American Standard Colony Pro 7075.205.002 Handleiding

American Standard Kraan Colony Pro 7075.205.002

Lees hieronder de 📖 handleiding in het Nederlandse voor American Standard Colony Pro 7075.205.002 (3 pagina's) in de categorie Kraan. Deze handleiding was nuttig voor 9 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/3
- 1 -
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2016
Thank you for selecting American Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly-please read
these instructions carefully before you begin.
RECOMMENDED TOOLS
1
2
3 3a
M965761 (8/16)
INSTALL FAUCET
SECURE FAUCET AND MAKE WATER SUPPLY CONNECTIONS
INSTALL POP-UP DRAIN
COLONY® PRO
CENTERSET
LAVATORY FAUCET
INSTALLATION
INSTRUCTIONS
7075.200
7075.202
7075.205
Phillips ScrewdriverPlumbers’ Putty or CaulkingAdjustable Wrench Hex Wrench (2 mm)Channel Locks
Certied to comply with ANSI A112.18.1M
CAUTION Turn off hot and cold water
supplies before begining.
Insert FAUCET and POP-UP CABLE (1) (2) through mounting
holes of Sink or Mounting Surface.
Secure FAUCET with ATTACHMENT NUTS (1) (2) supplied.
(HAND TIGHTEN).
Connect water supply to FAUCET with 1/2" IPS FLEXIBLE (1)
SUPPLIES or 3/8"O.D. BULL-NOSE RISERS . Use adjustable (3) (4)
wrench to tighten connections. Do not over tighten. Be careful
not to kink copper supply when bending. Use tubing cutter to
cut to proper length.
NOTE: FLEXIBLE SUPPLIES HAVE TO BE PURCHASED SEPARATELY
Apply a bead of putty to
underside of FLANGE (1).
Drop FLANGE into LAVATORY (1)
DRAIN . From below assemble (2)
RUBBER GASKET , METAL (3)
WASHER and LOCK NUT(4) (5).
Do not tighten.
1
2
4
3
1
FERRULE
COUPLING NUT
11
3
4
2
5
- 2 -
3b 3c
3
4
Remove AERATOR. With handles in OFF position, turn on water supplies and check all connections for leaks.
• Operate both handles to ush water lines thoroughly. Operate LIFT ROD and check DRAIN for leaks. Replace AERATOR.
If Faucet Drips Proceed As Follows:
• Turn HANDLES in OFF position.
If spout drips, operate HANDLES several times from OFF to ON position. Do not forc HANDLES they turn only 90˚.
AERATOR may accumulate dirt causing distorted and reduced water ow. Remove AERATOR and rinse clean.
To Change Handle Position:
Remove INDEX BUTTON , HANDLE SCREW and HANDLE(1) (2) (3).
• Remove ADAPTER & RETAINING O-RING (4) (5).
• Lift and turn STOP WASHER 90˚.(6)
Replace RETAINING O-RING (5)
& ADAPTER (4).
Replace HANDLE (3).
TEST INSTALLED FAUCET
SERVICE
M965761 (8/16)
3
2
1
5
4
6
5
8
7
3
2
4
1
90°
90°
5
6
Aerator
1
2
3
4
Place SEAL (1) with small end facing up into
TAILPIECE and tighten against DRAIN (2)
BODY . PIVOT ROD (4) (3) opening in
TAILPIECE (2) should face the rear of the
lavatory. Tighten LOCK NUT (5) with
channel locks. Do not over tighten.
Assemble PIVOT ROD , PIVOT NUT and SEAL(1) (2) (3). CLIP (4)
as shown. Hand tighten PIVOT NUT Drop STOPPER (2) (5)
into drain.(For vandal proof drain rotate stopper so PIVOT
ROD goes through EYE of STOPPER (1) (6) (5). Make
connection to “P” TRAP.)
Remove one end of CLIP from PIVOT ROD (3) (1) by squeezing
ends together while sliding.
Insert PIVOT ROD into second or third hole in EXTENSION(1) (7)
and reassemble CLIP may need to be bent). (3) (7) . (EXTENSION
Adjust STOPPER (5) height by repositioning EXTENSION (7)
andtightening THUMBSCREW (8).
- 3 -
M965761 (8/16)
COLONY® PRO
CENTERSET
LAVATORY FAUCET
MODEL NUMBERS
Replace the “YYY” with
appropriate finish code
POLISHED CHROME 002
LEGACY BRONZE 278
SATIN NICKEL 295
HOT LINE FOR HELP
For toll-free information and answers to your questions, call:
1 (800) 442-1902
Mon. - Fri. 8:00 a.m. to 8:00 p.m. EST
Saturday 10:00 a.m. to 4:00 p.m. EST
IN CANADA 1-800-387-0369
(TORONTO 1-905-306-1093)
Weekdays 8:00 a.m. to 7:00 p.m. EST
IN MEXICO 01-800-839-1200
7075.200
7075.202
7075.205
M923840-0070A
AERATOR
M953450-YYY0A
(7075.200)
POP-UP DRAIN
ASSEMBLY
M953465-YYY0A
(7075.202)
POP-UP DRAIN
ASSEMBLY
065800-0070A
ATTACHMENT NUT
M964005-0070A
VALVE
M913332-0070A
BEARING WASHER
M964492-0070A
VALVE NUT
M970169-YYY0A
M970182-YYY0A
POP-UP KNOB & ROD
SET SCREW &
PLUG BUTTON
HOT/COLD
M970186-YYY0A
LEVER HANDLE KIT
M911107-0070A
ADAPTER


Product specificaties

Merk: American Standard
Categorie: Kraan
Model: Colony Pro 7075.205.002

Heb je hulp nodig?

Als je hulp nodig hebt met American Standard Colony Pro 7075.205.002 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Kraan American Standard

Handleiding Kraan

Nieuwste handleidingen voor Kraan