Brondi FX-400 Twin Handleiding

Brondi Niet gecategoriseerd FX-400 Twin

Lees hieronder de 📖 handleiding in het Nederlandse voor Brondi FX-400 Twin (11 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 22 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/11

FX-4 Twin

PMR446

Private mobile radio

Instruction manual – English

1. LCD Screen

Channel Number. Changes from 1 to

8 as selected by the user.

CTCSS Code. Changes from 1 to 38

as selected by the user.

Displays the Battery change level.

When the bars are reduced, the

battery needs recharging.

TX Displayed when transmitting a signal.

RX Displayed when receiving a signal.

DCM Displayed when the Dual Watch function is turned ON.

VOX Displayed when the VOX feature is enabled.

SC Displays when the PMR is scanning all channels.

Displayed when the Key Lock feature is activated.

Displays the current Speaker volume level.

Displays when the call signal is ON.

Displays when the vibrator function is activated.

Antenna

LCD Screen

- Displays the

current channel

selection and other

radio s

mbols.

PTT (PUSH to

TALK) button

–Press and hold to

transmit.

CALL button

-Press to send

ringing tone to

other PMR units.

MENU Button

-Press to change

to switch between

modes.

eake

PWR(POWER)

Button – Press

and hold to turn

the unit ON or

OFF.

MIC

(

Micro

hone

)

UP/DOWN

Buttons –

Press to change

channels, volume,

and to select

Ear/Mic/Charger

jack

2. Installation

2.1 Removing the Belt Clip

a. Pull the Belt Clip latch forward

(away from the FX-400)

b. While pulling the Belt Clip

latch, push up the Belt Clip as

shown in Figure1.

2.2 Installing the Belt Clip

a. Slide the Belt Clip into the

slot as shown in Figure2.

b. A “click” indicates the Belt

Clip is locked into position.

2.3 Installing the Batteries

Caution: Observe the proper battery polarity orientation when

installing batteries. Incorrect positioning can damage both the

batteries and the unit.

a. Pull up the battery cover latch, Lift up Battery Compartment Cover.

b. Install the rechargeable batteries by following the orientation as

shown in Figure 3 (the arrow is showing and pointing upward.)

c. Replace the Battery Compartment Cover. See Figure 4.

Important

Read these Safety Warnings before you charge the batteries.

When placing the FX-400 in the charger, use only the rechargeable

batteries supplied with the FX-400.

Don’t try to recharge non-rechargeable batteries.

Make sure the battery compartment cover is securely locked in

place when you are charging the batteries.

Dispose of used batteries safely and in a way that will not harm

the environment- never try to burn them or put them anywhere, they

could get burnt or punctured.

Don’t leave dead batteries in your FX-400 units.

They might leak if you do.

2.4 Charging the batteries using direct charger

a. Lift up the Mic/Ear/Charger cover, insert the round connector at

the side of the unit.

b. Plug in the mains adaptor into a 240V AC, 50Hz main socket with

the switch on the socket set to OFF.

c. Switch ON the main socket.

d. It takes about 10 hours to fully recharge the batteries if they are

completely run down. New batteries take up to 14 hours to fully

charge.

Belt Cli

latch

ure 1 Fi

ure 2

ure 3 Fi

ure 4

Product specificaties

Merk:	Brondi
Categorie:	Niet gecategoriseerd
Model:	FX-400 Twin
Gewicht:	162 g
Oplader:	Ja
Type accu/batterij:	AAA
Energie-opslagtechnologie accu/batterij:	Nikkel-Metaalhydride (NiMH)
Batterijen meegeleverd:	Ja
Ondersteund aantal accu's/batterijen:	4
Batterij bijna leeg-indicatie:	Ja
Maximumbereik:	10000 m
Frequentie:	446 - 446.1 MHz
Oplaadbaar:	Ja
Aantal kanalen:	8 kanalen
Pager functie:	Nee
Riemclip:	Ja
Batterijen inbegrepen:	Ja
Batterijtechnologie:	Nikkel-Metaalhydride (NiMH)
Type batterij:	AAA
Aantal kanalen (totaal):	8 kanalen