Vitek VT-1230A-D18 Handleiding


Lees hieronder de đź“– handleiding in het Nederlandse voor Vitek VT-1230A-D18 (1 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 14 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/1
DC 12 30AV 18CH Power Supply Models - -VT 1230A D18!
Installation instruction:
1. Install box at desired location in a cool place. The power
supply can be wall . Make the hole position on mounted
the wall using the back of the box as a template and drill
four holes. Screw in the top two holes with the mounting
M4 screws hang the power supply box - tand hen affix
the bottom screws. Use drywall anchors if solid beams
are unavailable.
2. Knock out (remove) the appropriate perforated knockouts
for running cables through.
3. Turn power switch to “OFF” posi . tion
4. U” Connect each camera device to one "+U” & one “-
power output terminal. Be careful that the “+” & “-“ match
at the camera as well.
5. 11 Plug the AC plug into local 0VAC power outlet. Turn
power switch to “ON” position. The green LED light
should be on showing power is being supplied to the
camera.
6. Close the cover and secure it with provided screw.
Technical Specifications
Each channel is protected with a 1 Amp,PTC resettable .85
fuse.
Operation emperature: - +86 degrees F the t 14 to
Storage temperature: - degrees F 14 to +140
Notes:
1. When used in an extreme weather climate the power ,
panel may take up 30 seconds to boot up after initial
connection to power.
2. 2 To avoid the risk of fire use only type STP- wire or
heavier No.18AWG cop . Use wire gauge per at minimum
suitable for at least 194 degrees F.
!


Product specificaties

Merk: Vitek
Categorie: Niet gecategoriseerd
Model: VT-1230A-D18

Heb je hulp nodig?

Als je hulp nodig hebt met Vitek VT-1230A-D18 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Vitek

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd