Whirlpool WIO 3T323 6 Handleiding

Whirlpool Vaatwasser WIO 3T323 6

Lees hieronder de 📖 handleiding in het Nederlandse voor Whirlpool WIO 3T323 6 (8 pagina's) in de categorie Vaatwasser. Deze handleiding was nuttig voor 19 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
1
EN
DAILY REFERENCE
GUIDE
THANK YOU FOR BUYING A WHIRLPOOL PRODUCT.
In order to receive a more complete assistance, please
register your appliance on:
www.whirlpool.eu/register
You can download the Safety Instructions and the Use
and Care Guide, by visiting our website
http://docs.whirlpool.eu and following the Instructions
on the back of this booklet.
Before using the appliance carefully read Health and Safety guide.
PRODUCT DESCRIPTION
APPLIANCE
1.Upper rack
2. Foldable flaps
3.Upper rack height adjuster
4.Upper spray arm
5.Lower rack
6.Cutlery basket
7.Lower spray arm
8.Filter Assembly
9.Salt reservoir
10.Detergent and Rinse Aid dispensers
11.Rating plate
12.Control panel
0000 000 00000
Service:
1
2
3
4
5
6
11
13
7
12
10
8
9
CONTROL PANEL
1. On-Off/Reset button with indicator light
2. Program selection button
3. Salt refill indicator light
4. Rinse Aid refill indicator light
5. Program number and remaining time indicator
6. Delay indicator light
7. Display
8. Multizone indicator light
9. Delay button
10. Multizone button
11. Turbo button with indicator light
12. Extra Dry button with indicator light
13. Tablet (Tab) button with indicator light
1 2 3 4 5 6 7 8 9 10 12 1311
2
FIRST TIME USE
SALT, RINSE AID AND DETERGENT
ADVICE REGARDING THE FIRST TIME USE
After installation, remove the stoppers from the racks and the retaining
elastic elements from the upper rack.
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes and
on the machine’s functional components.
It is important that the salt reservoir be never empty.
t is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher and
should be filled when the SALT REFILL indicator light in the
control panel is lit.
1.Remove the lower rack and unscrew the
reservoir cap (anticlockwise).
2.Position the funnel
(see figure)
and fill the salt
reservoir right up to its edge (approximately 1 kg);
it is not unusual for a little water to leak out.
3.Remove the funnel and wipe any salt residue
away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can get
into the container during the wash program (this could damage the
water softener beyond repair).
Whenever you need to add salt, we recommend carrying out the
procedure before the washing cycle is started.
SETTING THE WATER HARDNESS
To allow the water softener to work in a perfect way, it is essential that
the water hardness setting is based on the actual water hardness in
your house. This information can be obtained from your local water
supplier.
The factory setting is for average (3) water hardness.
1. Switch on the appliance by pressing the
ON/OFF
button.
2. Switch off the appliance by pressing the
ON/OFF
button.
3. Hold down button
P
for 5 seconds, until you hear a beep.
4. Switch on the appliance by pressing the
ON/OFF
button.
5. The current selection level number and the salt indicator light both flash.
6. Press button
P
to select the desired hardness level (
see WATER
HARDNESS TABLE).
7. Switch off the appliance by pressing the
ON/OFF
button.
Setting is complete!
As soon as this procedure is complete, run a program without loading.
Only use salt that has been specifically designed for dishwashers.
After the salt has been poured into the machine, the SALT REFILL
indicator light switches off.
If the salt container is not filled, the water softener and the heating
element may be damaged as a result.
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse aid dispenser A should
be filled when the RINSE AID REFILL indicator light in the control
panel is lit.
1. Open the dispenser
B
by pressing and pulling up the tab on the lid.
2. Carefully introduce the rinse aid as far as the maximum (110 ml)
reference notch of the filling space - avoid spilling it. If this happens,
clean the spill immediately with a dry cloth.
3. Press the lid down until you hear a click to close it.
NEVER pour the rinse aid directly into the tub.
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satisfied with the drying results, you can ad-
just the quantity of rinse aid used.
Switch the dishwasher on using the ON/OFF button.
Switch it off using the ON/OFF button.
Press button P three times - a beep will be heard.
Switch it on using the ON/OFF button.
The current selection level number and rinse aid indicator light flash.
Press button P to select the level of rinse aid quantity to be
supplied.
Switch it off using the ON/OFF button
Setting is complete!
If the rinse aid level is set to ZERO (ECO), no rinse aid will be supplied. The
LOW RINSE AID indicator light will not be lit if you run out of rinse aid.
A maximum of 4 levels can be set according to the dishwasher model.
The factory setting is for a medium level.
If you see bluish streaks on the dishes, set a low number (1-2).
If there are drops of water or limescale marks on the dishes, set a
high number (3-4).
FILLING THE DETERGENT DISPENSER
To open the detergent dispenser
use the opening device A. Introduce
the detergent into the dry dispenser
B only. Place the amount of
detergent for pre-washing directly
inside the tub.
1.When measuring out the detergent
refer to the to add the proper
quantity. Compartment
B
comprises a
level showing the maximum quantity
of liquid or powder detergent that can be added to each cycle.
2. Remove detergent residues from the edges of the dispenser and
close the cover until it clicks.
3. Close the lid of the detergent dispenser by pulling it up until the
closing device is secured in place.
The detergent dispenser automatically opens up at the right time
according to the program. If all-in-one detergents are used, we
recommend using the
TABLET
button, because it adjusts the program so
that the best washing and drying results are always achieved.
Water Hardness Table
Level °dH
German degrees
°fH
French degrees
1 Soft 0 - 6 0 - 10
2 Medium 7 - 11 11 - 20
3 Average 12 - 17 21 - 30
4 Hard 17 - 34 31 - 60
5 Very hard 35 - 50 61 - 90
M
A
X
A
B
35
25
A
B
3
EN
PROGRAMS TABLE
ECO program data is measured under laboratory conditions according to European Standard EN 50242.
*) Not all options can be used simultaneously.
**) The duration of the program shown on the display or in the booklet is an estimate calculated on standard conditions. The actual time may vary depending on many
factors such as temperature and pressure of the incoming water, room temperature, amount of detergent, quantity and type of load, load balancing, additional selected
options and sensor calibration. The sensor calibration can increase program duration up to 20 min.
Standby consumption: Left-on mode consumption: 5 W - Off mode consumption: 0.5 W
PROGRAMS DESCRIPTION
Instructions on wash cycle selection.
ECO
Normally soiled crockery. Standard program, the most efficient in terms
of its combined energy and water consumption.
6th SENSE ®
For normally soiled dishes with dried food residues. Senses the level of
soiling on the dishes and adjusts the program accordingly. When the
sensor is detecting the soil level an animation appears in the display
and the cycle duration is updated.
INTENSIVE
Program recommended for heavily soiled crockery, especially suitable
for pans and saucepans (not to be used for delicate items).
DAILY
Normally soiled crockery. Everyday cycle, that ensures optimal cleaning
performance in shorter time.
SILENT
Suitable for night-time operation of the appliance. Optimum
performance ensured.
RAPID 30’
Program to be used for lightly-soiled dishes with no dried food
residues. (Ideal for 2 place settings).
CRISTAL
Cycle for delicate items, which are more sensitive to high temperatures,
for example glasses and cups.
PRE-WASH
Crockery to be washed later. No detergent to be used with this
program.
SANITIZING 65°
Normally or heavily soiled crockery, with additional antibacterial wash.
SELF-CLEAN
Cycle to be used to perform maintenance of the dishwasher. It cleans
the interior of the appliance using hot water.
Notes:
Optimum performance levels when using the “1 Hour” and “Rapid
programs can be achieved by observing the maximum amounts of
specified place settings.
To reduce consumption even further, only run the dishwasher
when it is full.
Program
Drying
phase
Available options *)
Detergent
container
Duration of
wash pro-
gram
(h:min)**)
Water
consumption
(litres/cycle)
Energy
consumption
(kWh/cycle)
Tub B
1. Eco 50° 4:00 6.0 0.93
2. 6th Sense 50-60° 1:25 - 3:00 7.0 - 14.0 0.9 - 1.40
3. Intensive 65° - 2:50 14.0 1.50
4. Daily 50° - 1:30 12.0 1.15
5. Silent 50° - 3:30 15.0 1.15
6. Rapid 30’ 50° - - 0:30 9.0 0.50
7. Cristal 45° - 1:40 11.0 1.10
8. Pre-Wash - - - - 0:12 4.5 0.01
9. Sanitizing 65° - 1:40 10.0 1.30
10. Self- Clean 65° - 1:35 14.0 1.15


Product specificaties

Merk: Whirlpool
Categorie: Vaatwasser
Model: WIO 3T323 6
Apparaatplaatsing: Volledig ingebouwd
Soort bediening: Knoppen
Ingebouwd display: Ja
Gewicht: 35500 g
Breedte: 595 mm
Diepte: 570 mm
Hoogte: 820 mm
Aantal couverts: 14 couverts
Droogsysteem: Statisch
Deurkleur: Niet van toepassing
Snoerlengte: 1.3 m
Uitgestelde start timer: Ja
Startvertraging: 12 uur
Resterende tijd indicatie: Ja
Kinderslot: Nee
Wi-Fi-besturing: Nee
Droogklasse: A
Duur cyclus: 240 min
Geluidsniveau: 43 dB
Jaarlijks energieverbruik: 265 kWu
Gewicht verpakking: 37500 g
Breedte verpakking: 650 mm
Diepte verpakking: 675 mm
Hoogte verpakking: 910 mm
Energie-efficiëntieklasse (oud): A++
Verlichting binnenin: Nee
Waterconsumptie per cyclus: 6 l
Wasklasse: A
Stroom: 10 A
Geïntegreerde timer: Nee
Inverter technologie: Nee
Aantal wasprogramma's: 10
Verstelbare voeten: Ja
Laag ingebouwde capability (open aan bovenkant): Ja
Productafmeting: Volledige grootte (60 cm)
Verborgen verwarmingselement: Ja
Bestek compartiment type: Mand
Kuip materiaal: Roestvrijstaal
Waarschuwingssignaal: Nee
LED backlight: Nee
Zout indicator: Ja
Glansmiddel indicator: Ja
Bescherming tegen overstromen: Nee
Zelf reinigende filter: Nee
AquaStop-functie: Ja
AquaSensor functie: Nee
Glasbescherming: Ja
Half-geladen: Ja
Afwasprogramma's: Economy, Intensive, Normal, Pre-rinse
Energieverbruik per cyclus: 0.93 kWu
Jaarlijks waterverbruik: 1680 l
Lengte afvoerslang: 1.5 m
Lengte watertoevoerslang: 1.55 m
Sensor programma selectie: Ja
Certificering: CE, IMQ
Bovenste mand verstelbare hoogte: Ja
Temperatuur (max): 60 °C
Watertoevoer: Cold, Hot
Manden verstelbare plaatsing: Bovenste
Stroomverbruik (indien uit): 0.5 W
Ingebouwde water verzachter: Ja
Maximum schotel afmeting (laagste mand): 0 mm
Onmiddelijk verwarmings element: Nee
AC-ingangsspanning: 220 - 240 V
AC-ingangsfrequentie: 50 Hz
Type beeldscherm: LED
Aanpasbaar interieur: Nee
Maximum schotel afmeting (bovenste mand): 0 mm

Heb je hulp nodig?

Als je hulp nodig hebt met Whirlpool WIO 3T323 6 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Vaatwasser Whirlpool

Handleiding Vaatwasser

Nieuwste handleidingen voor Vaatwasser