Apc SUA028RM Handleiding

Apc UPS SUA028RM

Lees hieronder de 📖 handleiding in het Nederlandse voor Apc SUA028RM (3 pagina's) in de categorie UPS. Deze handleiding was nuttig voor 16 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/3
990-7028D, 9/2003
A R P CCESSORY ECEPTACLE LATE
Entire contents copyright © 2003 by American Power Conversion Corporation. All rights reserved. Reproduction in whole
or in part without permission is prohibited. APC, Smart-UPS, and PowerChute are registered trademarks of American Power Conversion
Corporation. All other trademarks are the property of their respective owners.
Safety
Qualified service personnel must perform installation.
Ensure that the UPS is off and disconnected from utility power. The exposed electrical terminals will be energized if
the UPS is on or connected to utility power during the following procedure.
Installation
Note: Illustrations in this document may differ slightly from the actual hardware.
1. Unpack and inspect the accessory receptacle plate. Notify the carrier and dealer if there is damage. Recycle the
packaging or dispose of it properly.
2. Prepare the UPS for installation. Shut down and unplug all connected loads.
3. Turn off the UPS. Disconnect the UPS from utility power.
4. Unscrew the receptacle plate at the rear of the UPS. See figures below.
5. Pull the plate out gently so that the in-line connectors are accessible.
6. Press the locking tabs on the sides of the connectors and pull the connectors apart. Do not pull on the wires. Set aside the
old plate.
7. Align the new receptacle plate behind the UPS.
8. Match the corresponding connectors and snap together. See figures below.
9. Replace the receptacle plate and screws. See figures below.
10. Connect the UPS to utility power. Connect the loads. Turn on the UPS.
Figure 1:
Tower UPS and plate
configuration
Figure 2:
5U rack-mount UPS and plate
configuration
Figure 3:
Alternate 2U/3U rack-mount UPS and plate
configuration


Product specificaties

Merk: Apc
Categorie: UPS
Model: SUA028RM
Kleur van het product: Beige
Gewicht: 920 g
Breedte: 178 mm
Diepte: 254 mm
Hoogte: 127 mm
Gewicht verpakking: 1360 g
Vormfactor: Tower
Afmetingen verpakking (BxDxH): 178 x 254 x 127 mm
Duurzaamheidscertificaten: RoHS
Uitgangsvermogen: - W
Frequentie: - Hz
Aantal AC uitgangen: 8 AC-uitgang(en)
Nominale input voltage: 120 V
Stopcontacttypes: NEMA 5–15R
Output power capacity: - kVA
Ingang operation voltage (min): - V
Ingang operation voltage (max): - V
Uitgang operation voltage (min): - V
Uitgang operation voltage (max): - V
Output-aansluitingen: L5-15R

Heb je hulp nodig?

Als je hulp nodig hebt met Apc SUA028RM stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding UPS Apc

Handleiding UPS

Nieuwste handleidingen voor UPS