Whirlpool ADG SPACE IX Handleiding

Whirlpool Vaatwasser ADG SPACE IX

Lees hieronder de đź“– handleiding in het Nederlandse voor Whirlpool ADG SPACE IX (8 pagina's) in de categorie Vaatwasser. Deze handleiding was nuttig voor 79 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
GB -1-
Chart
ON/OFF
BUTTON
PROGRAMME
AND DELAY
SELECTOR
KNOB
(see at right for
options description
and “Table of
programmes” below).
START BUTTON
The indicator lights up during operation, flashes when a fault occurs, and goes off
at the end of the programme.
START BUTTON RESET FUNCTION:
Press this button for at least 2 seconds; the selected programme and options will
be cancelled. Main failure displays (repeated flashing of the START indicator lamp)
can be cancelled by RESETTING. Detailed instructions are given in chapter
“What to do if...”.
1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional
options) and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result of
the appliance’s automatic calibration system.
2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on
the EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.
3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.
Table of programmes
Deter-
gent
Consumption
PProgrammes Available
options Loading instructions Litres kWh Minutes 1)
1Pre-Wash cold Delay Crockery to be washed later. — 4.0 0.03 14
2Quickwash 40°C Delay Lightly soiled crockery, with no dried-on
food. * Use of tablets not recommended. X*10.0 0.65 30
3Eco 2) 50°C Delay Normally soiled crockery. Energy-saving
programme. X 12.0 1.05 165
4Antibacterial 3) Delay
Normally or heavily soiled crockery, with
additional antibacterial wash. Programme
interruption (e.g. due to door opening) can
compromise elimination of germs.
X 13.0 1.50 115
5Intensive 70°C Delay
Recommended programme for heavily soiled
crockery, especially suitable for pots and
pans.
X 14.0 1.55 155
Switch on the appliance
- press the ON/OFF button.
OK/Start lamp flashes.
Set the desired start delay (3-6-9h). The
selected start delay lamp (3-6-9h)
flashes.
Press the OK/Start button for
confirmation. After that the OK/Start
lamp switches off and the selected start
delay lamp lights up.
If you wish another time setting, press
OK/Start button again.
Turn the programme knob to your
desired programme position.
The OK/Start lamp flashes.
Press the OK/Start button for
confirmation.
After that the OK/Start lamp lights up.
The dishwasher starts immediately or
after the start delay selected.
For a Reset, press the OK/Start button at
a minimum of 2 seconds.
All settings are cancelled.
Indication: In the selection mode, all
described settings have to be selected
within 30 seconds, otherwise no settings
will be saved.
5019 396 01750ADP Space
Options and display description
BEFORE USING THE APPLIANCE FOR THE
FIRST TIME CAREFULLY READ THIS QUICK
REFERENCE GUIDE AND THE INSTALLATION
INSTRUCTIONS! THE GUARANTEE IS NOT
APPLICABLE IF FAULTS ARE CAUSED BY
INCORRECT USE OF THE APPLIANCE.
3
2
1
5
4
1
3
2
Programme settings
without start delay
Start delay and
programme settings
Quick reference guide
GB -2-
First time use
1- salt reservoir
2- rinse aid dispenser
3- detergent dispenser
4- racks system
5,6,7,8- available functions on the panel
9- filters
10- spray arms
In order to always ensure the best cleaning
results, you NEED to set:
DETERGENT type and WATER HARDNESS.
1. Select 3rd programme
(see Table of programmes
- page 1)
2. Press START button
for 7 seconds
3a. Check your
detergent type...
3b....and set it on your dishwasher
using the START button
(as per table below)
4. Remember to use salt and rinse
aid when needed (as indicated
below)
5. Switch off and switch on
again to save setting
Detergent
types
Dishwasher models
model without
display model with display
Powder or gel
(factory setting) no symbol add salt add rinse aid
Tablet 2 in 1 add salt
Tablet 3 in 1
Tablet All in 1
For models without “detergent type” option, the salt and rinse aid indicators will be lit when tablets are used.
3h 6h 9h
rinse aid
salt rinse aid
1. Ask your water supply company what the water hardness is... 2. ...enter this value on your
dishwasher Suggestions for detergent use
German
degrees °dH
French
degrees °fH
English
degrees °eH
Water
hardness
Dishwasher
with display:
insert value in
the display
Dishwasher
without
display: count
START button
led flashes
Gel or Powder
(rinse aid and
salt)
Tablets
0 - 5 0 - 9 0 - 6.3 Soft 1 1x
go to step 1
(see “Daily
check”)
if extra salt is
needed go to
step 1
(see “Daily
check”)
6 - 10 10 - 18 7 - 12.6 Medium 2 2x
11 - 15 19 - 27 13.3 - 18.9 Average 3 3x
16 - 21 28 - 37 19.6 - 25.9 Medium-hard 4 4x
22 - 28 38 - 50 26.6 - 35 Hard 5 5x
29 - 35 51 - 63 35.7 - 44.1 Very hard 6 6x
36 - 60 64 - 107 44.8 - 74.9 Extremely
hard 7 7x
How to set water hardness
*
only before the first wash or if the
water hardness has been changed
Switch on the appliance
- Select the 2nd programme “P2” - consult the table of programmes.
- Press the START button for at least 5 seconds until the START indicator lamp flashes.
- The water hardness setting is shown on the display (if present) or the START button flashes.
- With each successive touch of the START button the setting increases and when it reaches 7 it returns to 1 again.
- The appliance must be switched off to memorise the new setting.
Even if you use tablets which include salt,
you must still add salt since such
detergents are not effective enough at
softening hard water.
Water hardness level is factory set for
medium hard water (a number “4” is
shown on the display or the START
indicator lamp flashes 4 times).
How to set detergent type: powder/gel/tablet (if option is available)
GB -3-
Daily check
1
2
3
Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulator
Daily use
The salt level indicator lamp may remain lit for the duration of several wash cycles. If the
water hardness level falls within category (soft), no salt is required.
Salt indicator
(depending on
the model)
The indicator lamp on the control panel
lights up when SALT NEEDS TO BE
ADDED.
orange: OK. clear: NEEDS TO BE ADDED
Rinse aid indicator (depending on model) The indicator lamp on the control panel lights up when RINSE AID NEEDS TO BE
ADDED. dark: OK. clear: NEEDS TO BE ADDED
Only use rinse aids recommended for use in domestic dishwashers. Immediately wipe away any rinse aid spilt accidentally. This prevents the formation of excess suds which can cause a fault function of the appliance.
If there are streaks: reduce the dosage by turning the dial to a lower setting (1-3). If crockery is not perfectly dry: increase the dosage by turning the dial to a higher setting (5-6). Plastic dishes have more difficulty drying and a higher rinse aid
setting will not improve the situation.
Detergents with rinse aid incorporated may be effective only with longer programmes. In the case of shorter programmes, detergent residue may be a problem (if necessary, use powder detergent). Detergents with rinse aid incorporated tend
to form excess suds.
Visual indicator
(depending
on model).
Unscrew cap.
Fill the salt
reservoir with
water before the
first wash only.
Add salt
(never add
detergent!).
min. 1.5 kg
max. 2 kg
Visual indicator (depending
on model). Screw on the cap.
Salt residues around cap
need to be removed.
If required, open
the cover (press
lever).
Open the cover A
(press lever).
Only fill the
detergent dispenser
prior to starting a
wash programme.
Use only one tablet per cycle,
placed in the detergent
dispenser.
Tablet / gel / powder
Add rinse aid
to max.
line ~100 ml
The rinse aid dosage can be adjusted to the
detergent used. The lower the setting, the less
rinse aid is dispensed (factory setting: position 4).
Press the lever to open the cover. Using a coin or
similar object, turn the arrow to the desired
setting. After adjusting the rinse aid setting, shut
the cover again.
Visual
indicator B
Adding detergent -
Use only detergent specifically for dishwashers in accordance with the supplier’s recommendations
Filling the salt reservoir - Dissolve limescale (not necessary if water hardness level is set to “soft”!)


Product specificaties

Merk: Whirlpool
Categorie: Vaatwasser
Model: ADG SPACE IX
Apparaatplaatsing: Semi-ingebouwd
Gewicht: 50000 g
Breedte: 597 mm
Diepte: 555 mm
Hoogte: 820 mm
Aantal couverts: - couverts
Deurkleur: Niet van toepassing
Droogklasse: A
Duur cyclus: 165 min
Geluidsniveau: 48 dB
Waterconsumptie per cyclus: 12 l
Wasklasse: A
Aantal wasprogramma's: 5
Afmetingen verpakking (BxDxH): 640 x 660 x 845 mm
Kleur bedieningspaneel: Roestvrijstaal
Energieverbruik per cyclus: 1.05 kWu
AC-ingangsspanning: 220 - 230 V

Heb je hulp nodig?

Als je hulp nodig hebt met Whirlpool ADG SPACE IX stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Vaatwasser Whirlpool

Handleiding Vaatwasser

Nieuwste handleidingen voor Vaatwasser