
Maximale gewichtscapaciteit:	90.7 kg
Certificering:	UL
Bereik kantelhoek:	0 - 15 °
Maximale schermgrootte:	71 "
Minimale schermgrootte:	42 "