Antennas Direct ClearStream Handleiding

Antennas Direct Tv-antenne ClearStream

Lees hieronder de 📖 handleiding in het Nederlandse voor Antennas Direct ClearStream (2 pagina's) in de categorie Tv-antenne. Deze handleiding was nuttig voor 48 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/2

1) Reflector with

Collapsible Dipole

and Loop Element Base

2) Loop Element

3) 3 ½” Bolt

4) Weather Boot (optional)

Required, not included: Coaxial Cable, Medium-sized Cross Point Screwdriver.

Thread coaxial cable A with the connected weather boot through

the VHF IN hole in the Loop Element base (1) and connect cable

to the VHF IN connector on back of the Loop Element (2).

Once connected, slide the weather boot over the connection.

Secure the Reflector with Collapsible Dipole, Loop Element

Base (1), and Loop Element (2) as shown using the 3 bolt.½

Position the Loop Element Base at the center of the Reflector

Assembly bar until holes are alligned.

Thread coaxial cable through the TO TV hole

in the Loop Element Base (1) and connect the

cable to the TO TV connector on the back of

the Loop Element (2).

©Antennas Direct 2012 06/12 C2-V

Connect opposite end of coaxial cable to your TV or receiver.

Locate your TV Station transmission towers by going to

antennapoint.com and search on your address or zip code.

Point antenna in the direction of the transmission towers

closest to you and check reception by scanning for channels.

If reception is not as desired, move antenna and rescan.

Please call our Helpline for additional information.

Product specificaties

Merk:	Antennas Direct
Categorie:	Tv-antenne
Model:	ClearStream
Impedantie:	75 Ohm
Ondersteunde frequentiebanden:	UHF, VHF
Ontvangstbereik (UHF):	470 - 806 MHz
Ontvangstbereik (VHF):	174 - 216 MHz
Ontvangstbereik (VHF-kanaal):	7 - 13
Ontvangstbereik (UHF-kanaal):	14 - 69