Wasp WLR8900 Handleiding

Wasp Barcode lezer WLR8900

Lees hieronder de 📖 handleiding in het Nederlandse voor Wasp WLR8900 (41 pagina's) in de categorie Barcode lezer . Deze handleiding was nuttig voor 25 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/41

WLR 8900/8905

Programming Guide

Please Read

Note:

The Wasp WLR 8900/8905 Scanner is ready to scan the

most popular bar codes out of the box. This manual

should onl be used to make changes in they

configuration of the scanner for specific applications.

This scanner does not require software or drivers to

operate. The scanner enters data as keyboard data. Please

review this manual before scanning any of the programming

bar codes in this manual.

Tech Tip

If you are unsure of the scanner configuration or have

scanned the incorrect codes, please scan the default

bar code on page 6. This will reset the scanner to its

factory settings.

Check Version

No part of this publication may be reproduced or transmitted in any form

or by any means without the written permission of Wasp Technologies. The

information contained in this document is subject to change without notice.

Wasp is a trademark of Wasp Technologies. All other trademarks or registered trademarks are the

property of their respective owners.

Table of Contents

Chapter 1. Introduction ..............................................................................1

Chapter 2. Bar Code Symbologies............................................................2

Chapter 3. Installation................................................................................3

Chapter 4. Quick Start ..............................................................................4

Chapter 5. WLR 8900/8905 Setup & Configuration ............................5-28

1. Factory Default & Keyboard Connection ....................6

2. Autosense Stand Mode ..............................................6

3. Beep and Delay ......................................................7-8

4. Upper/Lower Case......................................................9

5. Keyboard Language ................................................10

6. Preamble/Postamble Configuration ..........................11

7. Terminator/Code ID ..................................................12

8. Enable/Disable Bar Code Symbologies ..............13-14

9. Bar Code Symbology Settings ............................15-27

Code 39 ..........................................................15

Interleaved 2 of 5 and Code 93 ......................16

Code 128 and UCC/EAN 128..........................17

MSI/Plessey ....................................................18

Codabar ..........................................................19

UPC-A..............................................................20

UPC-A Supplemental / UPC-A to EAN-13 ......21

UPC-E..............................................................22

UPC-E Supplemental ......................................23

EAN-8 ..............................................................24

EAN-8 Supplemental ......................................25

EAN-13 ............................................................26

EAN-13 Supplemental ....................................27

Appendix A Bar Code Test Symbols ....................................................28-30

Appendix B ASCII Table ......................................................................31-34

Appendix C Codes for PC ........................................................................35

Appendix D Technical Specifications ........................................................36

Product Support ....................................................................37

Warranty ................................................................................37

Frequently Asked Questions..................................................38

Product specificaties

Merk:	Wasp
Categorie:	Barcode lezer
Model:	WLR8900
Kleur van het product:	Zwart
Snoerlengte:	2.43 m
Type beeldsensor:	CCD
Ingangsspanning:	5 V
Temperatuur bij opslag:	-20 - 60 °C
Golflengte:	660 nm
Stroomverbruik:	150 mA
Standaard interfaces:	PS/2
Max. scangebied:	150 mm
Bedrijfstemperatuur (T-T):	0 - 50 °C
Lichtbron:	LED