Boss DC-2W Handleiding

Boss Niet gecategoriseerd DC-2W

Lees hieronder de 📖 handleiding in het Nederlandse voor Boss DC-2W (1 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 47 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/1

Owner’s Manual

S/SDD-320 switch

Switches the sound variation.

S (Standard)

Reproduces the sound of the original DC-2.

SDD-320

Reproduces a sparkling sound of the SDD-320.

MODE SELECTOR [1]–[4] buttons

Select the sound. Higher numbers produce a deeper eect.

By pressing two buttons simultaneously you can combine the eects.

Before using this unit, carefully read the sections entitled: “USING THE UNIT SAFELY” and “IMPORTANT NOTES” (supplied on a separate sheet).

After reading, keep the document(s) where it will be available for immediate reference.

Precautions When Connecting

5 To prevent malfunction and equipment failure, always turn

down the volume, and turn o all the units before making any

connections.

5 Once everything is properly connected, be sure to follow the

procedure below to turn on their power. If you turn on equipment

in the wrong order, you risk causing malfunction or equipment

failure.

When powering up: Turn on the power to your guitar amp last.

When powering down: Turn o the power to your guitar amp rst.

5 Before turning the unit on/o, always be sure to turn the volume

down. Even with the volume turned down, you might hear some

sound when switching the unit on/o. However, this is normal and

does not indicate a malfunction.

Use of Battery

5 The life of the included battery may be limited as its primary

purpose was for testing during assembly.

5 If you handle batteries improperly, you risk explosion and uid

leakage. Make sure that you carefully observe all of the items

related to batteries that are listed in “USING THE UNIT SAFELY” and

“IMPORTANT NOTES” (supplied on a separate sheet).

5 When operating on battery power only, the unit’s indicator will

become dim when battery power gets too low. Replace the

battery as soon as possible.

5 Batteries should always be installed or replaced before connecting

any other devices. This way, you can prevent malfunction and

damage.

5 If operating this unit on battery, please use alkaline battery.

Changing the Battery

1. Hold down the

pedal and loosen

the thumbscrew,

then open the

pedal upward.

* The pedal can be

opened without

detaching the

thumbscrew

completely.

2. Remove the old battery from the battery housing, and

remove the snap cord connected to it.

3. Connect the snap cord to the new battery, and place

the battery inside the battery housing.

* Be sure to carefully observe the battery’s polarity (+ versus -).

4. Slip the coil spring onto the spring base on the back of

the pedal, and then close the pedal.

* Carefully avoid getting the snap cord caught in the pedal, coil

spring, and battery housing.

5. Finally, hold down the pedal while tightening the

thumbscrew into the guide bush hole.

OUTPUT Jacks

Mono output

Eect sound

Stereo output

Eect sound (R)Eect sound (L)

MEMO

The audio output of this unit does not support mono mix (stereo input /

mono output).

To obtain the optimal Dimension eect, we recommend that you use the

unit with stereo output.

Specications

Nominal Input Level -20 dBu

Input Impedance 2.2 MΩ

Nominal Output

Level -20 dBu

Output Impedance 1 kΩ

Recommended Load

Impedance 10 kΩ or greater

Power Supply Alkaline battery (9 V, 6LR61)

AC adaptor (PSA series: sold separately)

Current Draw 65 mA

* Expected battery life under continuous use:

Alkaline: 6 hours

These gures will vary depending on the

actual conditions of use.

Dimensions 73 (W) x 129 (D) x 59 (H) mm

2-7/8 (W) x 5-1/8 (D) x 2-3/8 (H) inches

Weight 450 g / 1lb (including battery)

Accessories Leaet (“USING THE UNIT SAFELY,” “IMPORTANT

NOTES,” and “Information”)

Alkaline battery (9 V, 6LR61)

Options

(sold separately) AC adaptor (PSA-series)

* 0 dBu = 0.775 Vrms

* This document explains the specications of the product at the

time that the document was issued. For the latest information,

refer to the Roland website.

Intellectual Property Right

5 Roland, BOSS, and WAZA CRAFT are either registered

trademarks or trademarks of Roland Corporation in the United

States and/or other countries.

Thumbscrew

Battery Housing

Pedal

Spring Base

Coil Spring

Guide Bush

Hole

Battery Snap

Cord

Battery

Snap

9 V Battery

Thumbscrew

When this screw is loosened, the

pedal will open, allowing you to

change the battery.

* For instructions on changing

the battery, refer to “Changing

the Battery.”

AC Adaptor

(PSA series; sold separately)

Electric Guitar

Electronic Musical Instrument

(e.g., keyboards)

English

7This is a WAZA CRAFT series eect pedal crafted with a high-quality analog original circuit design.

7The “Dimension” eect add unique natural spaciousness and rich depth to your sound.

7This pedal also reproduces the sound of “SDD-320 Dimension D” used by countless recording studios, providing a more sparkling sound.

Main Features

Panel Descriptions

DC IN jack

In addition to 9-volt battery operation, this unit can also operate on a 9-volt AC adaptor (BOSS PSA series;

sold separately).

* Use only the specied AC adaptor (PSA series; sold separately), and connect it to an AC outlet of the

correct voltage.

* If the AC adaptor is connected while a battery is installed, the power

supply is drawn from the AC adaptor.

CHECK indicator

This indicator shows whether the eect is ON/OFF, and also doubles as the battery check

indicator. The indicator lights when the eect is ON.

* The brightness of the CHECK indicator (LED) will dim as the battery lowers. Replace the

battery when the LED is dim or does not light. For instructions, refer to “Changing the

Battery.”

Pedal switch

This switch turns the eect on/o.

OUTPUT B jack

Use this jack for stereo output.

By using this in conjunction with the

OUTPUT A (MONO) jack you can obtain

spacious sound.

OUTPUT A (MONO) jack

Outputs the eect sound in mono.

INPUT jack

Connect the output of your

electric guitar, electronic

musical instrument, or eect

unit to this jack.

* The INPUT A (MONO) jack

doubles as the power

switch. Power to the unit

is turned on when you

plug into the INPUT A

(MONO) jack; the power is

turned o when the cable

is unplugged. To prevent

unnecessary battery

consumption, be sure to

disconnect the plug from

the INPUT A (MONO) jack

when not using the eects

unit.

Guitar Amplier

5 CMSIS-RTOS RTX Version 4.70.1

rights reserved.

Redistribution and use in source and binary forms, with or without

modication, are permitted provided that the following conditions

are met:

7Redistributions of source code must retain the above copyright

notice, this list of conditions and the following disclaimer.

7Redistributions in binary form must reproduce the above copyright

notice, this list of conditions and the following disclaimer in

the documentation and/or other materials provided with the

distribution.

7Neither the name of ARM nor the names of its contributors may be

used to endorse or promote products derived from this software

without specic prior written permission.

THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND

CONTRIBUTORS “AS IS” AND ANY EXPRESS OR IMPLIED WARRANTIES,

INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF

MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE

ARE DISCLAIMED. IN NO EVENT SHALL COPYRIGHT HOLDERS AND

CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,

SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT

NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES;

LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)

HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN

CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR

OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE,

EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.

For the USA

SUPPLIER’S DECLARATION OF

CONFORMITY

Compliance Information Statement

Model Name :

Type of Equipment :

Responsible Party :

Address :

Telephone :

DC-2W

Guitar Eects

Roland Corporation U.S.

5100 S. Eastern Avenue Los Angeles,

CA 90040-2938

(323) 890-3700

Product specificaties

Merk:	Boss
Categorie:	Niet gecategoriseerd
Model:	DC-2W
Kleur van het product:	Paars
Gewicht:	450 g
Breedte:	73 mm
Diepte:	129 mm
Hoogte:	59 mm
Type stroombron:	AC, Battery
Accu/Batterij voltage:	9 V
Ondersteund aantal accu's/batterijen:	1
Aansluiting voor netstroomadapter:	Ja
Stroomverbruik:	65 mA
Beste gebruik:	Gitaar
Type product:	Expressiepedaal
Synchronisatie ingangsimpedantie:	2200000 Ohm
Uitgang van 6,35 mm (1/4-inch):	2
Output impedance:	1000 Ohm
Ingang van 6,35 mm (1/4-inch):	2
Uitgangsniveau:	-20/0 dB
Garantieperiode:	5 jaar
Nominale input level:	-20 dB
Status-indicatorlichtje:	Ja