Aigostar 31HGA Handleiding

Aigostar Strijkijzer 31HGA

Lees hieronder de 📖 handleiding in het Nederlandse voor Aigostar 31HGA (29 pagina's) in de categorie Strijkijzer. Deze handleiding was nuttig voor 35 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/29

INSTRUCTIONS

MULTIFUNCTION

STEAM IRON

CODE 8433325500955

AC22

AC22AC220-240V

0-240V

0-240V0-240V 50/6

50/6

50/6 50/60Hz 2200W

0Hz 2200W

0Hz 2200W0Hz 2200W

～

～～

IMPORTANT SAFETY INSTRUCTIONS

When using your ﬂatiron, basic safety precautions should always be followed,

including the following:

READ ALL INSTRUCTIONS BEFORE USING

1. Use iron only for its intended use.

2. To protect against a risk of electric shock, do not immerse the iron in water or

other liquids.

3. The iron should always be turned to min , before plugging or unplugging from “ ”

outlet. Never yank cord to disconnect from outlet; instead, grasp plug and pull to

disconnect.

4. Do not allow cord to touch hot surfaces. Let iron cool completely before putting

away. Loop cord loosely around iron when storing.

5. Always disconnect iron from electrical outlet when ﬁlling with water or emptying

and when not in use.

6. Do not operate iron with a damaged cord or if the iron has been dropped or

damaged. To avoid the risk of electric shock, do not disassemble the iron. Take it

to a qualiﬁed serviceman for examination and repair. Incorrect reassembly can

cause a risk of electric shock when the iron is used.

7. Close supervision is necessary for any appliance being used by or near children.

Do not leave iron unattended while connected or on an ironing board.

8. Burns can occur from touching hot metal parts, hot water, or steam. Use caution

when you turn a steam iron upside down there may be hot water in the reservoir. –

9. If the malfunction indicator goes on, the ﬂatiron is not operating normally.

Disconnect from the power supply and have the ﬂatiron serviced by qualiﬁed

service personnel.

10. The iron must be used and rested on a stable surface.

11.The iron is not to be used if it has been dropped, if there are visible signs of

damage or if it is leaking.

12.This appliance is not intended for use by persons(including children)with

reduced physical ,sensory or mental capabilities ,or lack of experience and

knowledge, unless they have been given supervision or instruction concerning

use of the appliance by a person responsible for their safety .

13.Children should be supervised to ensure that they do not play with appliance.

14.The iron must not be left unattended while it is connected to the supply

mains;

15.The plug must be removed from the socked-outlet before the water reservoir

is ﬁlled with water;

16.When placing the iron on its stand, ensure that the surface on which the stand

is placed is stable;

17.The iron is not to be used if it has been dropped, if there are visible signs of

damage or if it is leaking.

18.If the supply cord is damaged ,it must be replaced by the manufacturer. its

service agent or similarly qualiﬁed persons in order to avoid a hazard.

SPECIAL INSTRUCTIONS

1. To avoid a circuit overload, do not operate another high wattage appliance on the

same circuit.

2. If an extension cord is absolutely necessary, a 10-ampere cord should be used.

Cords rated for less amperage may overheat. Care should be taken to arrange the

cord so that it cannot be pulled or tripped over.

SAVE THESE INSTRUCTIONS

More speciﬁcally:

DO NOT let children or untrained persons use the appliance without supervision.

NEVER immerse the iron, cable or plug in any liquid.

DO NOT leave the hot iron touching fabrics or very inﬂammable surfaces.

DO NOT leave the appliance unnecessarily plugged in. Disconnect the plug from

the mains when the appliance is not being used.

NEVER touch the appliance with wet or damp hands.

DO NOT use the power cord or the appliance in order to pull the plug out of the

socket.

DO NOT leave the appliance exposed to the weather (rain, sun, etc. ).

DO NOT leave the iron without supervision when it is connected to the power

supply.

DO NOT ﬁll the reservoir with water before removing the plug from the socket.

PLEASE NOTE!

Do not use chemical additive, scented substances or decalciﬁers. Failure to

comply with the above-mentioned regulations leads to the loss of guarantee.

D E S C R I P T I O N O F D E V I C E

1. soleplate 2.skirt 3.spray nozzle 4.tank cover

5.water cover 6. up cover 7.spray button 8.steam knob

9.burst button 10.cord protector 11. temperature knob 12. lamp

13.self clean button 14. Tank

G E N E R A L I N S T R U C T I O N S

When using the iron for the ﬁrst time, you may notice a slight emission of smoke

and hear some sounds made by the expanding plastics. This is quite normal and it

stops after a short time. We also recommend passing the iron over an ordinary cloth

before using it for the first time.

Suggestions before using the iron for the ﬁrst time

1. Certain parts of the iron have been lightly greased therefore the iron could

give off a little smoke when plugged in for the ﬁrst time. This will cease after a

short while.

2.Before using the iron for the ﬁrst time , remove the plastic protector from the

base (if it has one) clean the base with a soft cloth.

3. Keep the base very smooth. Do not run it over metal objects (such as against

the ironing board, buttons , zips ,etc.)

4. Pure wool ﬁbres (100% wool)can be ironed with the appliance in the steam

position .by preference ,select a high steam position and use a dry ironing cloth.

Selecting the temperature

1.Check the ironing instructions on the garment to be ironed.

2.If the garment does not have any ironing instructions but you know the kind of

fabric in question, use the chart below.

3. Fabrics that have some kind of ﬁnish(polishing . wrinkles , nco trasts….)can

be ironed at the lowest temperatures.

4.If the fabric contains several kinds of ﬁbres ,always select the temperature

applicable ,if an article contains 60% polyester and 40% cotton ,you must always

choose the temperature corresponding to polyester and without steam.

5. First classify the articles to be ironed according to the most suitable ironing

temperature : wool with wool, cotton with cotton, etc. as the iron heats up as fast

as it cools , start by ironing the articles requiring the lowest temperature such as

those made of synthetic ﬁbres . Progress towards those that require the highest

temperatures.

6.Turn the temperature control until it is in front of the appropriate signal

according to the following:

· position for nylon and acetate

·· position for wool ,silk or mixures

··· position for cotton or linen (steam).

How to ﬁll the water tank.

1.Unplug the iron.

1. Set the steam ruler to dry ironing .

2. Fill the tank through the ﬁlling hole.

3. If you have hard water ,it is advisable to use only distilled or demineralized

water.

-do not use chemically de-limed water or perfumed

4.Do not store the iron with water in the tank.

Steam ironing

1.Fill the iron as described in the section “how to ﬁll the water tank”.

2. Plug the iron into the mains.

3.Steam ironing is only possible when the highest temperatures shown on the

temperature control are selected .

Otherwise ,water may escape through the soleplate.

4. Wait until the pilot light goes out , which indicates that the selected

temperature has been reached.

5.Tu the steam button to the required position. rn

6.When the ironing is ﬁnished and during breaks in ironing , place the iron in its

upright position.

7.Disconnect the iron from the mains supply . Pour of any remaining water and

leave the iron to cool off.

Spray

1.The spray can be used in any position, either in dry or steam ironing, as long as

the water tank is ﬁlled with water.

2.Press the spray button for this function

NOTE : This button has to be pressed repetitively to start this function for the

ﬁrst time.

Shot of steam

Shot of steam give extra steam for removing persistent wrinkles.

1.Place the temperature selector at the “max”position and wait until the pilot

light goes out

2.Wait for a few seconds for the steam to penetrate the ﬁbre before pressing

again.

NOTE : For the best steam quality, do not use more than three successive

Product specificaties

Merk:	Aigostar
Categorie:	Strijkijzer
Model:	31HGA
Kleur van het product:	Blue, White
Breedte:	119 mm
Diepte:	286 mm
Hoogte:	140 mm
Snoerlengte:	2 m
Gewicht verpakking:	1030 g
Soort:	Droog- & stoomstrijkijzer
Vermogen:	2200 W
Capaciteit watertank:	0.32 l
Zelfreinigend:	Ja
Instelbare thermostaat:	Ja
Certificering:	CE, CB, GS, VDE
Duurzaamheidscertificaten:	RoHS
Maatbeker:	Ja
Continu stoom uitvoering:	35 g/min
Steam boost performance:	105 g/min
Stoomstoot functie:	Ja
Draadloos:	Nee
Ontworpen voor reizen:	Nee
Zichtbaar waterniveau:	Ja
AC-ingangsspanning:	220-240 V
AC-ingangsfrequentie:	50 - 60 Hz