Broan RMDD4804 Handleiding

Broan Afzuigkap RMDD4804

Lees hieronder de 📖 handleiding in het Nederlandse voor Broan RMDD4804 (40 pagina's) in de categorie Afzuigkap. Deze handleiding was nuttig voor 49 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/40

Downdraft Ventilators

Page 1

WARNING

READ AND SAVE THESE INSTRUCTIONS

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO

PERSONS, OBSERVE THE FOLLOWING:

1. Use this unit only in the manner intended by the manufacturer. If you

have questions, contact the manufacturer at the address or telephone

number in the warranty.

2. Before servicing or cleaning unit, switch power off at service panel

and lock the service disconnecting means to prevent power from be-

ing switched on accidentally. When the service disconnecting means

cannot be locked, securely fasten a prominent warning device, such

as a tag, to the service panel.

3. Installation work and electrical wiring must be done by a qualified

person(s) in accordance with all applicable codes and standards,

including fire-rated construction codes and standards.

4. Sufficient air is needed for proper combustion and exhausting of

gases through the flue (chimney) of fuel burning equipment to prevent

backdrafting. Follow the heating equipment manufacturer’s guideline

and safety standards such as those published by the National Fire

Protection Association (NFPA), and the American Society for Heating,

Refrigeration and Air Conditioning Engineers (ASHRAE), and the local

code authorities.

5. When cutting or drilling into wall or ceiling, do not damage electrical

wiring and other hidden utilities.

6. Ducted fans must always be vented to the outdoors.

7. To reduce the risk of fire, use only metal ductwork.

8. Do not install this product with the activating switch directly behind

a burner or element. Minimum distance between the switch and the

edge of the burner should be 4 inches.

9. Loose-fitting or hanging clothing should never be worn when operating

this appliance. They may be ignited by burners/elements on cooktop.

10. Children should not be left alone or unattended in the area where this

appliance is in use.

11. This unit must be grounded.

TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:

a) Never leave surface units unattended at high settings.

Boilovers cause smoking and greasy spillovers that may

ignite. Heat oils slowly on low or medium settings.

b) Always turn hood ON when cooking at high heat or when

cooking flaming foods.

c) Clean ventilating fans frequently. Grease should not be

allowed to accumulate on fan or filter.

d) Use proper pan size. Always use cookware appropriate

for the size of the surface element.

TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF

A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWINGa:

1. SMOTHER FLAMES with a close-fitting lid, cookie sheet,

or metal tray, then turn off the burner. BE CAREFUL TO

PREVENT BURNS. If the flames do not go out immedi

ately, EVACUATE AND CALL THE FIRE DEPARTMENT.

2. NEVER PICK UP A FLAMING PAN - You may be burned.

3. DO NOT USE WATER, including wet dishcloths or towels

- a violent steam explosion will result.

4. Use an extinguisher ONLY if:

A. You know you have a Class ABC extinguisher, and you

already know how to operate it.

B. The fire is small and contained in the area where it

started.

C. The fire department is being called.

D. You can fight the fire with your back to an exit.

a Based on “Kitchen Firesafety Tips” published by NFPA.

MODEL WIDTH BLOWER

RMDD3004 30" 500 cfm Internal

RMDD3604 36" 500 cfm Internal

RMDD4804 48" 500 cfm Internal

RMDD3004EX 30" Models 331H, 332H, 335, 336 HLB3, HLB6, HLB9, and HLB11 External (purchase separately)

RMDD3604EX 36" Models 331H, 332H, 335, 336 HLB3, HLB6, HLB9, and HLB11 External (purchase separately)

RMDD4804EX 48" Models 331H, 332H, 335, 336 HLB3, HLB6, HLB9, and HLB11 External (purchase separately)

WARNING - To reduce the risk of burns or ignition of clothing by reaching across burners, the downdraft remote control MUST

be mounted in the countertop - at least 4" from the burners. See "INSTALL COOKTOP" section on page 8.

INSTALLER:

Save this manual for Electrical

Inspector and Homeowner to use.

NOTE: Model RMDDRBK Remote Up/Down

Control sold separately.

CAUTION

1. For indoor use only.

2. For general ventilating use only. Do not use to exhaust hazardous or

explosive materials and vapors.

3. To avoid motor bearing damage and noisy and/or unbalanced impel-

lers, keep drywall spray, construction dust, etc. off power unit.

4. Clean filters and grease-laden surfaces frequently.

5. Do not repair or replace any part of this appliance unless specifically

recommended in this manual. All other servicing should be done by

a qualified technician.

6. Please read specification label on product for further information and

requirements.

7. To reduce the risk of fire and electric shock, install this downdraft only

with Rangemaster blower models shown below. Other blowers cannot

be substituted. (blowers sold separately).

MODEL WIDTH BLOWER

RMDD3004 30" 500 cfm Internal

RMDD3604 36" 500 cfm Internal

RMDD4804 48" 500 cfm Internal

RMDD3004EX 30" External, Model 331H, 332H, 335, 336,

HLB3, HLB6, HLB9, y HLB11 (purchase

separately)

RMDD3604EX 36" External, Model 331H, 332H, 335, 336,

HLB3, HLB6, HLB9, y HLB11 (purchase

separately)

RMDD4804EX 48" External, Model 331H, 332H, 335, 336,

HLB3, HLB6, HLB9, y HLB11 (purchase

separately)

Page 2

Downdraft Ventilators

AIR

VENT

COUNTER

TOP

BLOWER

BOX

CHIMNEY TOP

COOK TOP

GEAR

MOTOR

COVER

TYPICAL INSTALLATION

120 VAC

GROUNDED

OUTLET

This downdraft blower system is

designed to be used to exhaust

airborne contaminants when

cooking with a variety of gas

or electric cooktops. It can be

mounted in island, peninsula,

or conventional wall locations.

This unit can be easily installed

following these basic steps:

• Cut out the countertop

opening.

• Mount the unit in the cabi-

net.

• Connect the ductwork and

electrical.

• Install the cooktop.

Note: the high level of air flow

of this appliance may effect the

gas flame on some types of gas

cooktops. This is NORMAL and

will cause no harm, but can be

corrected by lowering the speed

of the blower.

PLANNING

Internal Blower Installation External Blower Installation

Note: the high level of air flow of this appliance may effect the

gas flame on some types of gas cooktops. This is NORMAL and

will cause no harm, but can be corrected by lowering the speed

of the blower.

ELECTRICAL

SPECIFICATIONS

120 VAC • 60 Hz • 4.0 A

TAKE MEASUREMENTS

All Units

1. Refer to the cooktop installation instructions for dimensions

of cooktop, countertop cut-out, and cabinet requirements.

Models RMDD3004 & RMDD3004EX will fit in most 30" wide

cabinets. Models RMDD3604 & RMDD3604EX will fit in most

36" wide cabinets. Models RMDD4804 & RMDD4804EX will

fit in most 48" wide cabinets. However, it is recommended that

oversized cabinets be used for easier installation.

2. Cooktop depth can vary greatly from one to another. This may

cause the fit of these two appliances to be rather tight.

Pay special attention to the areas of potential interference high-

lighted above. A countertop with (A) a raised lip and/or (B) a

backsplash may not allow enough flat countertop for a proper

installation. Note that 2-3/8" of flat countertop is required behind

cooktop and that 1-3/4" is necessary between the back edge of

the cooktop and the inside of cabinet back.

ELECTRICAL

SPECIFICATIONS

120 VAC • 60 Hz • 6.0 A (max.)

3-1/4" X 10"

DUCT CONNECTOR

AIR

VENT

BLOWER

BOX

CHIMNEY TOP

COOK TOP

GEAR

MOTOR

COVER

TYPICAL INSTALLATION

3-1/4" X 14"

DUCT CONNECTOR

120 VAC

GROUNDED

OUTLET

COUNTER

TOP

This downdraft blower system

is designed to be used to ex-

haust airborne contaminants

when cooking with a variety

of gas or electric cooktops.

It can be mounted in island,

peninsula, or conventional wall

locations.

This unit can be easily installed

following these basic steps:

• Cut out the countertop

opening.

• Mount the unit in the

cabinet.

• Install Model 331H,

332H, 335, 336, HLB3,

HLB6, HLB9, HLB11

External Blower

• Connect the ductwork

and electrical.

• Install the cooktop.

1-3/4"

2-3/8"

Downdraft Ventilators

Page 3

1. The interior down-

draft blower system is

designed for use with

3-1/4" x 10" ductwork

(can be transitioned

to 6" round). Three

different discharge

directions are avail-

able with side-to-

side adjustment for

accurate alignment of

ductwork.

2. For best performance:

Choose the ducting

option which allows

the shortest length

of ductwork and a

minimum number of

elbows and transi-

RIGHT

DISCHARGE

DOWN DISCHARGE

LEFT

DISCHARGE

PLAN THE DUCTWORK

Internal Blower Installation External Blower Installation

EQUALS 8 FT. OF

STRAIGHT DUCT

6" ROUND

ELBOW

EQUALS 14 FT. OF

STRAIGHT DUCT

3. The system will operate most efficiently when the ductwork

does not exceed 40 feet of equivalent duct. The chart, above,

shows equivalent feet of elbows and transitions. The number

of feet of straight duct plus the equivalent feet of transitions

and/or elbows to be used should equal 40 feet or less.

NOTE: The equivalent feet of various roof and wall caps has

been taken into consideration. Do not include them in this

calculation.

3-1/4" X 10" TO 6" RD.

TRANSITION

3-1/4" X 10"

90O ELBOW

tions. Check location of floor joists, wall studs, electrical

wiring or plumbing for possible interference.

EQUALS

2 FT. OF

STRAIGHT DUCT

1. The exterior down-

draft blower system is

designed for use with

3-1/4" x 14"rectan-

gular ductwork (can

be transitioned to 8"

or 10" round). Three

different discharge

directions are avail-

able with side-to-

side adjustment for

accurate alignment of

ductwork.

2. For best performance:

Choose the ducting

option which allows

the shortest length

of ductwork and a

minimum number of

RIGHT

DISCHARGE

DOWN DISCHARGE

LEFT

DISCHARGE

EQUALS 11 FT. OF

STRAIGHT DUCT

8" ROUND ELBOW

EQUALS 19 FT. OF

STRAIGHT DUCT

3. The system will operate most efficiently when the ductwork

does not exceed 40 feet of equivalent duct. The chart, above,

shows equivalent feet of elbows and transitions. The number

of feet of straight duct plus the equivalent feet of transitions

and/or elbows to be used should equal 40 feet or less.

NOTE: The equivalent feet of various roof and wall caps has

been taken into consideration. Do not include them in this

calculation.

3-1/4" X 14" TO 8" RD.

TRANSITION

3-1/4" X 14" 90O

ELBOW

elbows and transitions. Check location of floor joists, wall

studs, electrical wiring or plumbing for possible interference.

EQUALS

5 FT. OF

STRAIGHT

DUCT

Internal Blower Installation External Blower Installation

TAKE MEASUREMENTS (CONTINUED)

SIDE VIEW

OF DOWNDRAFT

SIDE VIEW

OF DOWNDRAFT

Product specificaties

Merk:	Broan
Categorie:	Afzuigkap
Model:	RMDD4804

Heb je hulp nodig?

Als je hulp nodig hebt met Broan RMDD4804 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Afzuigkap Broan

Broan Elite E6430SSM Handleiding

2 November 2024

Broan Elite E6030SSM Handleiding

2 November 2024

Broan Elite RMIP45 Handleiding

3 April 2024

Broan Elite 619004 Handleiding

3 April 2024

Broan BWS1304SS Handleiding

3 April 2024

Broan EWS1306BLS Handleiding

3 April 2024

Broan BWP1304SS Handleiding

3 April 2024

Broan PM250 Handleiding

3 April 2024

Broan Elite 614804EX Handleiding

3 April 2024

Broan BWP1364SS Handleiding

3 April 2024

Handleiding Afzuigkap

Nieuwste handleidingen voor Afzuigkap

MPM -61-PX-75 Handleiding

24 December 2024

MPM -61-PX-76 Handleiding

24 December 2024

MPM -61-PX-77 Handleiding

24 December 2024

Kaiser A 9315 ElfEm Eco Handleiding

20 December 2024

Kaiser A 9315 RotEm Eco Handleiding

20 December 2024

Kaiser AT 9343 Handleiding

20 December 2024

Kaiser A 6315 RotEm Eco Handleiding

20 December 2024

Kaiser AT 6445 AD Eco Handleiding

20 December 2024

Kaiser A 6423 ElfBE Eco Handleiding

20 December 2024

Kaiser AT 8435 Eco Handleiding

20 December 2024