Whirlpool WFP24JW Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Whirlpool WFP24JW (8 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 28 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
W11422243A
Pedestal Installation Instructions
For use with Model WFP24JW0
Instructions d’installation du piédestal
Pour utilisation avec le modèle WFP24JW0
23
3
/
8
"
(594 mm)
21
1
/
8
"
(537 mm)
12"
(305 mm)
Table of Contents
PEDESTAL SAFETY 1 .................................................................
INSTALLATION REQUIREMENTS 2 ..........................................
Tools and Parts 2 .....................................................................
Location Requirements 2..........................................................
Before Installing Your Pedestal ............................................. 2
INSTALLATION INSTRUCTIONS 3 ............................................
Install Pedestal ....................................................................... 3
Table des matières
SÉCURITÉ DU PIÉDESTAL ......................................................5
EXIGENCES D’INSTALLATION ................................................5
Outillage et pièces ...................................................................5
Exigences d’emplacement ......................................................6
Avant l’installation du piédestal ..............................................6
INSTRUCTIONS D’INSTALLATION .........................................7
Installation du piédestal ...........................................................7
Pedestal Safety
Pedestal Safety
Pedestal Safety
Pedestal SafetyPedestal Safety
2
Location Requirements
Parts supplied:
Remove parts from package. Check that all parts
were included.
Metal pedestal
Carriage bolts (4)
Tools required:
7/16" (11 mm) open end
wrench (for bracket self-
locking nut) and 9/16"
(14 mm) open end wrench
(for foot locknut)
Level
Tools and Parts
Check that you have the tools and parts necessary
for correct installation.
Installation Requirements
Locknuts (4)
Self-locking nuts (4)
Mounting brackets (4)
Feet with rubber caps (4)
If the dryer and pedestal assembly is located in a garage, 6"
(152 mm) must be added under the pedestal so that the dryer
is 18" (460 mm) above the garage oor. A separate riser, able
to support at least 275 lbs. (125 kg), may be required. The entire
pedestal must sit completely on the riser.
Before Installing Your Pedestal
IMPORTANT: If your washer and dryer are already installed,
they must be uninstalled.
Uninstalling Your Washer
1. Unplug the power supply cord.
2. Turn off the water faucet.
3. Slowly loosen the ll hose at the faucet to relieve the water
pressure. Use a sponge or towel to absorb the released water.
4. Pull the washer away from the wall so the pedestal can be
placed in its nal location.
Uninstalling Your Electric Dryer
1. Unplug dryer or disconnect power.
2. Pull the dryer away from the wall so the pedestal can be
placed in its nal location.
WARNING
Excessive Weight Hazard
Use two or more people to move and uninstall washer.
Failure to do so can result in back or other injury.
WARNING
Excessive Weight Hazard
Use two or more people to move and uninstall dryer.
Failure to do so can result in back or other injury.
Mounting Bracket for
Dryer (1)
3
Installation Instructions
Install Pedestal
Follow these instructions to install the pedestal on the washer
or dryer.
1. To install the washer or dryer onto the pedestal, rst thread
a locknut onto each foot. Screw each locknut down to the
rubber base of the foot.
2. When all 4 locknuts are in place on the feet, screw a foot
into each corner brace of the pedestal. Adjust the feet so
that the rubber pads extend just below the bottom of the
pedestal and keep the pedestal at least 1/8" (3.175 mm) off
the oor.
NOTE: For more stability, do not raise the bottom of the
pedestal any higher than necessary to clear the oor on all
four sides.
3. Set the pedestal in its nal location.
4. Place a level on the pedestal to ensure that it is level from
front to back and side to side. If necessary, adjust the feet
up or down to level the pedestal.
5. Once it is level, use a 9/16" (14 mm) open end wrench
to thread each locknut to the bottom of each corner brace.
Tighten until locked into place.
6. Place the washer or dryer on the pedestal as shown.
The front and side edges should line up. For Dryers screw
all feet in completely then unscrew 3 full turns.
WARNING
Excessive Weight Hazard
Use two or more people to move and install pedestal.
Failure to do so can result in back or other injury.
7a. Washer Installation: If installing the washer on the
pedestal, use 4 of these brackets in these locations on the
pedestal.
To install the brackets, slide the open-ended portion of
the bracket over one of the feet of the washer.Center the
two prongs of the bracket on top of the foot. Repeat this
step with the other three brackets and feet. Use one
bracket on each of the four feet to properly secure the
washer.
7b. Dryer Installation: If installing the dryer on the pedestal,
use this combination of brackets in these locations on the
pedestal.
To install the brackets, slide the open-ended portion of
the bracket over one of the feet of the dryer. Center the
two prongs of the bracket on top of the foot. Repeat this
step with the other three brackets and feet. Use one
bracket on each of the four feet to properly secure the
washer.
Pedestal bracket
Washer foot
Dryer foot
Dryer foot
Pedestal bracket
Front


Product specificaties

Merk: Whirlpool
Categorie: Niet gecategoriseerd
Model: WFP24JW

Heb je hulp nodig?

Als je hulp nodig hebt met Whirlpool WFP24JW stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Whirlpool

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd