Audiovox XM Direct2 Handleiding

Audiovox Kabels voor pc's en randapparatuur XM Direct2

Lees hieronder de 📖 handleiding in het Nederlandse voor Audiovox XM Direct2 (14 pagina's) in de categorie Kabels voor pc's en randapparatuur. Deze handleiding was nuttig voor 36 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/14

Interface CableInterface Cable

Interface Cable

Installation GuideInstallation Guide

Installation Guide

Step 1:

Remove the head unit from your dashboard.

Important: Depending on how your head unit was installed you may have to remove

part or all of your dash board before the head unit can be pulled out. You may also have

to remove screws to complete this step.

Note: Before proceeding, make sure that the PIA Adapter has been pro-

grammed. Refer to the PIA Installation Manual. Professional installation

is recommended.

Step 2:

Connect the 34-pin cable connector to the Programmable Interface Adapter (PIA) mating

connector as shown in Figure 1. Slide the rubber strain relief onto the PIA case. Attach the

Car Dock USB connector into the USB receptacle on the PIA. Make sure the connectors are

secure, and slide the top cover onto the bottom housing. (Refer to Figure 2.)

InstallationInstallation

Installation

Figure 1. PIA Cable Interface

Antenna

Pass-Through

Connector

Note: Make sure all cables

are securely connected.

Mating

Connector

To Head Unit

Mini-Tuner and

Car Dock

Ground Wire

Yellow Wire, 12V Battery

Yellow and

black wire are

optional based

on model.

Left/Right

Audio Cable

Fuse

Left/Right Audio

Cables (Model Specific)

Connector

Installation (Continued)Installation (Continued)Installation (Continued)Installation (Continued)Installation (Continued)

Figure 2. Typical Head Unit, Rear View

Note: The location of the connections on the head unit may vary depending on the

model.

Step 4:

Start your car and turn on your head unit to confirm that the XM Direct system is

properly connected. Please refer to your stereo owners manual on how to access XM

mode. When you tune to XM channel 1, you should see “XM Preview” on your head unit

LCD, and hear that channel through your car speakers. If not, check to make sure all

connections are correct or refer to the troubleshooting section of this installation guide.

Step 5:

Mount and secure the interface cable in a suitable location that will not interfere with

the radio and will not vibrate or rattle after installation.

Step 3:

Connect the end of the cable with the right angle DIN connector and audio cables to

the back of the head unit as shown in Figure 2. The shorter end of the cable coming

from the PIA is a pass-through cable that can be used to connect other products to your

head unit, i.e., CD changer.

Product specificaties

Merk:	Audiovox
Categorie:	Kabels voor pc's en randapparatuur
Model:	XM Direct2
Kleur van het product:	Black, Yellow
Aansluiting 1 type:	Mannelijk
Aansluiting 2 type:	Vrouwelijk