Boss Dual Cube Bass LX Handleiding

Boss Basgitaarversterker Dual Cube Bass LX

Lees hieronder de 📖 handleiding in het Nederlandse voor Boss Dual Cube Bass LX (12 pagina's) in de categorie Basgitaarversterker. Deze handleiding was nuttig voor 3 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/12

Owner’s Manual

Bass Amplier

Before using this unit, carefully read “USING THE UNIT SAFELY” and “IMPORTANT NOTES” (leaet “USING THE UNIT SAFELY” and Owner’s Manual (p. 12)). After reading, keep

the document(s) where it will be available for immediate reference.

Panel Descriptions

1 INPUT jack

Connect your bass guitar here.

2 [COMP/DRIVE] button

Sets the comp and distortion eects.

If this is “OFF”, these eects are not applied.

[DRIVE] button

To use the distortion eects, press the [DRIVE] button to make it

light up.

3 [AMP TYPE] knob

Selects the amp type.

Type Explanation

SUPER FLAT An amp with at tonal characteristics.

FLAT An amp with a classic bass sound.

VINTAGE An amp with a fat but sweet vintage sound.

MODERN An amp with a tight low end and a crisp high end.

ROCK An amp with a characteristic overdrive sound.

4 [MEMORY] button

Use the memory feature to store three dierent sets of knob

congurations for each amp type (p. 6).

5 [GAIN] knob

Adjusts the gain (amount of distortion).

6 [VOLUME] knob

Adjusts the volume before equalization and eects are applied.

7 EQUALIZER

[BASS] knob

Adjusts the sound level of the low-frequency range.

[MIDDLE] knob

Adjusts the sound level of the middle-frequency range.

[TREBLE] knob

Adjusts the sound level of the high-frequency range.

8 [EFFECTS] knob

Use this knob to switch between eects such as chorus or anger,

depending on the knob’s position.

Type Explanation

OFF Eects are not applied.

CHORUS

Chorus is an eect that creates a beautiful tonal

spaciousness and depth by adding a slightly

modulated sound.

FLANGER Gives a twisting, anged character to the sound.

T-WAH You can produce a wah eect with the lter

changing in response to the bass level.

9 [DELAY/REVERB] knob

Use this knob to switch between eects such as delay or reverb,

depending on the knob’s position.

Type Explanation

OFF Eects are not applied.

DELAY Changes the delay time and eect.

REVERB Adjusts the volume of the reverb.

Top Panel

7 10

8 9

1 43 65 12 13 14 1511

Panel Descriptions

10 RHYTHM GUIDE

The rhythm guide built into this amp features drum and percussion

rhythm patterns that are useful when you’re practicing by yourself.

Set this to the pattern you like when you practice, or use it as a

metronome (p. 6).

[PATTERN] knob

Selects the genre of the rhythm pattern.

[START/STOP] button

Starts/stops the rhythm guide. When you start the rhythm guide,

the [START/STOP] button blinks in time with the tempo.

[TAP TEMPO] button

Sets the tempo for the rhythm guide. Press this button twice at

the tempo you desire to make the rhythm guide play back at that

tempo.

[VARIATION] button

Selects the rhythm pattern variation. There are three types of

rhythm variations available for each genre.

The [VARIATION] button color changes from green unlitÓredÓ

with each press, and the variation changes accordingly.

[VOLUME] knob

Adjusts the volume of the rhythm guide.

11 PHONES/REC OUT jack

Connect your headphones or headset mic here.

Adjust the headset mic volume with the [MIC VOL] knob.

* No sound is played through the unit’s speaker while the PHONES/

REC OUT jack is in use.

* You may hear feedback with some headset mics if you raise the

volume too much. Also keep in mind that feedback may occur

between the headset mic and the speakers connected to the LINE

OUT jacks.

* Turn down the [MIC VOL] knob when plugging or unplugging a

cable into the PHONES/REC OUT jack. Also, make sure that the plug

is inserted fully into the jack. If a plug is not fully inserted with the

volume turned up, an unpleasant loud noise may be heard.

* Pin arrangement for PHONES/REC OUT jack (stereo, CTIA)

GND

MIC

12 LOOPER indicator

You can use the looper by connecting a footswitch (FS-5U, FS-6,

FS-7; sold separately) to the FOOT SW jack (p. 7).

13 [MASTER] knob

Adjusts the output volume.

14 POWER indicator

This indicator lights when the unit is turned on.

* When operating on battery power, the unit’s POWER indicator

blinks if the batteries are nearly depleted. Replace the batteries as

soon as possible (p. 5).

15 [POWER] switch

Turns the power of this unit on/o (p. 5).

Product specificaties

Merk:	Boss
Categorie:	Basgitaarversterker
Model:	Dual Cube Bass LX
Kleur van het product:	Zwart
Gewicht:	4400 g
Breedte:	341 mm
Diepte:	205 mm
Hoogte:	261 mm
Gebruikershandleiding:	Ja
Aan/uitschakelaar:	Ja
Connectiviteitstechnologie:	Bedraad
Type stroombron:	AC, Battery
Inclusief AC-adapter:	Ja
Aantal USB 2.0-poorten:	1
Gemiddeld vermogen:	10 W
Ondersteund aantal accu's/batterijen:	8
Geschikt voor:	Elektrische basgitaar
Aantal luidsprekers:	2
Volumeregeling:	Draaiknop
Draaghandvat:	Ja
Inclusief netsnoer:	Ja
Ingang stroom:	Ja
Audio-uitgangskanalen:	2.0 kanalen
XLR out:	1
Type batterij:	AA
Piekvermogen per kanaal:	5 W
Ingang van 6,35 mm (1/4-inch):	1
Nominale input level:	-10 dB
Bestandsgrootte luidspreker-stuurprogramma:	5 "
Versterkingsregeling:	Ja
Pedaalstekker:	Ja