Broan EW5836SS Handleiding

Broan Afzuigkap EW5836SS

Lees hieronder de 📖 handleiding in het Nederlandse voor Broan EW5836SS (28 pagina's) in de categorie Afzuigkap. Deze handleiding was nuttig voor 21 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/28
MODELS EW5830SS • EW5836SS
Page 1
Chimney
Range Hood
READ AND SAVE THESE INSTRUCTIONS
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY
TO PERSON(S) OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufacturer. If
you have questions, contact the manufacturer at the address or
telephone the number listed in warranty.
2. servicing Before or cleaning unit, switch power off at service panel
and lock service disconnecting means to prevent power from being
switch on accidentally. When the service disconnecting means
cannot be a locked, securely fasten prominent warning device,
such a as tag, to the service panel.
3. Installation work and electrical be wiring must done by qualified
personnel in accordance codes standards, applicable with all and
including construction fire-rated codes and standards.
4. is combustion Sufficient air needed for proper and exhausting
of gases through the flue (chimney) burning of fuel equipment to
prevent back drafting. Follow the heating equipment manufacturer’s
guideline published and safety standards such as those by the
National Protection Association American Fire (NFPA), and the
Society Refrigeration for Heating, and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
5. This product may have sharp edges. Be careful to avoid cuts and
abrasions during installation and cleaning.
6. When cutting or drilling into wall or ceiling, do not damage electrical
wiring and other hidden utilities.
7. Ducted fans must always be vented to the outdoors.
8. only Use metal ductwork.
9. Do not use this unit with any other solid-state speed control device.
10. Do operate not any fan with a damaged cord or plug. Discard fan or
return to an authorized service facility for examination and/or repair.
11. GROUNDING be INSTRUCTION: The appliance must grounded.
In the event of an electrical short circuit, grounding reduces the risk
of electric shock by providing an escape wire for the electric current.
The appliance is equipped with a cord having a grounding wire with
a be is grounding plug. The plug must plugged into an outlet that
properly installed grounded. grounding and WARNING: Improper
can a a result in risk of electric shock. Consult qualified electrician
if the if grounding instructions are not completely understood, or
doubt exists is Do as to whether the appliance properly grounded.
not is use an extension cord. If the power supply cord too short,
have a qualified electrician install an outlet near the appliance.
TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
a) Never leave surface units unattended at high settings. Boilovers
cause smoking and greasy spillovers oils that may ignite. Heat
slowly low on or medium settings.
b) Always turn hood ON when cooking at high heat or when flambéing
food Peppercorn (i.e. Crêpes Suzette, Cherries Jubilee, Beef
Flambé).
c) Clean ventilating frequently. fans be Grease should not allowed to
accumulate on fan or filters.
d) Use proper pan size. Always use cookware appropriate for the size
of surface the element.
1. For indoor use only.
2. For general ventilating use only. Do not use to exhaust hazardous
or explosive materials and vapors.
3. To avoid motor bearing damage and noisy and/or unbalanced
impeller, keep drywall spray, construction dust, etc. off power unit.
4. Your hood motor has a thermal overload which will automatically
shut off the motor if it becomes overheated. The motor will restart
when it will cool down. If the motor continues to shut off and
restart, the hood serviced. have
5. The bottom of the hood MUST BE LESS than 24” NOT and
recommended at maximum of 36” a above cooktop best for
capture of cooking impurities.
6. Two installers are recommended because of the size of this
hood.
7. To reduce risk of fire and to properly exhaust air, be sure duct to
air outside. Do not exhaust air into spaces within walls or ceilings
or into attics, crawl spaces, or garages.
8. Be careful when installing the decorative flue and hood, they may
have sharp edges.
9. This hood is not intended to a be used as shelf.
10. Please read specification label on product further information for
and requirements.
Installer: Leave this manual
with the homeowner.
Homeowner: Operation and Maintenance
instructions on pages 7 & 8.
WARNING
CAUTION
FOR DOMESTIC COOKING ONLY
WARNING
Register your product online at: www.broan.com
TO REDUCE THE RISK OF INJURY TO PERSON(S) IN THE EVENT
OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING*:
1. SMOTHER a FLAMES with close-fitting lid, cookie sheet, or metal
tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS.
IF DO THE FLAMES NOT GO OUT IMMEDIATELY, EVACUATE
AND CALL THE FIRE DEPARTMENT.
2. NEVER PICK A be UP FLAMING PAN You may burned.
3. DO NOT USE WATER, including wet dishcloths or towels a violent
steam explosion will result.
4. Use extinguisher an ONLY if:
A. You a extinguisher, know you have Class ABC and you
know how operate to it.
B. The is small fire and contained in the it area where started.
C. The department is fire being called.
D. You can fight the fire with your back to an exit.
* Based on published “Kitchen Fire Safety Tips” by NFPA
MODELS EW5830SS • EW5836SS
Page 2
INSTALL THE DUCTWORK
(Ducted Hoods Only)
1. Decide where the ductwork will run between the hood and
the outside.
2. A straight, short duct run will allow the hood perform most to
efficiently.
3. Long duct runs, elbows and transitions will reduce the
performance of the hood. Use as of them as possible. few
Larger ducting be required best performance with may for
longer duct runs.
4. Install wall cap or roof cap. Connect round metal ductwork
to towards cap and back work the hood location. Use duct
tape seal the joints between ductwork sections.to
NOTE
Centerline of duct connector on hood is ¾” the left of the to
centerline of the hood – plan duct rough-in accordingly.
MEASURE THE INSTALLATION
The minimum hood distance above cooktop MUST BE NOT
LESS than 24”.
A maximum of 36” above cooktop is highly recommended for
best capture of cooking impurities.
Distances 36 at the installer and users discretion; over are
providing that the ceiling height permits.
PREPARE THE HOOD
HOOD
12 3/8 TO CENTER
OF UPPER BRACKET
HOLES
ROUND ELBOW
HOOD MOUNTING
BRACKET
24” 36” TO AB EOV
COOKING SURFACE
1 5/ ”8
DECORATIVE FLUE
6” ROUND DUCT
ROOF CAP
WALL P CA
2” TO CENTER
OF
LOWER HOOD
CHASIS HOLES
3½” FROM WALL TO
CENTER LINE OF DUCT
( NOTE: CENTERLINE OF
BLOWER ¾ IS LEFT OF
CENTERLINE .)OF HOOD
DECORATIVE FLUE
Unpack hood and check contents. You should receive:
1 - Hood Assembly
1 - Decorative Flue Assembly (consisting of upper and lower
flue)
1 - Upper Flue Mounting Bracket
2 - Aluminum Grease Filters (installed on hood)
2 - 35W MR16 GU10 Halogen Lamps (installed on hood)
1 - Parts Bag containing:
6 - Mounting Screws (4mm x 38mm Cross Recessed Head) Pan
2 - Mounting Screws (4mm x 12mm Cross Recessed Pan Head)
1 - Suction Cup Tool
1 - Installation Manual
6 MOUNTING
SCREWS
(4mm x 38mm
Cross Recessed
Pan Head)
2 MOUNTING
SCREWS
(4mm x 12mm
Cross Recessed
Pan Head)
DECORATIVE
FLUE
ASSEMBLY
UPPER
FLUE MOUNTING
BRACKET
BULB
SUCTION
CUP TOOL
HOOD
ASSEMBLY
MODELS EW5830SS • EW5836SS
Page 3
INSTALL THE WIRING INSTALL THE HOOD MOUNTING
SUPPORT
1. Construct wood wall framing that is flush with interior
surface of wall studs. Make sure the framing is centered over
installation location.
NOTE
Hood distance above cooktop is: Minimum 24”, Maximum 36”.
9-ft. and 10-ft. ceilings require Flue Extension, Model may
FXNE58SS, depending on installation height (purchase
separately). See chart below additional installation height for
information.
2. After wall surface is finished, fasten (2) 4mm x 38mm screws
at the locations shown above. DO TIGHTEN screws all NOT
the way.
24”
MAX.
HOOD
CENTERLINE
4¼”
MAX.
12”
24” TO 36”
ABOVE
COOKTOP
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical
short circuit, grounding reduces the risk of electric shock by
providing an escape wire the electric current. This appliance for
is equipped with a cord having a grounding wire with a grounding
plug. The plug must be plugged into an outlet that is properly
installed and grounded.
Position the electrical outlet within the space covered the by
decorative flue and where it will not interfere with the round
duct. Make sure the outlet is no further than 24” from the top
of the hood chassis, and that the outlet does not interfere with
a mounting bracket fastening area or where the decorative flue
touches the wall.
24" 25" 26" 27" 28" 29" 30" 31" 32" 33" 34" 35" 36"
Ceiling
Height
8 Feet 36-3/8" 37-3/8" 38-3/8" 39-3/8" 40-3/8" 41-3/8" 42-3/8"
*43-3/8" *44-3/8" *46-3/8" *48-3/8"*45-3/8" *47-3/8"9 Feet
9 Feet
with
FXNE58SS
10 Feet
with
FXNE58SS 43-3/8" 44-3/8" 45-3/8" 46-3/8" 47-3/8" 48-3/8"
* Non-duct recirculation louvers will be exposed in ducted configuration
Desired Hood Distance (Above 36" High Cooktop)
Upper Mounting Screws Location (Distance above 36" High Cooktop)
(Dimension “A”)
*42-3/8"
36-3/8" 37-3/8" 38-3/8" 39-3/8" 40-3/8" 41-3/8" 42-3/8"
36-3/8" 37-3/8" 38-3/8" 39-3/8" 40-3/8" 41-3/8" 42-3/8"
C
L
36” HIGH COOKTOP
10 3/ ”8
3 ”
3 1/ ”2
4mm x 38mm
SCREWS
HERE
A
SEE
CHART
BELOW
2 ”


Product specificaties

Merk: Broan
Categorie: Afzuigkap
Model: EW5836SS

Heb je hulp nodig?

Als je hulp nodig hebt met Broan EW5836SS stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Afzuigkap Broan

Handleiding Afzuigkap

Nieuwste handleidingen voor Afzuigkap