Certina DS Caimano Handleiding

Certina Horloge DS Caimano

Lees hieronder de 📖 handleiding in het Nederlandse voor Certina DS Caimano (3 pagina's) in de categorie Horloge. Deze handleiding was nuttig voor 41 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/3

W W W. CE R TI N A. CO M 356_EN / 09.15

1/3

Analogue Quartz

Watches

User’s Manual

Display and functions

Seconds hand

Minute hand

Hour hand

Date*

Day*

* According to model

Models with a screwed crown:

IA Initial position (screwed down, not pulled out)

IB Winding position (unscrewed, not pulled out)

Analogue Quartz Watches

W W W. CE R TI N A. CO M 356_EN / 09.15

2/3

Congratulations

We congratulate you on choosing a CERTINA® watch. Meticulously

designed, using only high-quality materials and components, your watch

is protected against shocks and impacts, variations in temperature, water

and dust and also benefits from the concept.DS

To ensure the operating precision of your watch for many years to come,

we advise you to pay very careful attention to the advice provided

hereafter.

This user’s manual applies to all CERTINA® quartz, quartz solar

or autoquartz watches. Please refer to the explanations relating

specifically to your watch model.

The DS (Double Security) concept is characterised by:

– its scratch and impact resistance,

– its tough sapphire crystal,

– a gasket inside the crown and a gasket around the winding stem guar-

anteeing the water resistance of the watch even when the crown is

pulled out,

– a reinforced case back.

Recharging the accumulator

Models with screwed crown

To ensure even better water resistance, certain models are fitted with

a screwed crown. Before setting the time, date* or day*, you must first

unscrew the crown into position before you can pull it out to position IB II

or .III

Important: After every operation, the crown must be screwed back in to

maintain the water-resistance of the watch.

Quartz watches

Quartz watches are battery powered, and cannot be recharged.

Autoquartz watches

To wind an Autoquartz watch, turn the crown through a few dozen

(~50) revolutions in position (or IB for models with screwed crown). I

The automatic winding system will then ensure that the watch is fully

wound by means of your wrist movements alone. The watch needs to be

worn for several weeks to reach maximum charge, and thereby achieve

its theoretical power reserve of 100 days.

Quartz solar watches

These watches do not have a winding crown. To recharge the accumulator,

expose the dial of your watch either to the sun or to artificial light.

Settings

NB: Please take account of the information above if your watch is

fitted with a screwed crown.

Setting the time

Pull the crown out to position and turn it in either direction until the III

desired time is displayed.

On certain models with a seconds hand, you can synchronize it with an

official time signal (radio/TV/Internet). When the crown is pulled out to

position III, the seconds hand is stopped. Once the time is synchronised,

push the crown back into position (and screw it back in on models with I

a screwed crown).

Rapid correction of the date* and day*

NB: Do not perform a rapid date correction between 22:00 and

02:00.

Pull the crown out to position and turn it clockwise until the desired date II

is displayed, or counterclockwise to correct the day. During this operation,

your watch will keep operating, so you will not need to adjust the time.

Technical information

CERTINA

quartz watches

Boasting the precision of quartz, they generally have a power reserve

of more than 2 years in continuous use, though this varies slightly

depending on the habits of the wearer and the ambient temperature.

Similarly, the ambient temperature may affect the accuracy of quartz

movements, causing variations of around -0.5 to +0.7 seconds per day.

All you have to do is to set the time, and possibly the date if your watch

is equipped with a display of this kind (see the “Settings” section).

EOL Function – (End of Life)

The battery end of life is indicated by the seconds hand making 4-second

jumps. The watch will keep operating for a few more days, but the battery

should be removed and replaced by an approved CERTINA® service centre

as soon as possible.

CERTINA

Autoquartz watches

As accurate as a quartz watch yet operating without a battery, these

watches are equipped with an accumulator which automatically recharges

its energy by means your wrist movements. The oscillation movements of

your wrist turn an oscillating weight, each rotation of which activates

a micro-generator which in turn charges an accumulator with electrical

energy.

Power supply

The lithium accumulator has an average service life of more than

10 years. Never replace it with a conventional silver oxide battery, since

this would irrevocably destroy the movement.

EOE Function – (End of Energy)

Your CERTINA® Autoquartz watch is equipped with an EOE (End of Energy)

energy requirement indicator. If you observe the seconds hand jump

every 4 seconds, it means that your watch needs to be wound (see the

“Winding” section).

Water-resistance

CERTINA® watches are designed to withstand a pressure of up to 3

bar (30 m / 100 ft), 5 bar (50 m / 165 ft), 10 bar (100 m / 330 ft), 20 bar

(200 m / 660 ft) or 30 bar (300 m / 1000 ft), depending on the information

shown on the case-back.

A watch cannot be permanently guaranteed absolutely water-resistant.

It may be affected by ageing of the gaskets or by an accidental impact on

the watch. We recommend that you have your watch’s water resistance

checked once a year by an approved CERTINA® service centre.

Care and maintenance

Temperature

Do not expose your watch to sudden temperature changes (exposure to

sunlight followed by immersion in cold water) or extreme temperatures

(over 60°C (140°F) or below 0°C (32°F).

Magnetic fields

Do not expose your watch to intense magnetic fields such as those

generated by loudspeakers, mobile phones, computers, refrigerators or

other electromagnetic appliances.

Shocks and impacts

Avoid thermal shocks or impacts, since they may harm your watch.

In the event of a violent impact please have your watch checked by an

approved CERTINA® service centre.

Analogue Quartz Watches

W W W. CE R TI N A. CO M 35 6_E N / 0 9 . 15

3/3

Harmful products

Prevent your watch from coming into any direct contact with solvents,

detergents, perfumes, cosmetic products etc., since they may damage

the bracelet, the case or the gaskets.

Cleaning

We would advise you to clean your watch regularly (except for

the leather strap) using a soft cloth and lukewarm soapy water.

After immersion in salty water, rinse your watch in fresh water and

leave it to dry completely.

Quartz or Autoquartz watches

If you are considering not wearing your watch for a few weeks or months,

we would advise you to pull the crown out to the last stop before storing it.

This will reduce energy consumption.

Services

Like any precision instrument, a watch must be serviced regularly for

optimum operation. As a general rule, we recommend that you have

your watch checked every 3 to 4 years by your approved CERTINA®

retailer or service centre. However, please note that depending on the

climate and the conditions of use of the watch, a shorter interval may

be required. To enjoy meticulous standards of service and to ensure

your guarantee remains in force, please always contact an approved

CERTINA® retailer or service centre.

Availability of spare parts

From the stoppage date of the watch production, CERTINA® guarantees

the availability of its spare parts for a minimum period of 10 years for

standard watches, and for a period of up to 20 years for gold watches.

If for any reason production of a particular spare part is stopped or

deferred, CERTINA® reserves the right, at its sole discretion, to offer the

customer an alternative solution.

Collection and treatment of end of life quartz watches*

This symbol indicates that this product should not be disposed

of as household waste. It must be returned to an approved

collection point. By following this procedure you will contribute to

safeguarding the environment and human health. Recycling the materials

will help to conserve natural resources.

Battery type: silver oxide and zinc button cell.

Autoquartz: manganese dioxide and lithium button cell.

* Valid in European Community member states and in any countries with

comparable legislation.

Product specificaties

Merk:	Certina
Categorie:	Horloge
Model:	DS Caimano
Type horloge:	Horloge
Mechanismetype:	Quartz
Chronograaf:	Nee
Type wijzerplaat horloge:	Analoge wijzerplaat
Waterdicht:	Ja
Waterbestendig diepte:	100 m
Horlogekast materiaal:	Staal
Kleur behuizing:	Zilver
Band materiaal:	Leer
Hoofdkleur van band:	Zwart
Glas type van horloge:	Saffier
Hoesvorm:	Rond
Krasbestendig glas:	Ja
Hoofdkleur van wijzerplaat:	Zilver
Geslacht:	Man
Stijl becijfering horloge:	Arabische cijfers/geen cijfers
Kleur becijfering horloge:	Zwart
Aantal wijzers:	3
Kastdiameter:	38 mm
Productontwerp:	Casual