Brula D plus - tief - deep Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor Brula D plus - tief - deep (19 pagina's) in de categorie Haarden. Deze handleiding was nuttig voor 55 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/19
2
General
Introduction
You have opted for a BRULA basic stove firebox. We would like to congratulate you
on your choice and thank you for showing confidence in our product.
With this product you are getting premium quality basic stove technology for a
healthy radiant heat and stylish heating.
We hope you enjoy using our "fiery" products.
These assembly and operating instructions serve to familiarise you with the
assembly and correct handling of this fireplace in order to ensure smooth operation.
Please take the time to read these assembly and operating instructions carefully.
Our warranty and guarantee only apply if all points for the correct assembly and
operation of the fireplace are observed as described below.
Keep the assembly and installation instructions in a safe place so you can refer to
how to operate the fireplace correctly time and time again (e.g., at the start of a new
heating period).
The basic stove principle
The basic stove (also known as a storage stove) is synonymous with long-lasting
and healthy heating. And these are precisely the advantages offered by this stove
system. Compared to a hot air system which uses the principle of convection and
essentially only heats up the air, a basic stove emits warmth into the room slowly
and evenly in the form of healthy radiant heat, something which is valued in
particular by allergy sufferers.
And this is how it works:
Once the fire has been lit in the combustion chamber, the heating gases are drawn
through a draught system made of firebricks which absorb and store the heat. The
draught system is designed so that the heating gases must firstly pass through the
entire stove before escaping through the chimney. This means that the generated
heat is emitted by the stove over a long period of time. The radiant heat created in
this way does not heat up the air but rather the objects which it encounters, just like
a ray of sun.
BRULA GmbH
Weidacher Str. 17
87471 Durach/Allgäu, Germany
Tel. +49(0)831-564070
Fax +49(0)831-56407-50
info@brula.de
3
Operating instructions
General requirements
Please note that national and local provisions must be satisfied when installing the
BRULA basic stove firebox.
Please consult your competent district master chimney sweep about this prior to
installation. He will advise you on the suitable chimney as well as all other
requirements which are of relevance for the setup and commissioning of your basic
stove. A sufficient combustion air supply must be ensured in particular, especially
with a very well sealed building shell, flat ventilation systems etc. in order to
guarantee smooth operation.
Your chimney sweep will be able to help here too. He will also check that the
fireplace has been connected properly. The basic stove firebox described here is
tested according to EN 15250 BlmschV (level 2) (German Federal Immission
Protection Ordinance) and may be attached to a chimney with multiple connections
provided that the chimney's technical conditions allow this. If the basic stove is
attached to a chimney with multiple connections, the heating door used must be self-
closing. This ensures that the door closes automatically after adding more fuel and
thus the supply pressure of the chimney is not affected.
Installation site / fire protection regulations
When setting up the basic stove, the valid fire protection regulations of the German
Fire Code Ordinance (FeuVo) and the specifications of the stove and air heating
construction trade (TROL) with respect to fire and heat protection must be observed.
The specified minimum distances to combustible objects and walls must be
maintained and the flooring must also be protected.
Note:
Only set up the fireplace on surfaces with a sufficient load bearing capacity. If the
load bearing capacity is not sufficient, suitable measures must be taken (e.g., plate
for load distribution) to remedy this.
Connection to the chimney
All connections from the stove to the chimney must be tight and firm. Always use a
wall lining to connect the connecting piece to the chimney.
Product specificaties
| Merk: | Brula |
| Categorie: | Haarden |
| Model: | D plus - tief - deep |
Heb je hulp nodig?
Als je hulp nodig hebt met Brula D plus - tief - deep stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Haarden Brula
20 December 2022
19 December 2022
19 December 2022
19 December 2022
21 December 2022
19 December 2022
19 December 2022
Handleiding Haarden
- Haarden Quigg
- Haarden Altech
- Haarden Austroflamm
- Haarden Barbas
- Haarden Barbecook
- Haarden Bellfires
- Haarden Big Fire
- Haarden Blackline
- Haarden Blumfeldt
- Haarden Bocal
- Haarden Boley
- Haarden Brunner
- Haarden Dimplex
- Haarden Dovre
- Haarden DRU
- Haarden Edilkamin
- Haarden El Fuego
- Haarden Element4
- Haarden Faber
- Haarden Franco Belge
- Haarden Global Fires
- Haarden Godin
- Haarden Haas-Sohn
- Haarden Hergom
- Haarden Hwam
- Haarden Icon Fires
- Haarden Italiana Camini
- Haarden K-Stove
- Haarden Kago
- Haarden Kalfire
- Haarden Landmann
- Haarden Livin Flame
- Haarden M-design
- Haarden Manor House
- Haarden Mondena
- Haarden Napoleon
- Haarden Norsk Kleber
- Haarden Perel
- Haarden Qlima
- Haarden Ruby Fires
- Haarden Saey
- Haarden Spartherm
- Haarden Stuv
- Haarden Thermocet
- Haarden Thermorossi
- Haarden Toolland
- Haarden Wanders
- Haarden Well Straler
- Haarden Xaralyn
- Haarden JAcobus
- Haarden Jydepejsen
- Haarden Olsberg
- Haarden OneConcept
Nieuwste handleidingen voor Haarden
4 December 2023
4 December 2023
4 December 2023
4 December 2023
4 December 2023
4 December 2023
4 December 2023
4 December 2023
4 December 2023
4 December 2023