BEKO Gemini Handleiding

BEKO Niet gecategoriseerd Gemini

Lees hieronder de 📖 handleiding in het Nederlandse voor BEKO Gemini (2 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 202 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/2

gemini

Instructions

1.1

Snap the

side wings

to the snaps

in the center

to make

the base

NARROW or

to the snaps

on the sup-

port belt

to make the

base WIDE.

1FRONT CARRY FACING IN POSITION (7 LBS | 3.5 KG +)

For newborns and small babies from 7 – 15lbs, use the .NARROW BASE

From 15lbs+, use the .WIDE BASE

1.2

Place the

support belt

around your

waist or hips

with the

outside of

the carrier

facing your

legs.

1.3

Fasten

buckle

and adjust

support

belt tightly

around

your body.

Support belt

should be

level and

parallel to

the ﬂoor.

1.4

Place baby

in the carrier

facing in.

Hold her

with one

arm.

1.5

With the

other arm,

bring the car-

rier between

baby’s legs

and over

baby’s body.

Place the

shoulder

strap

over your

shoulder.

1.6

Switch

arms and

reach behind

you for

the buckle

end of the

shoulder

strap.

1.7

Holding baby

with your

forearm, use

both hands

to fasten

the shoulder

strap buckle

to the buckle

on the

side of the

carrier.*

1.8

For young

babies who

need neck

/ head sup-

port, unsnap

the headrest

and fasten

it using the

hooks onto

the D-rings

on the shoul-

der straps.

1.9

Final

position with

headrest

UP WIDE&

BASE.

1.10

Final

position

with head-

rest snapped

DOWN &

NARROW

BASE.

2.1

Snap the

side wings

to the snaps

in the center

to make

the base

ARROW.

2FRONT CARRY FACING out POSITION

child must face towards you until

he/she can hold head upright! (3 – 4 months)

2.2

Place the

support belt

around your

waist or hips

with the out-

side of the

carrier facing

your legs.

You may pre-

fer the sup-

port belt on

your waist or

on your hips.

2.3

Fasten

buckle

and adjust

support

belt tightly

around

your body.

Support belt

should be

level and

parallel

to ﬂoor.

2.4

Place baby

in the carrier

facing out.

Hold her

with one

arm.

2.5

With the

other arm,

bring the

carrier

between

baby’s legs

and over

baby’s body.

Place the

shoulder

strap

over your

shoulder.

2.6

Switch arms

and reach

behind

you for the

buckle end

of the shoul-

der strap.

2.7

Holding baby

with your

forearm, use

both hands

to fasten

the shoulder

strap buckle

to the buckle

on the

side of the

carrier. *

100%

organic

cotton

2.8

Rotate baby’s

hips forward

slightly

so that she

is sitting on

her rear end.

Final position

with head-

rest snapped

DOWN &

NARROW

BASE.

front + back carrier 7 — 35 lbs | 3.5 — 16 kg

WARNINGS – FALL HAZARD!

KEEP AWAY FROM FIRE!

Read all instructions before using the

GEMINI .Baby Carrier Keep instructions for

future use. Check to ensure all buckles, snaps,

and adjustments are secure before each use.

Small babies can fall through a leg opening

that is too big. Follow all instructions for use

and always ensure you are holding onto baby

with at least one arm while you are putting

baby into or taking baby out of the carrier.

Only use this carrier for children between 7 lbs

and 35 lbs (3.5 kg – 16kg). Your balance may

be adversely aﬀected by your movements and

those of your baby. Take care when bending

or leaning forward. Be careful when opening

doors or turning corners not to bang your

baby. This carrier is not suitable for use during

sport activities.

care INSTRUCTIONS

Machine wash with mild detergent on gentle

cycle. Air dry. Do not wash frequently. Do not

use bleach. Spot clean as needed.

WARRANTY

Beco Baby Carrier warrants this product

against defects in material and workmanship.

We stand behind our products and will either

repair or replace for free any genuine Beco

Baby Carrier purchased from an authorized

retailer for one year from date of purchase.

Proof of purchase required.



IMPORTANT! KEEP FOR

FUTURE REFERENCE

beco baby

1630 SUPERIOR AVE. ste d

COSTA MESA, CA 92627

www.becobabycarrier.com

T 1.888.943.8232 F 949.642.1216

info@becobabycarrier.com

made in usa

carrier®

* Pull on the shoulder adjuster webbing end to tighten snugly. Switch arms, and repeat steps 6 & 7 with the other shoulder strap.

BECO PRESS 2011 copy_MANUAL GEMINI 9/8/11 9:25 PM Stránka 1

BECO TIP = USE ELASTIC

LOOPS TO SHORTEN

DANGLING WEBBING STRAPS

The webbing straps on your shoulder straps and

support belt each have an elastic loop at the end.

If you have excess webbing length when your

GEMINI is fully adjusted, roll up the ends of your

webbing straps to shorten them to your desired

length and use the elastic loops to secure the

rolled-up webbing.

ERGONOMIC EFFECTS

OF CHANGING THE WIDTH

OF THE BASE:

The innovative design feature that enables you to

change the width of the Gemini’s base makes a world

of diﬀerence in how baby’s weight is distributed over

your body as well as how baby herself is supported.

While small infants will enjoy plenty of support with

the base, older babies (15 lbs+) should NARROW

ride with the base open . The wide base willWIDE

support the growing baby in an ergonomically proper

position with her knees as high as her rear end. No-

tice in ﬁg. 1.9 how baby’s legs are spread wide around

the parent’s body. This position, with baby’s weight

supported along her entire rear end and upper

thighs, is proper ergonomic positioning. Fig. 1.10

shows the same baby with the base: NARROW

notice how her legs are dangling slightly down.

When you see your own baby’s legs assume this

slightly dangling position, your baby has outgrown

the base and needs to start being carriedNARROW

with the base open . You will also notice WIDE

a major increase in comfort for yourself with the

WIDE base. That’s because baby’s weight is being

distributed better across your lower body and torso.

ACHIEVING MINIMUM SIZE

LEG OPENING:

Small babies can fall through a leg opening if the

carrier is too loose. Make sure to tighten the shoul-

der straps enough so baby is held snugly against

your torso and does not feel too loose in the carrier.

Baby should be at approximately the same position

she would be if held in your arms against your chest.

See ﬁg. in 1.7 FRONT CARRY FACING IN POSITION

and ﬁg. 2.7 FRONT CARRY FACING OUT POSITION.

Babies love to suck on various parts of the baby

carrier, especially when they are teething. We recom-

mend using BECO DROOLING PADS on the shoulder

straps to help keep the straps clean. While there

may be some color bleeding initially, this will dimin-

ish aer the carrier’s ﬁrst washing in cold water.

Both the fabric and the fabric dyes of the GEMINI

are rigorously tested and are safe for babies.

The fabric is 100% Organic cotton, and all dyes

are water based.

NOTES ABOUT

FACING OUT POSITION:

Use the NARROW BASE for this position as it is

more comfortable for you and baby. While many

babies enjoy the facing out position once they have

developed good head and neck control, pay attention

to your baby’s cues to and turn her around to face

you if she is becoming overstimulated. Young babies

need lots of eye contact and communication with

their caregivers, so it is better to avoid prolonged

use of the forward facing out position. Also, start

using the hip carry position and back carry position

when baby is big enough so that baby does not get

used to only one carrying position. The more ﬂexible

baby is, the more carrying options you will have!

REGARDLESS OF THE

POSITION, ALWAYS MAKE

SURE BABY HAS A CLEAR

AIRWAY TO BREATHE!

HOW TO OPEN

THE Tri-LOCK BUCKLES

The Baby Carrier is equipped GEMINI

with very secure tri-lock buckles. Once

properly fastened, these buckles will not

open accidentally. There is a 2” tri-lock buckle

on the support belt and two 1” tri-lock buckles

at the top where the carrier harness attaches

to the shoulder straps.

to open:

Squeeze the sides of the buckle with one

hand and push the button on buckle’s top

with your other hand. Pull the buckle

parts apart.

to close:

Line up the parts of the buckle and slide

them together until you hear a solid “click.”

Pull gently on the buckle parts to ensure

they are properly aligned and engaged.

Always listen for that click!

3.1

Snap the

side wings to

the snaps on

the support

belt to make

the base

WIDE.

HIP CARRY POSITION

ONLY FOR BABIES WITH FULL HEAD/NECK CONTROL!

(4+ months) Use the .WIDE BASE

3.2

Place the

carrier

around your

hips with the

carrier’s seat

above your

hip or

slightly in

front of it.*

3.3

Place baby

in the carrier.

Support her

with your

arms.

3.4

Bring the

carrier

between

baby’s legs

and over

her body.

Hold baby

with the

arm on the

side she is

sitting on. **

3.5

Switch

arms and

reach behind

you for

the buckle

end of the

shoulder

strap with

the arm on

the side she

is sitting on.

3.6

Holding baby

with your

forearm on

the opposite

arm, use

both hands

to fasten the

shoulder

strap buckle

to the buckle

on the side

of the carrier.

3.7

Run the

other shoul-

der strap

UNDER

your arm

as shown

and place it

OVER your

opposite

shoulder.

3.8

Switching

arms holding

baby, hold

her with your

forearm and

use your

hands to fas-

ten the shoul-

der strap

buckle to the

buckle on the

side of the

carrier. ***

3.9

The shoulder

straps will

rest one on

top of the

other over

your shoul-

der. Pull on

both straps

at once

and position

them on your

shoulder, not

on your neck.

3.10

Final position.

Note how the

WIDE BASE

supports

baby’s legs.

Smaller

babies can

also ride with

their arms

tucked in.

* Fasten buckle and adjust support belt tightly around your body. Support belt should be level and parallel to ﬂoor. ** With your other arm, place front shoulder strap over your shoulder.

*** Pull on the shoulder adjuster webbing end to tighten snugly.

4.1

Snap the

side wings to

the snaps on

the support

belt to make

the base

WIDE.

4BACK CARRY POSITON ONLY FOR BABIES

WITH FULL HEAD/NECK CONTROL!

(6+ months) Use the .WIDE BASE