Yamaha DA824 Handleiding

Yamaha Audio/video-converter DA824

Lees hieronder de 📖 handleiding in het Nederlandse voor Yamaha DA824 (19 pagina's) in de categorie Audio/video-converter. Deze handleiding was nuttig voor 53 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/19

DA CONVERTER

Owner’s Manual

ON OFF

POWER

DA CO NVERTER

LOCKPEAK

SIGNAL

NOMINAL

PEAK

SIGNAL

NOMINAL

1 2 3 4 5 6 7 8

Keep This Manual For Future Reference.

FCC INFORMATION (U.S.A.)

1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions contained in this manual, meets FCC

requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product.

2. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s supplied with this product MUST

be used. Follow all installation instructions. Failure to follow instructions could void your FCC authorization to use this product in the USA.

3. NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class “B” digital devices. Compliance with

these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with

other electronic devices. This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found in the users manual, may

cause interference harmful to the operation of other electronic devices. Compliance with FCC regulations does not guarantee that interference will not occur in all

installations. If this product is found to be the source of interference, which can be determined by turning the unit “OFF” and “ON”, please try to eliminate the

problem by using one of the following measures: Relocate either this product or the device that is being affected by the interference. Utilize power outlets that are on

different branch (circuit breaker or fuse) circuits or install AC line filter/s. In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in

is 300 ohm ribbon lead, change the lead-in to coaxial type cable. If these corrective measures do not produce satisfactory results, please contact the local retailer

authorized to distribute this type of product. If you can not locate the appropriate retailer, please contact Yamaha Corporation of America, Electronic Service

Division, 6600 Orangethorpe Ave, Buena Park, CA 90620

The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries.

WARNING: THIS APPARATUS MUST BE EARTHED

IMPORTANT

THE WIRES IN THIS MAINS LEAD ARE COLOURED IN

ACCORDANCE WITH THE FOLLOWING CODE:

GREEN-AND-YELLOW : EARTH

BLUE : NEUTRAL

BROWN : LIVE

As the colours of the wires in the mains lead of this apparatus may

not correspond with the coloured markings identifying the terminals in

your plug, proceed as follows:

The wire which is coloured GREEN and YELLOW must be

connected to the terminal in the plug which is marked by the letter E

or by the safety earth symbol or coloured GREEN and YELLOW.

The wire which is coloured BLUE must be connected to the terminal

which is marked with the letter N or coloured BLACK.

The wire which is coloured BROWN must be connected to the

terminal which is marked with the letter L or coloured RED.

* This applies only to products distributed by YAMAHA KEMBLE

MUSIC (U.K.) LTD.

DA824—Owner’s Manual

Important Information

Please read before operating the DA824

Warnings

• Do not subject the DA824 to extreme temperatures, humidity, direct sunlight, or dust,

which could be a potential ﬁre or electrical shock hazard.

• Do not allow water to enter the DA824 or allow it to become wet. Fire or electrical shock

may result.

• Connect the power cord only to an AC outlet of the type stated in this Owner’s Manual

or as marked on the DA824. Failure to do so is a ﬁre and electrical shock hazard.

• Hold the power-cord plug when disconnecting from an AC outlet. Never pull the cord.

A power cord damaged through pulling is a potential ﬁre and electrical shock hazard.

• Do not touch the power plug with wet hands. Doing so is a potential electrical shock

hazard.

• Do not place heavy objects, including the DA824, on top of the power cord. A damaged

power cord is a ﬁre and electrical shock hazard. In particular, be careful not to place

heavy objects on a power cord covered by a carpet.

• Do not scratch, bend, twist, pull, or heat the power cord. A damaged power cord is a

ﬁre and electrical shock hazard.

• If the power cord is damaged (e.g., cut or a bare wire is exposed), ask your dealer for a

replacement. Using the DA824 with a damaged power cord is a ﬁre and electrical shock

hazard.

• Do not plug several devices into the same AC outlet. This may overload the AC outlet,

and could be a ﬁre or electrical shock hazard. It may also affect the performance of some

equipment.

• If you notice any abnormality, such as smoke, odor, or noise, or if a foreign object or

liquid gets inside the DA824, turn it off immediately. Remove the power cord from the

AC outlet and consult your dealer for repair. Using the DA824 in this condition is a ﬁre

and electrical shock hazard.

• Do not place small objects on top of the DA824. Metal objects falling inside the DA824

is a ﬁre and electrical shock hazard.

• If a foreign object or water gets inside the DA824, turn it off immediately. Remove the

power cord from the AC outlet and consult your dealer for repair. Using the DA824 in

this condition is a potential ﬁre and electrical shock hazard.

• Should the DA824 be dropped or the cabinet be damaged, turn off the power, remove

the power plug from the AC outlet, and contact your dealer. If you continue using the

unit without heeding this instruction, ﬁre or electrical shock may result.

• Do not remove the DA824’s cover. You could receive an electrical shock. If you think

internal inspection, maintenance, or repair is necessary, contact your dealer.

• Do not attempt to modify the DA824. This is a potential ﬁre and electrical shock hazard.

• Do not block the DA824 ventilation slots. Blocking the ventilation slots is a potential

ﬁre hazard.

• Do not place a container with liquid or small metal objects on top of this unit. Liquid

or metal objects inside this unit are a ﬁre and electrical shock hazard.

Product specificaties

Merk:	Yamaha
Categorie:	Audio/video-converter
Model:	DA824
Kleur van het product:	Zwart
Gewicht:	7500 g
Breedte:	480 mm
Diepte:	366.8 mm
Hoogte:	97.5 mm
Aan/uitschakelaar:	Ja
Aantal:	1
Operating voltage:	230 V
Stroomverbruik (typisch):	40 W