BaByliss Super-X Metal 7700U Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor BaByliss Super-X Metal 7700U (12 pagina's) in de categorie Tondeuse. Deze handleiding was nuttig voor 21 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/12
SUPER-X METAL SERIES
CORDLESS HAIR CLIPPER
7700U
SAFETY CAUTIONS
• This appliance should only be used as described within this
instruction book. Please retain for reference.
IMPORTANT CHILD SAFETY
• ALWAYS keep out of the reach of children (during and after
use).
• This appliance should not be used, cleaned or maintained
by children.
• Always take extra care if used on children or near children.
• Do not use on very young children.
IMPORTANT SAFETY
WARNING! Do not use this appliance near bathtubs,
showers, basins or other vessels containing water.
• Do not immerse the appliance in water or other liquids.
• UK Only: . Do not use this appliance in the bathroom
• Outside the UK: If using the appliance in a bathroom, unplug
after use as the proximity of water can be dangerous even
if the appliance is switched off. For additional protection the
installation of a residual current device (RCD) with a rated
residual operating current not exceeding 30mA is advisable
in the electrical circuit supplying the bathroom. Ask your
installer for advice.
CAUTION: Keep the power cord and the appliance dry.
• Always inspect the appliance before use for noticeable signs
of damage. Do not use if damaged or if the appliance has
been dropped. In the event of damage contact the Conair
Customer Care Line (refer to ‘UK After Sales Service’ section
for further information).
• Do not use the appliance if the charging adaptor or lead
is damaged. In the event of damage, discontinue use
immediately. If the charging adaptor or lead is damaged, it
must be replaced by the manufacturer. Return the appliance
to the Customer Care Centre (refer to ‘UK After Sales Service’
section for further information). No repair must be attempted
by the consumer.
• Only use the attachments supplied with this appliance.
• WARNING! For the purposes of recharging the battery, only
use the detachable charging supply unit provided with this
appliance (CA92). This symbol indicates there is a
detachable power supply for means of charging.
• Do not leave the appliance unattended when switched on.
• Do not place the appliance on any surface whilst in operation.
• Special care is required when using the appliance close to
the ears, eyes and face.
• This appliance should not be used by adults whose reduced
physical, sensory or mental capabilities, or whose lack of
experience and knowledge, might cause a hazard, unless
they have been correctly instructed to understand the safe
use and hazards involved and are adequately supervised.
• This product contains a Lithium Ion rechargeable battery that
is not to be removed from the appliance for charging. The
batteries in this appliance are non-replaceable. Batteries
must be disposed of safely at the end of life. Please take
to a recycling centre for safe disposal.
• The supply terminals are not to be short circuited.
• For indoor, household, domestic use only.
• This product complies fully with all appropriate EU
and UK Legislation and the standards relevant to this
type and class of appliance. We are an ISO9001:2015
certied company that continually evaluates our Quality
Management System performance. If you have any
queries regarding product safety and compliance, please
contact the Conair Customer Care Line (refer to ‘UK After
Sales Service’ section).
INSTRUCTIONS FOR USE
IMPORTANT! Only use the adaptor and attachments supplied with
this appliance.
General
• Always inspect the appliance before use to ensure the clipper blades
are free from hair, debris etc.
• Use on clean, dry hair that has been combed until tangle-free.
Oiling Instructions
• For optimum cutting performance, it is highly recommended to oil the
blades after every use.
• When using the oil for the rst time, unscrew the cap and cut off the
very end of the plastic tube with a pair of scissors.
• Remove the blade guard and switch the appliance on.
• Holding the clipper at a 45 degree angle, gently squeeze the oil tube
and apply 2 drops directly onto the blades.
• Leave the unit on for a further few seconds to allow the oil to
thoroughly spread along the length of the blades.
• Switch off the unit and remove any excess oil by gently dabbing with
a cloth before using on hair.
Product specificaties
| Merk: | BaByliss |
| Categorie: | Tondeuse |
| Model: | Super-X Metal 7700U |
Heb je hulp nodig?
Als je hulp nodig hebt met BaByliss Super-X Metal 7700U stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Tondeuse BaByliss
5 November 2024
11 September 2024
11 September 2024
11 September 2024
11 September 2024
11 September 2024
11 September 2024
11 September 2024
11 September 2024
11 September 2024
Handleiding Tondeuse
- Tondeuse Braun
- Tondeuse Philips
- Tondeuse Panasonic
- Tondeuse Grundig
- Tondeuse Adler
- Tondeuse Afk
- Tondeuse Beper
- Tondeuse Bestron
- Tondeuse Blaupunkt
- Tondeuse Bomann
- Tondeuse G3 Ferrari
- Tondeuse Hitachi
- Tondeuse Logik
- Tondeuse Marquant
- Tondeuse Mesko
- Tondeuse MPM
- Tondeuse Princess
- Tondeuse Remington
- Tondeuse Rowenta
- Tondeuse Saturn
- Tondeuse Sencor
- Tondeuse Severin
- Tondeuse Silvercrest
- Tondeuse Taurus
- Tondeuse Team
- Tondeuse Termozeta
- Tondeuse Tristar
- Tondeuse Valera
- Tondeuse Wahl
- Tondeuse Zelmer
- Tondeuse Zoofari
- Tondeuse Jata
- Tondeuse OK
- Tondeuse Oster
- Tondeuse Becken
- Tondeuse Camry
- Tondeuse Clatronic
- Tondeuse Concept
- Tondeuse ECG
- Tondeuse First Austria
- Tondeuse Mellerware
- Tondeuse OBH Nordica
- Tondeuse Optimum
- Tondeuse Orbegozo
- Tondeuse Scarlett
- Tondeuse Sinbo
- Tondeuse Trisa
- Tondeuse Carmen
- Tondeuse King
- Tondeuse Ardes
- Tondeuse Conair
- Tondeuse Eldom
- Tondeuse Coline
- Tondeuse GA.MA
- Tondeuse Moser
- Tondeuse Aurora
- Tondeuse Cecotec
- Tondeuse Shav
Nieuwste handleidingen voor Tondeuse
30 November 2024
23 November 2024
23 November 2024
23 November 2024
23 November 2024
23 November 2024
23 November 2024
23 November 2024
23 November 2024
23 November 2024