Bebob V240micro Handleiding

Bebob Niet gecategoriseerd V240micro

Lees hieronder de 📖 handleiding in het Nederlandse voor Bebob V240micro (5 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 3 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/5

bebob factory GmbH Höglwörtherstr. 350 D-81379 München Tel.: +49 (0)89 8563 485-0 – – –

www.bebob.tv

March 2024

Features

 A high capacity micro V-Mount Li-Ion baery 14,4V / 16,5Ah // 238Wh

 Direct ng to a camera or plate via micro V- or V-Mount.

 Five-step LED Fuel Gauge (100% - 80% - 60% - 40% - 20% SoC State of Charge) ; –

 Full-charge capacity status LED

(green over 70%; yellow between 50% and 70%; red under 50% of new baery)

 Twist D-Tap (14,4V unreg.; max. 5A)

 USB- (5,0V; max. 1,0A) A

 200W connuous power drain

 16A max. discharge current

 Data communicaon (ARRI, RED, Sony, Blackmagic Design)

V240micro

Rechargeable Li-Ion Baery

USER MANUAL

WE STRONGLY RECOMMEND READING THIS

INSTRUCTION CAREFULLY BEFORE USING!

 FOR YOUR PERSONAL SAFETY, PLEASE

OBSERVE THE SAFETY INSTRUCTIONS

AND WARNINGS

 OBSERVE ALL COMMON AND LOCAL

SAFETY REGULATIONS

 PLEASE KEEP THIS MANUAL FOR

FUTURE REFERENCE

bebob factory GmbH Höglwörtherstr. 350 D-81379 München Tel.: +49 (0)89 8563 485-0 – – –

www.bebob.tv

March 2024

Safety instructions

 For professional use only!

 Operate only with recommended baeries!

 Charge only with recommended chargers!

 Risk of explosion when exposed to re or heat!

 Do not expose the baery to water!

 Do not cause short circuits between the baery`s terminals!

 Do not open or try to repair the device!

 Handle with care! Do not throw or drop the device!

 Do not operate in overhead or hanging applicaons!

 Do not expose to temperatures above 60°C (140°F) or below -20°C (-4°F)

 Do not overload the device (see Specicaons)!

 Do not supply more charging voltage than specied (see Specicaons)!

Storage

 The baery shall be stored within the specied temperature, humidity and state

of charge ranges (see specicaons).

 Storage ambient temperature range is (see specicaons)

 For long-term storage (longer than 4 weeks), the baery should have a charge

between 50% and 75%. The baery should be recharged every 4 weeks.

In storage, some self-discharge will occur. It is advised to fully recharge the

baery before reusing it.

Warranty

 The baery is covered by a 2-year uncondional warranty on all parts, except for

the cells.

 The cells are covered b a 1-year warranty at 70% of the original capacity.y

 If you have any addional quesons or warranty issues, please contact the

appropriate bebob distributor listed at www.bebob.tv .

Disposal

 Users are legally obliged to appropriate disposal of used baeries.

 Baeries must not be disposed of in household waste - see crossed-out dustbin

symbol on the baery label.

 You can return any baeries of our baery range (old and current models) to our

warehouse for free-of-charge disposal.

 If the baery is not completely discharged, precauons against a potenal short-

circuit must be taken.

bebob factory GmbH Höglwörtherstr. 350 D-81379 München Tel.: +49 (0)89 8563 485-0 – – –

www.bebob.tv

March 2024

Operaon

Charging

 Do not charge baeries unaended!

 Do not charge near ammable object

 Disconnect all external loads before the charging process

 Wait 30 minutes since the last discharge before charging

 The baery can be charged via any bebob B-Mount charger

(or equivalent charger using the CC-CV method)

 Do not supply more charging voltage than specied (see specicaons)!

 Charge me will depend on charging power and ambient temperature

 The opmal charging ambient temperature is (see specicaons).

 bebob baeries can be recharged with any amount of remaining charge.

 The gauge LEDs will indicate the state of charge during the charging process.

Camera Data Communicaon

 Blue leds: Arri/Sony Data Protocol

 Red leds: Red Data Protocol

 To switch between both status, press the Check

buon for 5s

Status led

 Status led lighng Green: Full Capacity over 70%

of New

 Status led lighng Yellow: Full Capacity between

50% and 70% of New

 Status led lighng Red: Full Capacity under 50%

of New

Flash Light

 To switch On/O press the Check Buon Twice

Product specificaties

Merk:	Bebob
Categorie:	Niet gecategoriseerd
Model:	V240micro

Heb je hulp nodig?

Als je hulp nodig hebt met Bebob V240micro stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Niet gecategoriseerd Bebob

Bebob AS2 Handleiding

10 December 2024

Bebob V240micro Handleiding

10 December 2024

Bebob VS8MICRO Handleiding

30 Juli 2024

Bebob AMM VENICE Handleiding

30 Juli 2024

Bebob A240MICRO Handleiding

29 Juli 2024

Bebob AS2MICRO Handleiding

29 Juli 2024

Bebob VS2MICRO Handleiding

29 Juli 2024

Bebob COCO-15V III Handleiding

23 Juni 2024

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Ufesa Versa BV4660 Handleiding

18 December 2024

NeoMounts DS70-250WH1 Handleiding

18 December 2024

NeoMounts DS70-250WH2 Handleiding

18 December 2024

NeoMounts ADS20-425BL1 Handleiding

18 December 2024

NeoMounts CPU-D050BLACK Handleiding

18 December 2024

NeoMounts DS60-425WH1 Handleiding

18 December 2024

Blackstar HT-1RH MK III Handleiding

18 December 2024

NeoMounts DS15-545BL1 Handleiding

18 December 2024

NeoMounts DS70-250SL2 Handleiding

18 December 2024

Bolin Technology Dante AV-H Decoder Handleiding

18 December 2024