Bushman DC285L-X Handleiding

Bushman Koelkast DC285L-X

Lees hieronder de 📖 handleiding in het Nederlandse voor Bushman DC285L-X (8 pagina's) in de categorie Koelkast. Deze handleiding was nuttig voor 4 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
User Manual &
Operating Instructions
DC-L Series
CARAVAN RV – – MARINE - OFFGRID
Congratulations on Bushman DCyour purchase of a -L fridge. these instructions carefully Please read
before installation use. and
Please be safe and use common sense and caution when installing, operating and cleaning this appliance. If
you are unsure about any of these instructions, contact your local dealer before proceeding.
IMPORTANT INFORMATION
Do not lay your fridge on its back, top If your fridge has been or sides or at any angle exceeding 30º.
incorrectly handled, ensure that the fridge is placed in a level upright position for 12 hours to allow the internal
fluids to redistribute evenly.
Never operate your fridge directly from a 240 V or AC power . supply
Do not use a modified sine wave inverter to operate your fridge.
PRIOR TO INSTALLATION
DELIVERY
At delivery, please check that the fridge is complete and is not damaged in any way. Remove all packaging
and securing tapes from the fridge. To avoid injury and causing damage to the appliance, be extremely
cautious when using sharp or pointed tools to complete this task.
Do not connect an appliance that has been damaged, contact your local stockist immediately.
INSTALLATION
Installation of the DC-L range of fridges must be completed by a suitably trained professional only.
POWER SUPPLY
Your fridge V V must be connected to a stable and regulated 12 or 24 DC power supply only. The compressor
will automatically detect which voltage is present adjust accordingly.
If you are using a generator or other power supply, the output must be a pure sine wave. Any fluctuations in
generator current may damage the compressor.
WIRING
For optimum results, you will need the correct sized wire depending on the distance from your power supply
to the fridge. Wiring must be to your directly from your fridge battery and should be continuous without joins.
Please also ensure the earth is wired directly to your battery, not to a chasse. If your sufficientwiring is in , your
fridge may not perform correctly or may be even be damaged.
CROSS
SECTION
IN MM2
MAXIMUM LENGTH OF WIRE IN
METRES
12 V
24 V
2.5
2.5
5
4
4
8
6
6
12
10
10
20
Any switches must have a breaking load not less than 20 A on 12 V or 10 A on 24 volts.
Ensure the wiring polarity is correct. Connect the red wire to the positive terminal (+) and the black wire to the
negative terminal (- ).
Never connect bare electric wires. Use only connections of a size suitable for the cross section of the wire
being used.
INSTALLATION IN A CAVITY WITH THE MOUNTING KIT
DC-L fridges are designed to be installed in a . We recommend allowing a cavity minimum mm gap 5 in width
and height e of gap of 50 for eas installation. A minimum mm is recommended for the rear. Refer to the
following table for the recommended -cut out dimensions.
MODEL
CUT- OUT CAVITY DIMENSIONS (MM)
WIDTH
DEPTH
HEIGHT
DC190-L
6 05
575
1385
DC285-L
6 05
675
1555
VENTILATION
Two vents need to be provided from the rear of the fridge cavity to the outside environment, or to the general
area where the fridge is located. The vents should be located at the bottom and top of the fridge cavity and
have a 300free t cross section of at leas cm2 each. This allows for natural thermal air flows across the
condenser. As a general rule, the more ventilation you can provide, the better.
MOUNTING KIT
The mounting kit is first affixed to the side and top of the fridge cabinet using the screws provided.
Once the fridge has been connected to the power supply and moved into its final position, the mounting kit
can be affixed to the front of the cavity.
OPERATING THE FRIDGE
THERMOSTAT
• Turn the thermostat knob around from 0 to power up the fridge.
• The cooling level can be set between 1 and 7.
• 7 is the coldest setting and 1 is the warmest.
EQUALISING THE FRIDGE
During the first 24 hours of operation, your compressor will operate for longer than usual. This process allows
the internal air temperature, food, drinks, condenser and insulation to equalise.
ENERGY SAVING TIPS
• Have a much venti the more the better.lation as possible –
• Keep the fridge out of direct sunlight whenever possible
• Only open the fridge or freezer door when necessary
• Allow hot food to cool down before placing inside the fridge
• Defrost the fridge as soon as a layer of ice forms
• Set the fridge to be only as cold as necessary
CLEANING
Wash the inside of your fridge with luke warm water and a mild soap. Never use abrasive or corrosive
cleaning agents, steel wool or scouring sponges. A soft sponge, towel, or soft brush is recommended.
Always keep the inside of the fridge clean and dry. Remove any condensate water or ice which gathers in or
near the tray under the freezer compartment.
Be careful when opening or closing the freezer door if ice has been allowed to accumulate in this area.
Keep the doors of the fridge ajar when the fridge is not in use, to allow fresh air to circulate inside the fridge
compartment.


Product specificaties

Merk: Bushman
Categorie: Koelkast
Model: DC285L-X

Heb je hulp nodig?

Als je hulp nodig hebt met Bushman DC285L-X stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Koelkast Bushman

Handleiding Koelkast

Nieuwste handleidingen voor Koelkast