Yamaha YID-W10 Handleiding

Yamaha Ipod Audio YID-W10

Lees hieronder de 📖 handleiding in het Nederlandse voor Yamaha YID-W10 (12 pagina's) in de categorie Ipod Audio. Deze handleiding was nuttig voor 29 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/12

YID-W10

Wireless System for iPod

Système sans fil pour iPod

OWNER’S MANUAL

MODE D’EMPLOI

English

Français

1 En

FCC INFORMATION (for US customers)

1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!

This product, when installed as indicated in the instructions

contained in this manual, meets FCC requirements.

Modifications not expressly approved by Yamaha may

void your authority, granted by the FCC, to use the product.

2. IMPORTANT: When connecting this product to

accessories and/or another product use only high quality

shielded cables. Cable/s supplied with this product MUST

be used. Follow all installation instructions. Failure to

follow instructions could void your FCC authorization to

use this product in the USA.

3. NOTE: This product has been tested and found to comply

with the requirements listed in FCC Regulations, Part 15

for Class “B” digital devices. Compliance with these

requirements provides a reasonable level of assurance that

your use of this product in a residential environment will

not result in harmful interference with other electronic

devices.

This equipment generates/uses radio frequencies and, if not

installed and used according to the instructions found in the

users manual, may cause interference harmful to the

operation of other electronic devices.

Compliance with FCC regulations does not guarantee

that interference will not occur in all installations. If this

product is found to be the source of interference, which

can be determined by turning the unit “OFF” and “ON”,

please try to eliminate the problem by using one of the

following measures:

Relocate either this product or the device that is being

affected by the interference.

Utilize power outlets that are on different branch (circuit

breaker or fuse) circuits or install AC line filter/s.

In the case of radio or TV interference, relocate/reorient

the antenna. If the antenna lead-in is 300 ohm ribbon

lead, change the lead-in to coaxial type cable.

If these corrective measures do not produce satisfactory

results, please contact the local retailer authorized to

distribute this type of product. If you can not locate the

appropriate retailer, please contact Yamaha Electronics

Corp., USA 6660 Orangethorpe Ave., Buena Park, CA

90620.

The above statements apply ONLY to those products

distributed by Yamaha Corporation of America or its

subsidiaries.

This device complies with Part 15 of FCC Rules and RSS-Gen of IC Rules.

Operation is subject to the following two conditions:

1) this device may not cause interference, and

2) this device must accept any interference, including interference that may cause undesired operation of this device.

NOTICE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15

of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

– Reorient or relocate the receiving antenna

– Increase the separation between the equipment and receiver.

– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

– Consult the dealer or an experienced radio/TV technician for help.

This equipment compiles with FCC/IC radiation

exposure limits set forth for uncontrolled equipment

and meets the FCC radio frequency (RF) Exposure

Guidelines in Supplement C to OET65 and RSS-102

of the IC radio frequency (RF) Exposure rules. This

equipment has very low levels of RF energy that it

deemed to comply without maximum permissive

exposure evaluation (MPE). But it is desirable that it

should be installed and operated with at least 20 cm

and more between the radiator and person’s body

(excluding extremities: hands, wrists, feet and ankles).

FCC WARNING

Change or modifications not expressly approved by

the party responsible for compliance could void the

user’s authority to operate the equipment.

This transmitter must not be co-located or operated in

conjunction with any other antenna or transmitter.

FOR CANADIAN CUSTOMERS

To prevent electric shock, match wide blade of plug to

wide slot and fully insert.

This Class B digital apparatus complies with Canadian

ICES-003.

Product specificaties

Merk:	Yamaha
Categorie:	Ipod Audio
Model:	YID-W10
Kleur van het product:	Zwart
Gewicht:	302 g
Snoerlengte:	1.2 m
Stroomverbruik (in standby):	1 W
Compatibiliteit:	iPhone, iPhone 3G, iPhone 3GS, iPod (5th Generation), iPod classic, iPod nano, iPod touch
Stroomverbruik (typisch):	4 W