Whirlpool WH3ID10BS7SA0 Handleiding

Whirlpool Vaatwasser WH3ID10BS7SA0

Lees hieronder de 📖 handleiding in het Nederlandse voor Whirlpool WH3ID10BS7SA0 (32 pagina's) in de categorie Vaatwasser. Deze handleiding was nuttig voor 5 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/32

ENQuick Guide

CONTROL PANEL

FILLING THE SALT RESERVOIR

The use of salt prevents the formation of LIMESCALE on the dishes and on

the machine’s functional components.

• It is mandatory that the salt reservoir never be empty.

• It is important to set the water hardness.

The salt reservoir is located in the lower part of the dishwasher and must be

lled when the SALT REFILL indicator light in the control panel is lit.

1. Remove the lower rack and unscrew the reservoir cap

(anticlockwise).

2. Position the funnel and ll the salt reservoir (see gure)

right up to its edge (approximately 1 kg); it is not unu-

sual for a little water to leak out.

3. Only the rst time you do this: ll the salt reservoir

with water.

4. Remove the funnel and wipe any salt residue away from the opening.

Make sure the cap is screwed on tightly, so that no detergent can get into

the container during the wash program (this could damage the water

softener beyond repair).

Whenever you need to add salt, it is mandatory to complete the proce-

dure before the beginning of the washing cycle to avoid corrosion.

WATER SOFTENING SYSTEM

Water softener automatically reduces water hardness, consequently pre-

venting scale buildup on heater, contributing also to better cleaning e-

ciency. This system regenerates itself with salt, therefore it is required

to rell salt container when empty.

Frequency of regeneration depends on water hardness level setting - regen-

eration takes place once per 6 Eco cycles with water hardness level set to 3.

Regeneration process starts in nal rinse and nishes in drying phase, be-

fore cycle ends.

• Single regeneration consumes: ~3.5L of water;

• Takes up to 5 additional minutes for the cycle;

• Consumes below 0.005kWh of energy.

FILLING THE RINSE AID DISPENSER

Rinse aid makes dish DRYING easier. The rinse aid

dispenser A should be lled when the RINSE AID

REFILL indicator light in the control panel is lit.

NEVER pour the rinse aid directly into the

appliance tub.

FILLING THE DETERGENT DISPENSER

To open the detergent dispenser use the opening device . Introduce the C

detergent into the dry dispenser only. Place the amount of detergent for D

pre-washing directly inside the tub.

If all-in-one detergents are used, we recommend using the TABLET button,

because it adjusts the program so that the best washing and drying results

are always achieved.

Usage of detergent not designed for dishwashers may cause

malfunction or damage to the appliance.

1 2 3 4 5 6 7 8 9 10 11

1. ON-OFF/Reset button with indicator light

2. Program selection button

3. Salt rell indicator light

4. Rinse Aid rell indicator light

5. Program number and delay time indicator

6. Tablet indicator light

7. Display

8. Power Clean® indicator light

9. Power Clean® button

10. Delay button

11. START/Pause button with indicator light /

Tablet (Tab)

THANK YOU FOR BUYING A WHIRLPOOL PRODUCT.

In order to receive a more complete assistance, please

PLEASE SCAN THE

QR CODE ON YOUR

APPLIANCE IN

ORDER TO HAVE

MORE DETAILED

INFORMATION

Before using the appliance carefully read Safety and Installation Instructions.

After installation, please remember to remove all transport protection parts from

the dishwasher.

Program

Programs description

Drying

phase

Natural

Dry

Available

options *)

Duration

of wash

program

(h:min)

**)

Water

consumption

(litres/cycle)

Energy

consumption

(kWh/cycle)

Eco 50°- Program is suitable to clean normally soiled tableware, that for

this use, it is the most ecient programme in terms of its combined ener-

gy and water consumption, and that it is used to assess compliance with

the EU Ecodesign legislation.

3:40 8.7 0.67

2. Intensive 65° - Program recommended for heavily soiled crockery, espe-

cially suitable for pans and saucepans. 2:45 17.5 1.60

6th Sense® 50-60°- For normally soiled dishes with dried food residues.

Senses the level of soiling on the dishes and adjusts the program accord-

ingly. 1:20 - 3:00 7.0 - 14.0 0.70 - 1.10

4. Fast Wash&Dry 50°

- Normally soiled crockery. Everyday cycle, that ensures

optimal cleaning and drying performance in shorter time.

1:25 11.5 1.10

5. Half Load - 55° Ideal for washing a half load of lightly or normally soiled

crockery. 1:20 11.0 1.00

6. Rapid 30’ - 45° Program to be used for half load of lightly-soiled dishes

with no dried food residues. Without drying. - 0:30 9.0 0.50

Silent

50° - Suitable for night-time operation of the appliance. With the

lowest noise. 3:30 16.0 1.15

8. Sanitizing - 65° Normally or heavily soiled crockery, with additional anti-

bacterial wash. Can be used to perform maintenance of the dishwasher. - 1:50 12.0 1.30

9. Prewash - Use to refresh crockery planned to be washed later.

No detergent to be used with this program. - - 0:10 4.5 0.01

PROGRAMS TABLE

FIRST TIME USE More information in the Daily Reference Guide on website.

Quick Guide

CLEANING AND MAINTENANCE More information in the Daily Reference Guide on website.

CLEANING THE FILTER ASSEMBLY CLEANING THE SPRAY ARMS

In case you nd foreign objects (such as broken glass, porcelain, bones, fruit seeds

etc.) please remove them carefully.

NEVER REMOVE the wash-cycle pump protection (black detail) (Fig 4).

To remove the upper spray arm,

turn the plastic locking ring in a

clockwise direction.

The lower spray arm may

be removed by pulling it

upwards.

POWER CLEAN®

Power Clean®

uses the special

water jets in the

rear of cavity to

wash more in-

tensively the

high dirty items. The lower rack has

a Space Zone, a special pull-out

support in the rear of the rack that

can be used to support frying pans

or baking pans in upright position,

thus taking up less space.

Placing the pots/casseroles faced

to the Power Clean® component

please activate the POWER CLEAN®

on the panel.

UPPER RACK

(loading example for

the upper rack)

Load delicate and light

dishes: glasses, cups,

saucers, low salad

bowls.

LOWER RACK

(loading example for the lower

rack)

For pots, lids, plates, salad

bowls, cutlery etc.. Large plates

and lids should ideally be pla-

ced at the sides to avoid inter-

ferences with the spray arm.

The lower rack has tip-up sup-

ports which can be used in a

vertical position when arrang-

ing plates or in a horizontal po-

sition (lower) to load pans and

salad bowls easily.

FOLDABLE

FLAPS

WITH AD-

JUSTABLE

POSITION

CUTLERY BASKET

The basket is

equipped with

top

grilles for

improved cutle-

ry arrangement.

The cutlery ba-

sket should be

positioned only

at the front of

the lower rack.

Knives and other utensils with sharp

edges must be placed in the cutlery

basket with the points facing down-

wards or they must be positioned

horizontally in the tip-up compart-

ments on the upper rack.

LOADING THE RACKS CAPACITY: 10 standard place-settings

ECO program data is measured under laboratory conditions according to European Standard EN 60436:2020.

Note for Test Laboratories: For information on

comparative EN testing conditions, please send an email to the following address:

dw_test_support@europeanappliances.com

Pre-treatment of the dishes is not needed before any of the programs.

*) Not all options can be used simultaneously.

**) Values given for programs other than the program Eco are indicative only. The actual time may vary depending on many factors such as temperature and

pressure of the incoming water, room temperature, amount of detergent, quantity and type of load, load balancing, additional selected options and sensor cali-

bration. The sensor calibration can increase program duration up to 20 min.

OPTIONS can be selected directly by pressing the corresponding button (see CONTROL PANEL). If an option is not compatible with the selected

program (see PROGRAMS TABLE), the corresponding LED ashes rapidly 3 times and beeps will sound. The option will not be enabled.

DELAY - The start time of the program may be delayed for a period of

time between and hours.1 12

The DELAY function cannot be set once a wash cycle has been started.

POWER CLEAN® - Thanks to the additional power jets this option

provides a more intensive and powerful wash in the lower rack, in the

specic area. This option is recommended for washing pots and casseroles.

TABLET (Tab)- If you use powder or liquid detergent, this option

should be o.

OPTIONS AND FUNCTIONS Please scan on your product in order to have more detailed information.the QR code

NaturalDry is a convection drying system which automatically opens the

door during/after drying phase to ensure exceptional drying performance

every day. Door opens at the temperature that is safe to your kitchen fur-

niture.

ENQuick Guide

PROBLEMS POSSIBLE CAUSES SOLUTIONS

The dishwasher does

not ll the water.

Display shows: H,

6 and On/O LED is

blinking rapidly

No water in the water supply or the tap is

closed. Make sure there is water in the water supply or the tap running.

The inlet hose is bent. Make sure the inlet hose is not bent (see INSTALLATION) reprogram the dishwa-

sher and reboot.

The sieve in the water inlet hose is clogged;

it is necessary to clean it

After having carried out the verication and cleaning, turn o and turn on the

dishwasher and restart a new program.

Dishwasher nishes

the cycle prematurely.

Display shows: 15

and

On/O LED is blinking

rapidly

Drain hose positioned too low or siphoning

into home sewage system.

Check if end of drain hose is placed at correct height (see INSTALLATION).Check

for siphoning into home sewage system, install air admittance valve if necessary.

Air in water supply. Check water supply for leaks or other issues letting air inside.

Detergent leaks. Depends on the liquid detergent used and

can be emphasized in case of delay option

is activated.

Small leaks will not cause machine malfunction and can be avoided by changing

liquid detergent type or using tablets.

In case your dishwasher doesn’t work properly, check if the problem can be solved by going through the following list. For other errors or issues

please contact authorized After-sales Service which contact details can be found in the warranty booklet. Spare parts will be available for a period

of either up to 7 or up to 10 years, according to the specic Regulation requirements.

TROUBLESHOOTING

Please scan the on your product in order to have more detailed information. QR code

Policies, standard documentation, ordering of spare parts and additional product information can be found by:

• Using QR code on your product.

• Visiting our website anddocs.whirlpool.eu/docs parts-selfservice.europeanappliances.com

• Alternatively, (See phone number in the warranty booklet). contact our After-sales Service

When contacting our After-sales Service, please state the codes provided on your product’s identication plate.

The model information can be retrieved using the QR-Code reported in the energy label.

The label also includes the model identier that can be used to consult the portal of the registry at https://eprel.ec.europa.eu.

IEC 436

Product specificaties

Merk:	Whirlpool
Categorie:	Vaatwasser
Model:	WH3ID10BS7SA0

Heb je hulp nodig?

Als je hulp nodig hebt met Whirlpool WH3ID10BS7SA0 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Vaatwasser Whirlpool

Whirlpool WFE 2B19 Handleiding

14 Januari 2025

Whirlpool WH8IB15B2M6LS0 Handleiding

13 Januari 2025

Whirlpool W0I D734L S Handleiding

13 Januari 2025

Whirlpool WH8IC15B4M6LHC0 Handleiding

13 Januari 2025

Whirlpool WH8IA15AM3TUS0 Handleiding

13 Januari 2025

Whirlpool WH3ID10BS7SA0 Handleiding

13 Januari 2025

Whirlpool WH6FB10BS7A0X Handleiding

9 Januari 2025

Whirlpool WH7FA14BN7A0X Handleiding

9 Januari 2025

Whirlpool WIP 4T233 PFEG Handleiding

3 December 2024

Whirlpool WFO 3T233 P 6.5 X Handleiding

3 December 2024

Handleiding Vaatwasser

Nieuwste handleidingen voor Vaatwasser

SEIKI SC-1300AU6DWW Handleiding

13 Januari 2025

Hoover HFS 2F492X/E Handleiding

13 Januari 2025

Grundig GNVP4432PW Handleiding

13 Januari 2025

Bosch SGV45M83EU Handleiding

13 Januari 2025

Sauter LV112 Handleiding

11 Januari 2025

Siemens SN87TX02CE Handleiding

11 Januari 2025

Siemens SX87TX02CE Handleiding

11 Januari 2025

Gorenje GV673B66 Handleiding

9 Januari 2025

Smeg DWAU6224X4 Handleiding

9 Januari 2025

Smeg DWAU6224N4 Handleiding

9 Januari 2025