Zoom R16 Handleiding

Zoom Audiorecorder R16

Lees hieronder de 📖 handleiding in het Nederlandse voor Zoom R16 (100 pagina's) in de categorie Audiorecorder. Deze handleiding was nuttig voor 214 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/100

Reproduction of this manual, in whole or in part, by any means, is prohibited.

OPERATION MANUAL

Usage and safety precautions

In this manual, symbols are used to highlight warnings and

cautions for you to read so that accidents can be prevented.

The meanings of these symbols are as follows:

Please observe the following safety tips and precautions to ensure

hazard-free use of the R16.

Power requirements

Since power consumption of this unit is fairly high, we

recommend the use of an AC adapter whenever possible.

If you use batteries, use either alkaline or nickel-metal

hydride batteries.

AC adapter operation

• Be sure to use only a DC5V/1A/center plus AC adapter

(ZOOM AD-14). Use of an adapter other than that

speciﬁed could damage the unit and pose a safety hazard.

• Connect the AC adapter only to an AC outlet that

supplies the rated voltage required by the adapter.

When disconnecting the AC adapter from the AC outlet, •

always grasp the adapter itself and do not pull on the

cable.

• During lightning or when not using the unit for an

extended period, disconnect the AC adapter from the

AC outlet.

Battery operation

Use six conventional size AA-1.5 volt batteries.•

• The R16 cannot be used for recharging. Pay close

attention to the labeling of the batteries to make sure

you choose the correct ones.

When not using the unit for an extended period, remove •

the batteries from the unit.

• If battery leakage has occurred, wipe the batter y

compartment and the battery terminals carefully to remove

all remnants of battery ﬂuid.

• While using the unit, the battery compartment cover

should be closed.

About grounding

Depending on installation conditions, a slight electrical

charge may be felt when touching a metal part of the

R16. If you wish to avoid this, ground the unit by connecting

the ground screw on the rear panel to a good external

ground.

• To prevent the risk of accidents, never use any of the

following for grounding:

Water pipes (risk of electric shock)•

Gas pipe (risk of explosion) •

Telephone wiring ground or lightning arrestor •

(risk of lightning strike)

Environment

Avoid using your R16 where it will be exposed to:

Extreme temperature•

High humidity, moisture, or splashing water•

Excessive dust or sand•

Excessive vibration or shock•

Handling

Never place objects ﬁlled with liquids, such as vases, on

the R16 since this can cause electric shock.

The R16 is a precision instrument. Do not exert undue

pressure on the keys and other controls. Also take care

not to drop the unit, and do not subject it to shock or

excessive pressure.

Connecting cables and input and output jacks

You should always turn off the power to the R16 and all

other equipment before connecting or disconnecting

any cables. Also make sure to disconnect all connection

cables and the power cord before moving the R16.

Alterations

Never open the R16 case or attempt to modify the product

in any way since this can result in damage to the unit.

Volume

Do not use the R16 at a loud volume for a long time since

this could cause hearing impairment.

Electrical interference

For safety considerations, the R16 has been designed to provide

maximum protection against the emission of electromagnetic

radiation from inside the device, and protection from external

interference. However, equipment that is very susceptible to

interference or that emits powerful electromagnetic waves should

not be placed near the R16, as the possibility of interference

cannot be ruled out entirely.

With any type of digital control device, the R16 included,

electromagnetic interference could cause malfunction and could

corrupt or destroy data. Care should be taken to minimize the risk

of damage.

Cleaning

Use a soft, dry cloth to clean the R16. If necessar y, slightly

moisten the cloth. Do not use abrasive cleanser, wax, or solvents

(such as paint thinner or cleaning alcohol), since these may dull

the ﬁnish or damage the surface.

Back up

The data on the R16 could be lost because of malfunction or

incorrect operation. Back-up your data.

Copyrights

Exc ept f or person al u se, unau th orized r eco rding from

copyrighted so urces (CDs, records, tapes, video clips,

broadcast material and so on) is prohibited.

ZOOM Corporation does not bear any liability for injunctions

regarding copyright law infringement.

The SD symbol and SDHC symbol are trademarks.

Windows®/Windows Vista® are trademarks or registered

trademarks of Microsoft®. Macintosh® and Mac OS® are

trademarks or registered trademarks of Apple Inc. Steinberg and

Cubase are trademarks or registered trademarks of Steinberg Media

Technologies GmbH Inc. Intel® and Pentium® are trademarks or

registered trademarks of Intel® Corporation. AMD Athlon™ is a

trademark or registered trademark of Advanced Micro Devices, Inc.

All other trademarks, product names, and company names mentioned

in this documentation are the property of their respective owners. All

trademarks and registered trademarks mentioned in this manual are

for identication purposes only and are not intended to infringe on the

copyrighted properties of their respective owners.

This symbol indicates explanations about extremely

dangerous matters. If users ignore this symbol and

handle the device the wrong way, serious injury or

death could result.

This symbol indicates explanations about dangerous

matters. If users ignore this symbol and handle the

device the wrong way, bodily injury and damage to

the equipment could result.

SAFETY PRECAUTIONS

Usage Precautions

Introduction

Multitrack recorder that can use up to 32

GB SDHC cards

T h e R 1 6 c a n r e c o r d u p t o 8 t r a c k s

simultaneously. For example, recording a

full band on individual tracks or multiple

microphones placed around a drum kit. After

making linear PCM recordings (WAV type) at

16/24-bit and 44.1-kHz sampling rate, you can

transfer the recorded les to your computer to

make use of them in your DAW software. You

can even connect two R16s together with a

USB cable, allowing you to record a maximum

of 16 tracks.

Hi-Speed USB (USB 2.0) audio interface

You can use the R16 as a Hi-speed USB (USB

2.0) audio interface that has abundant input

and output jacks. The R16 can handle 8 inputs

and 2 outputs at a maximum of 24-bit and 96

kHz, and its effects can even be used at 44.1

kHz sampling rate. The unit can also operate

using only USB bus power.

Usable as a control surface for DAW software

The R16 is equipped with functions that enable

you to control DAW software in a computer via a

USB cable. You can operate the transport of the

DAW software, such as play, record and stop,

and you can physically control fader operations.

You can also assign various DAW functions to

the R16’s F1–F5 function keys. (The assignable

functions depend on the DAW software.)

Various effects

The R16 has 2 main built-in effects—an insert

effect that can be applied to specific channel

signals and a send-return effect that can be

used like the send-return bus of a mixer. You

can use these effect in a wide variety of ways,

including during recording, by applying them

to already recorded tracks, and in mastering

operations like mixing down and bouncing.

Handles various input sources including

g u i t a r s , m i c r o p h o n e s and lin e - l e v e l

equipment

The R16 is equipped with 8 input jacks that

accept both XLR and phone connectors,

including one that can handle high impedance

signals and two that can supply 48V phantom

power. The R16 can handle high impedance

guitars and basses, dynamic and condenser

mi cr op hon es , a nd v a r i o u s l i n e l e v e l

instruments like synthesizers. It also has

two built-in high performance microphones

that are v er y convenient for recordi ng

acoustic guitar and vocals.

Comprehensive built-in mixer features

The R16 is equipped with a digital mixer that

allows you to mix the playback of recorded

and imported audio tracks. You can adjust the

volume, pan, EQ and effects for each track

and mix them into a stereo output.

Multiple tuner modes and a metronome for

guide rhythms

The R16 not only has a standard chromatic

tuning function, it also has functions for

unusual tunings, including 7-string guitars and

5-string basses. The metronome can be used

as a guide rhythm while recording. You can

play the metronome sound through the mixer

OUTPUT jacks or you can send it only through

the headphones if you want. For example, in

a live situation you could send the click just to

the drummer via the headphone output.

Exchange files with computers and USB

memory devices

The R16 has a USB 2.0 jack that allows

high speed data transfer. You can transfer WAV

audio les recorded on the R16 to a computer

just by dragging and d r opping. You can

also exchange files with a connec ted USB

memory device without using a computer.

Thank you very much for purchasing the ZOOM R16 Recorder/Interface/Controller. In this manual, we will call

it the R16. The R16 has the following features.

Please read through this manual carefully in order to understand the R16 functions effectively.

After reading it, please keep the manual along with the warranty in a safe place.

*Specifications are subject to change for improvement without notice.

Product specificaties

Merk:	Zoom
Categorie:	Audiorecorder
Model:	R16
Kleur van het product:	Zilver
Gewicht:	1300 g
Breedte:	376 mm
Diepte:	237.1 mm
Hoogte:	52.2 mm
Sample rate:	96 kHz
Aantal kanalen:	10 kanalen
Digitaal geluid verwerken:	24 Bit
DJ mixer:	Nee
Maximum input level:	5 V