Atco Balmoral 17 SK Handleiding

Atco Grasmaaier Balmoral 17 SK

Lees hieronder de 📖 handleiding in het Nederlandse voor Atco Balmoral 17 SK (10 pagina's) in de categorie Grasmaaier. Deze handleiding was nuttig voor 41 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/10

STOP

1 2 3 5

Balmoral - Seite 3 Seite 1 Freitag, 1. Dezember 2006 11:39 11

Cylinder Mower Balmoral 14 SK Balmoral 17 SK Balmoral 20 SK

Part number 3 616 C07 ... 3 616 C08 ... 3 616 C09 ...

Engine size (cm

98 98 98

Fuel Tank capacity (l) 1.8 1.8 1.8

Rated power 2.2 kW (3.0 Hp) 2.2 kW (3.0 Hp) 2.2 kW (3.0 Hp)

Blade width (cm) 35 43 50

Height of cut (mm) 6

–

35 6

–

35 6

–

Cuts per metre 79 79 79

Grassbox capacity (l) 52 62 70

Weight (kg) 45 51 54

Max overall width (cm) 51 60 68

Serial Number See rating details on machine

This product is intended for domestic lawn

mowing.

This manual gives instructions on the correct as-

sembly and safe use of your machine. It is im-

portant that you read these instructions care-

fully.

When fully assembled the machine weighs ap-

proximately 45 kg – 54 kg. If necessary, obtain

assistance to remove from packaging.

Take care when transporting the mower to the

lawn, as the blades are sharp.

Carefully remove the machine from its packag-

ing and check that you have all the following

items:

– Lawnmower with handle assembly

– Operating instructions

– Machine registration card

– Engine maintenance manual

– Hexagonal wrench

– Grassbox

– Grassbox cradle

When parts are missing or damaged, please

contact your dealer.

Throttle lever

Red safety latch

Cutter control lever

Drive control lever

Handle top

Engine cut-off switch

Petrol filler cap

Petrol tank

Handle bottom

Grassbox

Choke lever

Carburettor

Recoil cord handle

Petrol tap

Serial No

Not all of the accessories illustrated or described are

included as standard delivery.

Handles

Unfold the handle top

and secure with wing

nut

. Make sure the cables do not become

trapped between the handles.

The handle top is height adjustable. The spin-

dle

can be repositioned in desired position

III

Use cable clips to attach cables to bottom han-

dle

and top handle

Product Specification

Intended Use

Introduction

Delivered Items

Operating Controls

Assembly

Balmoral - GB Seite 2 Freitag, 1. Dezember 2006 11:42 11

Petrol

Petrol deteriorates over time. Engine starting

may be difficult if you use petrol kept for more

than 30 days. Always run the fuel tank dry when

storing over 30 days.

1. Remove the petrol filler cap

, slowly add un-

leaded petrol to the tank

, fill to approx.

halfway up the fuel strainer.

2. Replace the petrol filler cap

3. Wipe up any spilt petrol from the engine be-

fore starting the mower.

Engine Oil

The mower is not supplied with oil in the engine,

however it is possible that there is a small quan-

tity in the engine. It is essential to fill with oil be-

fore starting the engine to avoid damage to

your engine. It is important to use the recom-

mended oil to avoid damage to your engine.

1. With the mower standing on level ground,

unscrew and remove the oil filler dip stick

2. Wipe the oil filler dip stick

clean; insert the

oil filler dip stick

, then remove it again. Do

not screw it in. Check the oil level.

3. Add a good-quality SAE 30 API SF in small

quantities at a time, allowing it to settle. Re-

peatedly add oil and check the level until it

reaches the max. position dip stick

. The

engine may require up to 0.4 litres of oil.

4. Refit the oil fill dip stick

Grassbox/bag

Attach/remove the grassbox

as shown.

Height of Cut Adjustment

Your mower has an infinitely adjustable height

of cut between 6 - 35 mm with four markings

between these (numbered 1 - 4) as a guide to

adjustment. A fifth position labelled „S“ should

only be used with the scarifier cassette acces-

sory or to achieve a particularly short cut if the

lawn is very flat. The height of cut is adjusted by

turning the knob

at the right hand rear of the

machine. The comb will also require adjust-

ment, see „Comb Adjustment“.

Comb Adjustment

Your mower is fitted with an adjustable comb

which can be brought into use on the lower

heights of cut. The comb is set by loosening the

screws

and rotating the comb until the tines

just touch the ground. You may need to re-ad-

just after changing the height of cut. Take care

not to set the comb too deep, as this could

cause damage to either your mower or lawn.

Cutting Long Grass Using Side Wheel Kit (ap-

propriate models only)

Your mower is fitted with a full width front roller

which is suitable for normal smooth lawns. For

cutting longer, coarse grass a side wheel kit can

be fitted.

To fit this kit proceed as follows:

1. Tilt the mower back and wedge securely.

2. Remove the front roller/comb assembly by re-

moving bolt

and removing screw

on both

sides.

3. Fit the side wheel

, on to the side wheels

spindle

4. Fit each side wheel assembly on both sides of

the roller brackets as shown and fix with bolt

Refit the full width roller by following steps 1-4 in

reverse.

Starting and Stopping

Starting from Cold

1. Move the throttle lever

to position .

2. Move the engine cut-off switch

to „

“.

3. Turn the petrol tap

„On“.

4. Move the choke lever

to .

5. Pull the recoil cord handle

. Allow the recoil

handle to return slowly after each pull.

6. Gradually turn the choke lever

to .

Starting from Hot

Follow “Starting from Cold” using steps 1,3 & 5

only.

If the engine does not start or will not continue

to run, follow the “Starting from Cold” proce-

dure with choke

lever between the

and position.

Stopping

1. Move the throttle lever

to position .

2. Move the engine cut-off switch

to „0“.

3. Turn the petrol tap

„Off“.

Engaging cylinder cutter and rear roller

1. Start engine.

2. Push the red safety latch

forward and grad-

ually squeeze the cutter control lever

to-

wards the top handle

3. Gradually squeeze the drive control lever

towards the top handle

4. Release the safety button

5. Adjust the speed as required by moving the

throttle lever

between and .

6. To stop, release both control levers

and

Using Your mower

Balmoral - GB Seite 3 Freitag, 1. Dezember 2006 11:42 11

Product specificaties

Merk:	Atco
Categorie:	Grasmaaier
Model:	Balmoral 17 SK
Kleur van het product:	Black, Green
Gewicht:	51000 g
Breedte:	600 mm
Soort:	Duwgrasmaaier
Stroombron:	Benzine
Vermogen:	2200 W
Draadloos:	Ja
Maaibreedte:	430 mm
Minimale maaihoogte:	6 mm
Maximale maaihoogte:	35 mm
Maaimethode:	Cilinderbladen
Capaciteit brandstoftank:	1.8 l
Cilinderinhoud:	98 cm³
Aanbevolen gazongrootte:	- m²
Grasvangbak:	Ja
Inhoud opvangbak:	62 l
Snij-hoogte:	6 - 35 mm