Whirlpool CF 19 T Handleiding

Whirlpool Vriezer CF 19 T

Lees hieronder de đź“– handleiding in het Nederlandse voor Whirlpool CF 19 T (4 pagina's) in de categorie Vriezer. Deze handleiding was nuttig voor 19 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
INSTRUCTIONS FOR USE
1
GB
1. Lid Handle.
2. Lock (if provided).
3. Seal.
4. Defrost water drain plug (depending on model).
5. Control panel.
6. Basket (if present).
7. Condenser (located at the rear).
INSTALLATION
• Please refer to the chapter “BEFORE USING THE
APPLIANCE”.
• Unpack the appliance.
• Remove the 4 protection pieces inserted between
lid and appliance.
• Ensure that the defrosting water drainage plug (if
provided) is correctly positioned (4).
• For best operation of the appliance and in order to avoid
damage when the lid is opened, leave a space of at least
7 cm from the rear wall and 7 cm at the sides.
• Fit the accessories (if provided).
Clean the inside of the appliance before using it.
1. Thermostat: it can be used to adjust the internal
temperature of the appliance.
2. Red LED (if provided): Indicates that the appliance
temperature is not suciently low.
3. Green LED (if provided): indicates that the appliance
is on.
4. Yellow/orange illuminated button (if provided):
activates/deactivates the fast freeze function.
The exact conîť°guration of the controls may vary
according to the model.
Switching on the appliance
• The appliance is factory set for optimum operation at a
temperature of -18°C.
• Plug in the appliance.
• The green LED lights up (if provided).
• Also the red LED (if provided) will switch on because the
temperature inside the appliance is not yet suciently
low for food storage. The red LED will normally switch oîť®
within the îť°rst six hours after the appliance is switched
on.
• After connecting the appliance to the mains supply and
when the optimal temperature has been reached, ensure
that the fast freeze button is not pressed (the yellow LED,
if provided, is oîť®).
• Place food inside the product only when the red LED (if
provided) has switched oîť®.
Note:
As the seal is tight, the appliance lid cannot be reopened
immediately after closing. Wait a few minutes before
re-opening the lid of the appliance.
Temperature adjustment
Use the thermostat to select the ideal storage temperature.
To adjust the internal temperature, proceed as follows:
• Turn the thermostat knob to 1 for a storage temperature
that is less cold.
• Turn the thermostat knob to 6 / for a colder storage
temperature.
• For partial loads, or when the load indicator is below
the “e” symbol inside the appliance (if present), it is
advisable to move the thermostat to the lower position
(on “e”, if present on the thermostat scale).
INSTRUCTIONS FOR USE
2
FREEZING FOOD
Preparation of fresh food for freezing
• Before freezing, wrap and seal fresh food in: aluminium
foil, cling îť°lm, air and water-tight plastic bags,
polyethylene containers with lids, provided they are
suitable for freezing foods.
• Food must be fresh, mature and of prime quality in order
to obtain high quality frozen food.
• Fresh vegetables and fruit should preferably be frozen
as soon as they are picked to maintain the full original
nutritional value, consistency, colour and avour.
• Always leave hot food to cool before placing in the
appliance.
Freezing fresh food
• Place foods to be frozen in direct contact with the walls
of appliance:
A) - foods to be frozen,
B) - foods already frozen.
• Avoid placing foods to be
frozen in direct contact with
food already frozen.
• For best and fastest freezing,
foods should be split into small
portions; this will also be useful
when the frozen items are to
be used.
1. At least 24 hours before storing
fresh food in the appliance,
press the fast freeze button.
For appliances without this
button, turn the thermostat to
.
2. Place the food to be frozen and keep the lid of the
appliance closed for 24 hours. At the end of this period,
switch oîť® the fast freeze button (if provided).
FOOD STORAGE
Refer to the table on the appliance (if provided).
Classiîť°cation of frozen
foods
Put the frozen products into
the appliance and classify
them; The storage date
should be indicated on the
packs, to allow use within
expiry dates.
Advice for storing frozen
food
When purchasing frozen food products:
• Ensure that the packaging is not damaged (frozen
food in damaged packaging may have deteriorated).
If the package is swollen or has damp patches, it may
not have been stored under optimal conditions and
defrosting may have already begun.
• When shopping, leave frozen food purchases until last
and transport the products in a thermally insulated cool
bag.
• Once at home, place the frozen foods immediately in
the appliance.
• Avoid, or reduce temperature variations to the minimum.
Respect the best-before date on the package.
• Always observe the storage information on the package.
Note:
Eat fully or partially defrosted foods immediately.
Do not refreeze unless the food is cooked after it
has thawed. Once cooked, the thawed food can be
refrozen.
If there is a long power failure:
• Do not open the appliance lid except to place ice
packs (if provided) over the frozen foods on the
right and left of the appliance. This will slow down
the rise in temperature.
MONTHS FOOD
INSTRUCTIONS FOR USE
3
DEFROSTING THE APPLIANCE
The appliance should be defrosted when the thickness of
ice on the walls reaches 5-6 mm.
• Disconnect the appliance from the mains power supply.
• Remove the packs of food from the appliance and wrap
them close together in newspaper and store in a very
cool place or thermally insulated bag.
• Leave the appliance lid open.
• Remove the internal defrost
water drain plug (depending
on model).
• Remove the external defrost
water drain plug (depending
on model) and reposition it as
shown in the îť°gure.
• Place a bowl beneath the
drainage channel to collect
the residual water. If available,
use the divider.
• Speed up defrosting by using
a spatula to detach the ice
from the appliance walls.
• Remove the ice from the bottom of the appliance.
• In order to avoid permanent damage to the
appliance interior, do not use pointed or sharp
metal instruments for removing the ice.
• Do not use abrasive products or heat up the interior
artiîť°cially.
• Dry the interior of the appliance thoroughly.
• On completion of the defrosting, ret the plug.
CHANGING THE LID LIGHT BULB (if provided)
• Disconnect the appliance from the
mains power supply.
• Remove the diuser by following
the sequence of steps shown in
the îť°gure.
• Unscrew the light bulb and replace
it with an identical bulb of the
same wattage and voltage.
• Ret the diuser and plug in the appliance.
TROUBLESHOOTING GUIDE
1. The red LED ashes.
• Is there a power failure?
• Is defrosting in progress?
• Is the appliance lid properly closed?
• Is the appliance positioned near a heat source?
• Is the thermostat setting correct?
• Are the ventilation grille and condenser clean?
2. The appliance is too noisy.
• Is the appliance perfectly horizontal?
• Is the appliance in contact with other furniture or objects
that may cause vibrations?
• Has the packaging been removed from under the
appliance?
Note:
Gurgling noises from the refrigerating circuit after the
compressor cuts out are perfectly normal.
3. The green LED (if provided) is oîť® and the appliance
is not working.
• Is there a power failure?
• Is the plug properly inserted in the socket?
• Is the electric cable intact?
4. The green LED (if provided) is oîť® and the appliance
is working.
• The green LED is not working. Contact the After Sales
Service for a replacement.
5. The compressor runs continuously.
• Have hot foods been put in the appliance?
• Has the appliance lid been left open for a long time?
• Is the appliance positioned in a very warm room or near
heat sources?
• Is the thermostat setting correct?
• Has the fast freeze function (depending on model) been
pressed by mistake?
6. Too much ice on the upper edge.
• Are the defrost water drainage plugs correctly
positioned?
• Is the appliance lid properly closed?
• Is the appliance lid seal damaged or deformed? (See
chapter “Installation”)
• Have the 4 protection pieces been removed? (See
chapter “Installation”)
7. Condensation forms on the external walls of the
appliance.
• It is normal for condensation to form under certain
atmospheric conditions (humidity above 85%) or if the
appliance is located in a damp or poorly ventilated room.
The performance of the appliance is in no way aected.
8. The layer of ice on the internal walls of the
appliance is not uniform.
• This phenomenon is quite normal.


Product specificaties

Merk: Whirlpool
Categorie: Vriezer
Model: CF 19 T

Heb je hulp nodig?

Als je hulp nodig hebt met Whirlpool CF 19 T stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Vriezer Whirlpool

Handleiding Vriezer

Nieuwste handleidingen voor Vriezer