Whirlpool WUC 3C33 F Handleiding

Whirlpool Vaatwasser WUC 3C33 F

Lees hieronder de đź“– handleiding in het Nederlandse voor Whirlpool WUC 3C33 F (8 pagina's) in de categorie Vaatwasser. Deze handleiding was nuttig voor 65 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
1
EN
Before using the appliance carefully read Safety Instructions.
APPLIANCE
PRODUCT DESCRIPTION
THANK YOU FOR BUYING A WHIRLPOOL PRODUCT.
In order to receive a more complete assistance, please
register your appliance on: www.whirlpool.eu/register
You can download the Safety Instructions and the
User Manual, by visiting our website docs.whirlpool.eu
and following the Instructions on the back of this
booklet.
1. On-O/Reset button with indicator light
2. Program selection button with indicator light
3. Multizone button with indicator light / Keylock
4. Eco program indicator light
5. Key lock indicator light
6. Display
7. Program number and remaining time indicator
DAILY REFERENCE
GUIDE
CONTROL PANEL
8. Tablet (Tab) indicator light
9. Closed water tap indicator light
10. Rinse Aid rell indicator light
11. Salt rell indicator light
12. Sani Rinse button with indicator light / Tablet (Tab)
13. Delay button with indicator light
14. Start/Pause button with indicator light / Drain out
1. Upper rack
2. Cutlery rack
3. Foldable aps
4. Upper rack height adjuster
5. Upper spray arm
6. Lower rack
7. Lower spray arm
8. Filter Assembly
9. Salt reservoir
10. Detergent and Rinse Aid dispensers
11. Rating plate
12. Control panel
3
1
2
8
13
14
5
467 11 12
910
1
4
5
6
7
12
10
8
2
3
9
0000 000 00000
Service:
11
2
FIRST TIME USE
SALT, RINSE AID AND DETERGENT
ADVICE REGARDING THE FIRST TIME USE
After installation, remove the stoppers from the racks and the retaining
elastic elements from the upper rack.
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes and
on the machine’s functional components.
• It is mandatory that THE SALT RESERVOIR NEVER BE EMPTY.
• It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher
(see PRODUCT DESCRIPTION) and must be lled when the SALT REFILL
indicator light in the control panel is lit.
1. Remove the lower rack and unscrew the
reservoir cap (anticlockwise).
2. Only the rst time you do this: ll the salt
reservoir with water.
3. Position the funnel (see gure) and ll the salt
reservoir right up to its edge (approximately 1
kg); it is not unusual for a little water to leak out.
4. Remove the funnel and wipe any salt residue
away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can get
into the container during the wash program (this could damage the
water softener beyond repair).
Whenever you need to add salt, it is mandatory to complete the pro-
cedure before the beginning of the washing cycle to avoid corrosion.
SETTING THE WATER HARDNESS
To allow the water softener to work in a perfect way, it is essential that
the water hardness setting is based on the actual water hardness in
your house. This information can be obtained from your local water
supplier.
The factory sets the default value for the water hardness.
• Switch on the appliance by pressing the button.ON/OFF
• Switch o the appliance by pressing the button.ON/OFF
• Hold down button START/Pause for 5 seconds, until you hear a beep.
• Switch on the appliance by pressing the button.ON/OFF
• The current selection level number and the salt indicator light both ash.
• Press button to select the desired hardness level (Psee WATER HARD-
NESS TABLE).
• Switch o the appliance by pressing the button.ON/OFF
Setting is complete!
As soon as this procedure is complete, run a program without loading.
Only use salt that has been specically designed for dishwashers.
After the salt has been poured into the machine, the SALT REFILL indi-
cator light switches o.
If the salt container is not lled, the water softener and the heating
element may be damaged as a result of limescale accumulation.
Using of Salt is recommended with any type of dishwasher deter-
gent.
Water Hardness Table
Level °dH
German degrees
°fH
French degrees
°Clark
English degrees
1 Soft 0 - 6 0 - 10 0 - 7
2 Medium 7 - 11 11 - 20 8 - 14
3 Average 12 - 16 21 - 29 15 - 20
4 Hard 17 - 34 30 - 60 21 - 42
5 Very hard 35 - 50 61 - 90 43 - 62
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse aid dispenser should be A
lled when the in the control RINSE AID REFILL indicator light
panel is lit.
1. Open the dispenser by pressing and pulling up the tab on the lid.B
2. Pour in the rinse aid (max.110 ml), making sure it does not overow
from the dispenser. If this happens, clean the spill immediately with
a dry cloth.
3. Press the lid down until you hear a click to close it.
NEVER pour the rinse aid directly into the appliance tub.
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satised with the drying results, you can ad-
just the quantity of rinse aid used.
• Switch the dishwasher on using the button.ON/OFF
• Switch it o using the button.ON/OFF
• Press button START/Pause three times - a beep will be heard.
• Switch it on using the button.ON/OFF
• The current selection level number and rinse aid indicator light ash.
• Press button to select the level of rinse aid quantity to be supplied.P
• Switch it o using the buttonON/OFF
Setting is complete!
If the rinse aid level is set to 1 (ECO), no rinse aid will be supplied. The
LOW RINSE AID indicator light will not be lit if you run out of rinse aid.
A maximum of 5 levels can be set according to the dishwasher model.
The factory setting is specic to the model, please follow instruction
above to check this for your machine.
• If you see bluish streaks on the dishes, set a low number (2-3).
• If there are drops of water or limescale marks on the dishes, set a
mid-range number (4-5).
FILLING THE DETERGENT DISPENSER
To open the detergent dispenser use the opening device C.
Introduce the detergent into the dry dispenser D only. Place the
amount of detergent for pre-washing directly inside the tub.
1. When measuring out the detergent
refer to the mentioned earlier infor-
mation to add the proper quantity.
Inside the dispenser there are indiD-
cations to help the detergent dosing.
2. Remove detergent residues from
the edges of the dispenser and clo-
se the cover until it clicks.
3. Close the lid of the detergent
dispenser by pulling it up until the
closing device is secured in place.
The detergent dispenser automatically opens up at the right time
according to the program.
If all-in-one detergents are used, we recommend using the TABLET
button, because it adjusts the program so that the best washing and
drying results are always achieved.
Usage of detergent not designed for dishwashers may cause mal-
function or damage to the appliance.
A
B
D
C
3
EN
PROGRAMS TABLE
PROGRAMS DESCRIPTION
ECO program data is measured under laboratory conditions according to European Standard EN 60436:2020.
Note for Test Laboratories:
For information on comparative EN testing conditions, please send an email to the following address: dw_test_support@whirlpool.com
Pre-treatment of the dishes is not needed before any of the programs.
*) Not all options can be used simultaneously.
**) Values given for programs other than the program Eco are indicative only. The actual time may vary depending on many factors such as temperature
and pressure of the incoming water, room temperature, amount of detergent, quantity and type of load, load balancing, additional selected options and
sensor calibration. The sensor calibration can increase program duration up to 20 min.
Program
Drying
phase
NaturalDry
Available
options *)
Duration
of wash
program
(h:min)**)
Water con-
sumption
(litres/cycle)
Energy con-
sumption
(kWh/cycle)
1. Eco 50° 3:10 9,5 0,83
2. 6th Sense®
50-60°
1:25 - 3:00 7,0 - 14,0 0,90 - 1,40
3. Intensive 65° 2:50 16,0 1,60
4. Fast Wash&Dry 50° 1:25 11,5 1,10
5. Crystals
45°
1:40 11,5 1,20
6. Rapid 30’ 50° -- 0:30 9,0 0,50
7. Silent 50° 3:30 15,0 1,15
8. Pre-Wash --- 0:12 4,5 0,01
Instructions on wash cycle selection.
1 ECO
Eco programme is suitable to clean normally soiled tableware, that for
this use, it is the most ecient programme in terms of its combined
energy and water consumption, and that it is used to assess compliance
with the EU Ecodesign legislation.
2 6th SENSE®
For normally soiled dishes with dried food residues. Senses the level of
soiling on the dishes and adjusts the program accordingly. When the
sensor is detecting the soil level an animation appears in the display
and the cycle duration is updated.
3 INTENSIVE
Program recommended for heavily soiled crockery, especially suitable
for pans and saucepans (not to be used for delicate items).
4 FAST WASH&DRY
Normally soiled crockery. Everyday cycle, that ensures optimal cleaning
performance in shorter time.
5 CRYSTALS
Program for delicate items, which are more sensitive to high temperatu-
res, for example glasses and cups.
6 RAPID 30’
Program to be used for half load of lightly-soiled dishes with no dried
food residues. Does not have drying phase.
7 SILENT
Suitable for night-time operation of the appliance. Ensures optimal cle-
aning and drying performance with the lowest noise emission.
8 PRE-WASH
Use to refresh crockery planned to be washed later. No detergent to be
used with this program.
Notes:
Please note that cycle Rapid 30’ is dedicated for lightly soiled dishes.


Product specificaties

Merk: Whirlpool
Categorie: Vaatwasser
Model: WUC 3C33 F
Apparaatplaatsing: Semi-ingebouwd
Soort bediening: Knoppen
Ingebouwd display: Ja
Gewicht: 47000 g
Breedte: 598 mm
Diepte: 590 mm
Hoogte: 820 mm
Netbelasting: 1900 W
Aantal couverts: 14 couverts
Automatische programma's: Ja
Droogsysteem: Natuurlijk
Deurkleur: Wit
Snoerlengte: 1.3 m
Uitgestelde start timer: Ja
Startvertraging: 24 uur
Resterende tijd indicatie: Ja
Duur cyclus: 190 min
Geluidsniveau: 43 dB
Energie-efficiëntieklasse: D
Gewicht verpakking: 49000 g
Installatie compartiment breedte: 600 mm
Installatie compartiment diepte: 600 mm
Installatie compartiment hoogte: 820 mm
Waterconsumptie per cyclus: 9.5 l
Stroom: 10 A
Installatie compartiment hoogte (min): 820 mm
Geluidsemissieklasse: B
Aantal wasprogramma's: 8
Energieverbruik per 100 cycli: 85 kWu
Verstelbare voeten: Ja
Productafmeting: Volledige grootte (60 cm)
Kleur bedieningspaneel: Wit
Bestek compartiment type: Mand
Zout indicator: Ja
Glansmiddel indicator: Ja
Afwasprogramma's: Eco, Glass/delicate, Intensive 65°C, Quick, Silent
Energieverbruik per cyclus: 0.848 kWu
Lengte afvoerslang: 1.5 m
Lengte watertoevoerslang: 1.55 m
Bovenste mand verstelbare hoogte: Ja
Installatie compartiment hoogte (max): 890 mm
Temperatuur (max): 65 °C
Watertoevoer: Koud
Manden verstelbare plaatsing: Bovenste
Stroomverbruik (ingeschakeld houden): 0.5 W
AC-ingangsspanning: 220-240 V
AC-ingangsfrequentie: 50 Hz
Energie-efficiëntieschaal: A tot G

Heb je hulp nodig?

Als je hulp nodig hebt met Whirlpool WUC 3C33 F stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Vaatwasser Whirlpool

Handleiding Vaatwasser

Nieuwste handleidingen voor Vaatwasser