ABB DY DCF77 Handleiding

ABB Niet gecategoriseerd DY DCF77

Lees hieronder de 📖 handleiding in het Nederlandse voor ABB DY DCF77 (1 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 27 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/1
REFERENCE STANDARDS
Compliance with Community Directives:
2014/53/EU (RED)
is declared with reference to the following harmonized standards:
• EN 60950-1
• ETSI EN 301 489-1, ETSI EN 301 489-3, ETSI EN 300 330
4
5
1User Manual
DCF MODULE FOR EXTERNAL USE
Read all the instructions carefully
DIMENSIONS (mm)
DEVICE STATUS
INSTALLATION
2
DY DCF77 is
a module that allows you to capture the information of data
and time. This information may be shared with ABB devices designed to
interface with
DY DCF77
, so as to ensure a synchronization always perfect.
Code Model Description
2CSM250411R1000
DY DCF77
DCF module for external use
SAFETY WARNINGS
During product installation and operation it is necessary to observe the
following instructions:
1) The product must be installed by a qualified person, in strict compliance
with the connection diagrams.
2) Do not power the instrument if any part of it is damaged.
3) The product must be installed and activated in compliance with current
electric system standards.
4) The electrical system in the building in which the product is to be installed
should have an over-current switch and a protection device.
5) Do not use the product for purposes different from the one specified.
6) In case of malfunction do not perform repairs and contact immediately the
technical support.
7) The product can be used in environments with category of overvoltage III
and pollution degree 2.
8) Before accessing the connection terminals, verify that the leads are not live.
9) After installation, inaccessibility to the connection terminals without
appropriate tools must be guaranteed.
TECHNICAL CHARACTERISTICS
• Power supply: 12V DC (-20% ÷ +20%)
• Absorption: 4 mA
• DCF frequency: 77.5 kHz
• Wall or pole installation
• Wiring
– Cable length: 100m
– Flexible cables section: 0.75 ÷ 1.5 mm
2
– Sheathed cables maximum diameter: 3 mm
• Protection degree: IP54
• Operating temperature: 0 ÷ +50 °C
• Storage temperature: -25÷ +70 °C
• Operating humidity: 20÷90% non condensing
• Key to force sending data to the connected devices
• Red / green / orange led for signaling device status (Figure 1)
Led for signaling
device status
Key to force sending data
to the devices
79
52
20
41
• Installation can be wall or pole (by using the adapter in the package)
• Remove the cover by leveraging the teeth on the sides of the product
• Pass the cables through the cable entry on the bottom side and connect the
power and bus cables respecting the wiring diagram
• Tighten the cable gland and replace the cover.
• When you power on the led emits two RED flashes as follows:
OFF ON OFF ON OFF
… 1 s 1 s 1 s …
After the power on sequence the DY DCF77 sends data and time to the I/O
extension port (then to the connected devices) every 30 minutes.
• The flashing of the GREEN led indicates the status of the device:
ON OFF
REPETITIONS
searching
for valid signal 500 ms 500 ms continuous
exact time acquired less
than 30 minutes 100 ms 100 ms 6 every 5 seconds
exact time acquired less
than 48 hours 100 ms 100 ms 3 every 5 seconds
• Sending data to the I/O extension port (and to the connected devices) is signaled
by the RED flashing of the led for 3 seconds as follows:
ON OFF ON OFF …..
100 ms 100 ms 100 ms 100 ms …..
Note: at any time you can force sending data to the I/O extension port by pressing
the key (accessible by removing the cover, see figure 2).
3CONNECTION DIAGRAMS
I/O extension
port
Figure 1 Figure 2
DY DCF77
2CSM441046D0201
ABB S.p.A
V.le dell’Industria 18
20010 Vittuone (MI) - Italy
Tel. +39 02 2415 0000
https://new.abb.com/low-voltage
© Copyright 2019 ABB S.P.A . All rights reserved.
We reserve the right to make technical changes or modify
the contents of this document without prior notice.
Installation Manual

Product specificaties

Merk: ABB
Categorie: Niet gecategoriseerd
Model: DY DCF77

Heb je hulp nodig?

Als je hulp nodig hebt met ABB DY DCF77 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Niet gecategoriseerd ABB

ABB

ABB US/U 12.2 Handleiding

27 Mei 2023
ABB

ABB DWTL1 Handleiding

26 Mei 2023
ABB

ABB D1 Plus 110 Handleiding

12 Mei 2023
ABB

ABB D1 Plus 24 Handleiding

7 Mei 2023
ABB

ABB D2 Plus Handleiding

23 April 2023
ABB

ABB System Pro M DT1 Handleiding

20 April 2023
ABB

ABB VAA/S6.230.2.1 Handleiding

19 April 2023
ABB

ABB AD1-R-15m-72 Handleiding

18 April 2023
ABB

ABB System Pro M DT2-K Handleiding

17 April 2023
ABB

ABB SA/S8.16.2.1 Handleiding

16 April 2023

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Panasonic

Panasonic NB-W250 Handleiding

25 November 2024
Alpine

Alpine CHM-S611 Handleiding

25 November 2024
AOpen

AOpen DE3650-C Handleiding

25 November 2024
Lazer

Lazer Urbanize MIPS Handleiding

25 November 2024
Symmons

Symmons Dia 353GB-24 Handleiding

25 November 2024
SoundTube

SoundTube IPD-RS62-EZ Handleiding

25 November 2024
Moen

Moen Camerist 4905 Handleiding

25 November 2024
Lazer

Lazer Cameleon DLX Handleiding

25 November 2024
DMT

DMT DLD-85 Handleiding

25 November 2024
AOpen

AOpen AM1120T Handleiding

25 November 2024