Yamaha RX-V992 Handleiding
Yamaha
AV-Receiver
RX-V992
Lees hieronder de đź“– handleiding in het Nederlandse voor Yamaha RX-V992 (87 pagina's) in de categorie AV-Receiver. Deze handleiding was nuttig voor 79 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/87
R X-V992
Natural Sound AV Receiver
Récepteur audiovisuel “Son Naturel”
OWNER’S MANUAL
MODE D’EMPLOI
R X-V992
DIGITAL/
PRO LOGIC
ENHANCED
MOVIE
THEATER
TV
SPORTS
STADIUM
DISCO
CONCERT
HALL
ROCK
CONCERT CHURCHJAZZ CLUB
EFFECT
VOLUME
NATURAL SOUND AV RECEIVER
RX–V992
CINEMA DSP
SPEAKERS
PHONES
A
ON OFF
B
BASS
EXTENSION
TONE
BYPASS
BASS TREBLE BALANCE
VIDEO AUX
S VIDEO VIDEO L AUDIO R
DELAY/CENTER
/REAR/SWFR
MAN’L
/
AUTO FM
TUNING
MODE
AUTO
/
MAN’L MONO
SET
MENU
FM/AM
DOWN
TUNING
UP
MEMORY
EDIT
55
4
3
2
l0l
2
3
4
55
4
3
2
l0l
2
3
4
55
4
3
2
l0l
2
3
4
LR
REC OUT/
ROOM 2 SELECTOR
VIDEO AUX
VCR 2
VCR 1
TV/DBS
DVD/LD SOURCE TAPE (MD)
TUNER
CD
PHONO
VCR 2 DVD
/
LDVCR 1
VIDEO AUX
TAPE (MD) TV/DBS
TUNER
CD
PHONO
A
/
B
/
C
/
D
/
E
1
2 3 4 5 6 7 8
POWER
l6
20
28
40
60
l2
8
4
2
0
–dB
1Read Instructions – All the safety
and operating instructions should be read
before the unit is operated.
2Retain Instructions – The safety and
operating instructions should be retained
for future reference.
3Heed Warnings – All warnings on the
unit and in the operating instructions
should be adhered to.
4Follow Instructions – All operating
and other instructions should be followed.
5Water and Moisture – The unit
should not be used near water – for
example, near a bathtub, washbowl,
kitchen sink, laundry tub, in a wet
basement, or near a swimming pool, etc.
6Carts and Stands – The unit should
be used only with a cart or stand that is
recommended by the manufacturer.
6A A unit and cart
combination should be
moved with care. Quick
stops, excessive force, and
uneven surfaces may cause
the unit and cart combination to overturn.
7Wall or Ceiling Mounting – The unit
should be mounted to a wall or ceiling
only as recommended by the
manufacturer.
8Ventilation – The unit should be
situated so that its location or position
does not interfere with its proper
ventilation. For example, the unit should
not be situated on a bed, sofa, rug, or
similar surface, that may block the
ventilation openings; or placed in a built-
in installation, such as a bookcase or
cabinet that may impede the flow of air
through the ventilation openings.
9Heat – The unit should be situated
away from heat sources such as
radiators, stoves, or other appliances that
produce heat.
10 Power Sources – The unit should be
connected to a power supply only of the
type described in the operating
instructions or as marked on the unit.
11 Power-Cord Protection – Power-
supply cords should be routed so that
they are not likely to be walked on or
pinched by items placed upon or against
them, paying particular attention to cords
at plugs, convenience receptacles, and
the point where they exit from the unit.
12 Cleaning – The unit should be
cleaned only as recommended by the
manufacturer.
13 Nonuse Periods – The power cord of
the unit should be unplugged from the
outlet when left unused for a long period
of time.
14 Object and Liquid Entry – Care
should be taken so that objects do not fall
into and liquids are not spilled into the
inside of the unit.
15 Damage Requiring Service – The
unit should be serviced by qualified
service personnel when:
A. The power-supply cord or the plug
has been damaged;
or
B. Objects have fallen, or liquid has
been spilled into the unit;
or
C. The unit has been exposed to rain;
or
D. The unit does not appear to operate
normally or exhibits a marked change in
performance;
or
E. The unit has been dropped, or the
cabinet damaged.
16 Servicing – The user should not
attempt to service the unit beyond those
means described in the operating
instructions. All other servicing should be
referred to qualified service personnel.
17 Power Lines – An outdoor antenna
should be located away from power lines.
18 Grounding or Polarization –
Precautions should be taken so that the
grounding or polarization is not defeated.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK), NO USER-SERVICEABLE
PARTS INSIDE, REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead
symbol, within an equilateral triangle,
is intended to alert you to the
presence of uninsulated “dangerous
voltage” within the product’s
enclosure that may be of sufficient
magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an
equilateral triangle is intended to alert
you to the presence of important
operating and maintenance
(servicing) instructions in the
literature accompanying the
appliance.
•Explanation of Graphical Symbols
CAUTION
WARNING
TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE
THIS UNIT TO RAIN OR MOISTURE.
SAFETY INSTRUCTIONS
We Want You Listening For A Lifetime
(for US customers only)
YAMAHA and the Electronic Industries Association’s Consumer Electronics Group
want you to get the most out of your equipment by playing it at a safe
level. One that lets the sound come through loud and clear without
annoying blaring or distortion – and, most importantly, without affecting
your sensitive hearing. Since hearing damage from loud sounds is often
undetectable until it is too late, YAMAHA and the Electronic Industries
Association’s Consumer Electronics Group recommend you to avoid
prolonged exposure from excessive volume levels.
English
19 For US customers only:
Outdoor Antenna Grounding – If an
outside antenna is connected to this unit,
be sure the antenna system is grounded
so as to provide some protection against
voltage surges and built-up static
charges. Article 810 of the National
Electrical Code, ANSI/NFPA 70, provides
information with regard to proper
grounding of the mast and supporting
structure, grounding of the lead-in wire to
an antenna discharge unit, size of
grounding conductors, location of
antenna discharge unit, connection to
grounding electrodes, and requirements
for the grounding electrode.
Note to CATV system installer:
This reminder is provided to call the
CATV system installer’s attention to
Article 820-40 of the NEC that
provides guidelines for proper
grounding and, in particular, specifies
that the cable ground shall be
connected to the grounding system of
the building, as close to the point of
cable entry as practical.
FCC INFORMATION
(for US customers only)
1. IMPORTANT NOTICE : DO NOT MODIFY THIS UNIT!
This product, when installed as indicated in the instructions contained in this
manual, meets FCC requirements. Modifications not expressly approved by
Yamaha may void your authority, granted by the FCC, to use the product.
2. IMPORTANT : When connecting this product to accessories and/or another
product use only high quality shielded cables. Cable/s supplied with this product
MUST be used. Follow all installation instructions. Failure to follow instructions
could void your FCC authorization to use this product in the USA.
3. NOTE : This product has been tested and found to comply with the requirements
listed in FCC Regulations, Part 15 for Class “B” digital devices. Compliance with
these requirements provides a reasonable level of assurance that your use of
this product in a residential environment will not result in harmful interference
with other electronic devices.
This equipment generates/uses radio frequencies and, if not installed and used
according to the instructions found in the users manual, may cause interference
harmful to the operation of other electronic devices.
Compliance with FCC regulations does not guarantee that interference will not
occur in all installations. If this product is found to be the source of interference,
which can be determined by turning the unit “OFF” and “ON”, please try to
eliminate the problem by using one of the following measures:
Relocate either this product or the device that is being affected by the
interference.
Utilize power outlets that are on different branch (circuit breaker or fuse) circuits
or install AC line filter/s.
In the case of radio or TV interference, relocate/reorient the antenna. If the
antenna lead-in is 300 ohm ribbon lead, change the lead-in to coaxial type
cable.
If these corrective measures do not produce satisfactory results, please contact
the local retailer authorized to distribute this type of product. If you can not
locate the appropriate retailer, please contact Yamaha Electronics Corp., U.S.A.
6660 Orangethorpe Ave, Buena Park, CA 90620.
The above statements apply ONLY to those products distributed by Yamaha
Corporation of America or its subsidiaries.
SPECIAL NOTES FOR FCC COMPOSITE DEVICE (for US
customers only)
This device is a composite system. The digital device component may not cause
harmful interference.
EXAMPLE OF ANTENNA GROUNDING
MAST
GROUND
CLAMP
ANTENNA
LEAD IN
WIRE
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810–20)
GROUNDING CONDUCTORS
(NEC SECTION 810–21)
GROUND CLAMPS
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250. PART H)
ELECTRIC
SERVICE
EQUIPMENT
NEC – NATIONAL ELECTRICAL CODE
Product specificaties
| Merk: | Yamaha |
| Categorie: | AV-Receiver |
| Model: | RX-V992 |
Heb je hulp nodig?
Als je hulp nodig hebt met Yamaha RX-V992 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding AV-Receiver Yamaha
16 Augustus 2022
15 Augustus 2022
9 Februari 2022
8 Februari 2022
9 Februari 2022
8 Februari 2022
16 Augustus 2022
28 Maart 2022
16 Augustus 2022
16 Augustus 2022
Handleiding AV-Receiver
- AV-Receiver JVC
- AV-Receiver Kenwood
- AV-Receiver Medion
- AV-Receiver Onkyo
- AV-Receiver Pioneer
- AV-Receiver Denon
- AV-Receiver Harman Kardon
- AV-Receiver Marantz
- AV-Receiver Technics
Nieuwste handleidingen voor AV-Receiver
25 Augustus 2023
2 Juli 2023
2 Juli 2023
2 Juli 2023
2 Juli 2023
2 Juli 2023
31 Januari 2023
20 November 2022
31 Januari 2023
8 April 2022