Boss Chorus CE-2W Handleiding
Boss
Gitaarversterker
Chorus CE-2W
Lees hieronder de đ handleiding in het Nederlandse voor Boss Chorus CE-2W (1 pagina's) in de categorie Gitaarversterker. Deze handleiding was nuttig voor 4 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/1
Ownerâs Manual
Standard/CE-1 mode switch
Switches the mode.
Standard
The sound of the CE-2.
This is a chorus sound notable for its clarity; it will not
impair the crispness of your guitar sound.
CE-1 Chorus
The chorus sound of the CE-1.
While providing an easily recognizable chorus eîect
with deeper modulation, this chorus is distinctively
mild.
CE-1 Vibrato
The vibrato sound of the CE-1.
This is a unique chorus with strongly varying
modulation.
DEPTH knob
Adjusts the depth of the chorus.
RATE knob
Adjusts the rate of the chorus.
Before using this unit, carefully read the sections entitled: âUSING THE UNIT SAFELYâ and âIMPORTANT NOTESâ (supplied on a separate sheet).
After reading, keep the document(s) where it will be available for immediate reference.
Precautions When Connecting
5 To prevent malfunction and equipment failure, always turn
down the volume, and turn oî all the units before making any
connections.
5 Once everything is properly connected, be sure to follow the
procedure below to turn on their power. If you turn on equipment
in the wrong order, you risk causing malfunction or equipment
failure.
When powering up: Turn on the power to your guitar amp last.
When powering down: Turn oî the power to your guitar amp îrst.
Use of Battery
5 A battery was installed in the unit before it left the factory. The life
of this battery may be limited, however, since its primary purpose
was to enable testing.
5 If you handle batteries improperly, you risk explosion and îuid
leakage. Make sure that you carefully observe all of the items
related to batteries that are listed in âUSING THE UNIT SAFELYâ and
âIMPORTANT NOTESâ (supplied on a separate sheet).
5 When operating on battery power only, the unitâs indicator will
become dim when battery power gets too low. Replace the
battery as soon as possible.
5 Batteries should always be installed or replaced before connecting
any other devices. This way, you can prevent malfunction and
damage.
Speciîcations
Nominal Input Level -20 dBu
Input Impedance 1 MΩ
Nominal Output
Level -20 dBu
Output Impedance 1 kΩ
Recommended Load
Impedance 10 kΩ or greater
Power Supply Alkaline battery (9 V, 6LR61) or
Carbon-zinc battery (9 V, 6F22)
AC adaptor (PSA series: sold separately)
Current Draw 25 mA
* Expected battery life under continuous use:
Alkaline: 32 hours
Carbon: 18 hours
These îgures will vary depending on the
actual conditions of use.
Dimensions 73 (W) x 129 (D) x 59 (H) mm
2-7/8 (W) x 5-1/8 (D) x 2-3/8 (H) inches
Weight 450 g / 1lb (including battery)
Accessories Leaîet (âUSING THE UNIT SAFELY,â âIMPORTANT
NOTES,â and âInformationâ)
Alkaline battery (9 V, 6LR61)
Options
(sold separately) AC adaptor (PSA-series)
* 0 dBu = 0.775 Vrms
* This document explains the speciîcations of the product at the
time that the document was issued. For the latest information,
refer to the Roland website.
Thumbscrew
When this screw is loosened, the
pedal will open, allowing you to
change the battery.
* For instructions on changing
the battery, refer to âChanging
the Battery.â
AC Adaptor
(PSA series; sold separately)
Electric Guitar
English
7This is a âWAZA CRAFT seriesâ eîect unit featuring analog circuitry designed with attention to every detail in pursuit of the înest sound.
7Standard mode completely replicates the sound of the CE-2 chorus, known for its mild modulation.
7In addition, this unit provides a CE-1 mode (chorus, vibrato) which reproduces the sound of the worldâs îrst chorus unit, the CE-1.
Main Features
INPUT jack
This jack accepts signals coming from
a guitar or other musical instrument, or
another eîects unit.
* The INPUT jack doubles as the power switch. Power
to the unit is turned on when you plug into the
INPUT jack; the power is turned oî when the cable
is unplugged. To prevent unnecessary battery
consumption, be sure to disconnect the plug from the
INPUT jack when not using the eîects unit.
Panel Descriptions
DC IN jack
Accepts connection of an AC Adaptor (PSA series; sold separately). By using an AC Adaptor, you can play
without being concerned about how much battery power you have left.
* Use only the speciîed AC adaptor (PSA series; sold separately), and connect it to an AC outlet of the
correct voltage. Do not use any other AC adaptor, since this may cause malfunction.
* If the AC adaptor is connected while a battery is installed, the power
supply is drawn from the AC adaptor.
* We recommend that you keep batteries installed in the unit even
though youâll be powering it with the AC adaptor. That way, youâll be
able to continue a performance even if the cord of the AC adaptor gets
accidentally disconnected from the unit.
CHECK indicator
This indicator shows whether the eîect is on or oî, and also doubles as the battery check
indicator. The indicator lights when the eîect is on.
* If youâre powering the unit with a battery and the CHECK indicator goes dimâ or doesnât
light at allâwhen you try to turn the eîect on, the battery is near depletion and should be
replaced. For instructions on changing the battery, refer to âChanging the Battery.â
Pedal switch
This switch turns the eîect on/oî.
OUTPUT B jack
Use this jack for stereo output.
The stereo output produced by this output in
conjunction with the chorus sound from the
OUTPUT A (MONO) jack provides a spacious
chorus eîect.
Only the direct sound is output from the
OUTPUT B jack.
OUTPUT A (MONO) jack
The direct sound and chorus sound are
mixed and output from this jack.
If you use the OUTPUT B jack for stereo
output, this jack outputs only the chorus
sound.
© 2016 Roland Corporation 02
Guitar Ampliîer
Guitar Ampliîer
OUTPUT jacks
Mono output
Chorus sound + Direct sound
Stereo output
Direct soundChorus sound
Changing the Battery
1. Hold down the pedal and loosen the thumbscrew, then
open the pedal upward.
* The pedal can be opened without detaching the thumbscrew
completely.
Thumbscrew
Battery Housing
Pedal
Spring Base
Coil Spring
Guide Bush
Hole
Battery Snap
Cord
Battery
Snap
9 V Battery
2. Remove the old battery from the battery housing, and
remove the snap cord connected to it.
3. Connect the snap cord to the new battery, and place
the battery inside the battery housing.
* Be sure to carefully observe the batteryâs polarity (+ versus -).
4. Slip the coil spring onto the spring base on the back of
the pedal, and then close the pedal.
* Carefully avoid getting the snap cord caught in the pedal, coil
spring, and battery housing.
5. Finally, insert the thumbscrew into the guide bush
hole and fasten it securely.
Product specificaties
| Merk: | Boss |
| Categorie: | Gitaarversterker |
| Model: | Chorus CE-2W |
Heb je hulp nodig?
Als je hulp nodig hebt met Boss Chorus CE-2W stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Gitaarversterker Boss
30 November 2024
30 November 2024
30 November 2024
30 November 2024
30 November 2024
30 November 2024
30 November 2024
30 November 2024
30 November 2024
30 November 2024
Handleiding Gitaarversterker
- Gitaarversterker Yamaha
- Gitaarversterker Ampeg
- Gitaarversterker Behringer
- Gitaarversterker Fender
- Gitaarversterker Hartke
- Gitaarversterker Line 6
- Gitaarversterker Marshall
- Gitaarversterker Peavey
- Gitaarversterker Roland
- Gitaarversterker Orange
- Gitaarversterker Vox
- Gitaarversterker Harley Benton
- Gitaarversterker ART
- Gitaarversterker Valeton
- Gitaarversterker TC Electronic
- Gitaarversterker Radial Engineering
- Gitaarversterker Mooer
- Gitaarversterker Blackstar
- Gitaarversterker Electro Harmonix
- Gitaarversterker Markbass
- Gitaarversterker SPL
- Gitaarversterker Hughes & Kettner
- Gitaarversterker Laney
- Gitaarversterker Ashdown Engineering
- Gitaarversterker Bugera
- Gitaarversterker Palmer
- Gitaarversterker Empress Effects
- Gitaarversterker Dimavery
- Gitaarversterker Fishman
- Gitaarversterker AER
- Gitaarversterker EBS
- Gitaarversterker Rivera
- Gitaarversterker Suhr
- Gitaarversterker Two Notes
- Gitaarversterker GR Bass
- Gitaarversterker Voodoo Lab
- Gitaarversterker AMT
- Gitaarversterker DACS Audio
- Gitaarversterker DV Mark
- Gitaarversterker Budda
- Gitaarversterker API Audio
Nieuwste handleidingen voor Gitaarversterker
30 November 2024
29 November 2024
20 November 2024
20 November 2024
18 November 2024
18 November 2024
16 November 2024
16 November 2024
16 November 2024
15 November 2024