Vimar 01985.120 Handleiding

Vimar Dimmer 01985.120

Lees hieronder de šŸ“– handleiding in het Nederlandse voor Vimar 01985.120 (1 pagina's) in de categorie Dimmer. Deze handleiding was nuttig voor 23 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/1
Viale Vicenza, 14 - 36063 Marostica VI Italy
Tel. +39 0424 488 600 - Fax (Italia) +39 0424 488 188 - Fax (Export) +39 0424 488 709
www.vimar.com
MASTER dimmer 120 V~ 60 Hz for incandescent lamps 40-500 W electronic
transformers 40-300 VA, CFL lamps 10-200 W, LED lamps 3-200 W, for LED
electronic power supplies, protection fuse, installation on DIN rails (60715
TH35), occupies 4 modules size 17.5 mm. For nautical scope.
ON/OFF switch and adjustment with two built-in buttons. MOSFET+TRIAC microprocessor
technology, works in both LE (Leading Edge) and TE (Trailing Edge) modes. MASTER function,
protection fuse. The device receives commands directly from the Busbar and is able to control
the load directly. It can also control up to 3 SLAVE dimmers for DIN rails 01986.120.
IMPORTANT: Lamps controllable from a single master or slave dimmer must all be the
same. All controllable loads must be declared DIMMERABLE by the manufacturer. Check
the type of compatible dimmering on the lamp package: LE (Leading Edge) or TE (Trailing
Edge). If it is not specified, the lamp can operate in both modes (chosen at the discretion
of the installer).
CHARACTERISTICS.
ā€¢ī˜ Ratedī˜supplyī˜voltageī˜TPī˜Busbar:ī˜29ī˜V
ā€¢ī˜ Ratedī˜supplyī˜voltageī˜mains:ī˜120ī˜V~,ī˜60ī˜Hz
ā€¢ī˜ Absorptionī˜fromī˜TPī˜Busbar:ī˜15ī˜mA
ā€¢ī˜ Dissipatedī˜power:ī˜7.8ī˜Wī˜
ā€¢ī˜ Terminals:ī˜N neutral, load, phase, L Sī˜synchronization,ī˜TPī˜Busbar
ā€¢ī˜ Protectionī˜fuseī˜typeī˜F5AH250V
ā€¢ī˜ Functionsī˜thatī˜canī˜beī˜accomplishedī˜withī˜theī˜dimmer:
- Switching on, off and dimmering
- Changing absolute brightness
- Actuating/saving scenarios
- Enabling "Flash Start" mode for CFL lamps
- "Ramp" operation
- Switch-off delay and warning function
-ī˜Phaseī˜cutting:ī˜LE/TEī˜
ā€¢ī˜ Localī˜controls:
Pressingī˜theī˜ button enables using the local buttons. All messages from the busbar are
ignored.
- Briefly pressing the button ī˜:ī˜ONī˜control
- Briefly pressing the button ī˜:ī˜OFFī˜control
-ī˜Pressingī˜andī˜holdingī˜downī˜theī˜buttonī˜ ī˜:ī˜Increaseī˜brightness
-ī˜Pressingī˜andī˜holdingī˜downī˜theī˜buttonī˜ :ī˜Decreaseī˜brightness
In normal operation (that is when the commands are sent over the bus) pressing the buttons
for the outputs is ignored.
ā€¢ī˜ Protectionī˜againstī˜short-circuitingī˜whenī˜turningī˜onī˜withī˜flashingī˜blow-outī˜indicator.
ā€¢ī˜ Thermalī˜protectionī˜withī˜flashingī˜blow-outī˜indicator.
ā€¢ī˜ MASTER-SLAVEī˜ function:ī˜ payingī˜ attentionī˜ notī˜ toī˜ exceedī˜ maximumī˜ powerī˜ controllableī˜ byī˜
each dimmer. A MASTER device can have up to 3 SLAVE dimmers (art. 01986.120) for a
maximumī˜totalī˜loadī˜ ofī˜2000ī˜Wī˜(VA)ī˜correspondingī˜toī˜500ī˜W/VAī˜maxī˜ connectedī˜toī˜eachī˜ofī˜
the 4 devices.
ā€¢ī˜ Installationī˜onī˜DINī˜railsī˜(60715ī˜TH35),ī˜occupiesī˜4ī˜modulesī˜ofī˜17.5ī˜mm.
CONFIGURATION.
FOR THE OPERATIONS OF INSTALLATION AND CONFIGURATION, SEE THE BY-ME
SYSTEM INSTRUCTIONS MANUAL ATTACHED TO THE CONTROL PANEL.
ā€¢ī˜Functionalī˜units:ī˜1;ī˜theī˜unitī˜canī˜belongī˜toī˜atī˜mostī˜4ī˜differentī˜groups.
ā€¢ī˜ Selectingī˜ theī˜ functionalī˜ unitī˜ (configuration):ī˜ duringī˜ groupī˜ creation,ī˜ whenī˜ theī˜ controlī˜ panelī˜
requiresī˜pressingī˜theī˜deviceī˜button:ī˜
-ī˜Itī˜isī˜recommendedī˜toī˜configureī˜theī˜deviceī˜withī˜theī˜loadī˜OFF;
-ī˜Pressī˜theī˜CONFī˜button,ī˜theī˜redī˜LEDī˜willī˜lightī˜up;
-ī˜ Withī˜ theī˜ redī˜ LEDī˜ on,ī˜ theī˜ controlī˜ panelī˜ willī˜ configureī˜ theī˜ functionalī˜ unit;ī˜ atī˜ theī˜ endī˜ ofī˜ thisī˜
operation the red LED will go out.
Controllable loads LE TE
40 to 500 W 40 to 300 W
10 to 100 W 10 to 200 Wī˜(Maxī˜5ī˜lamps) (Max 10 lamps)
3 to 100 W 3 to 200 Wī˜(Maxī˜5ī˜lamps) (Max 10 lamps)
Electronic transformers
for halogen lamps
40 to 300 W
(Max 3 transformers type
L
)
40 to 300 W
(Maxī˜5ī˜transformersī˜typeī˜
C
)
Dimmering with Leading Edge mode Dimmering with Trailing Edge mode
INSTALLATION RULES.
Installation should be carried out in compliance with the current regulations regarding the instal-
lation of electrical systems in the country where the products are installed.
ā€¢ī˜ Itī˜shouldī˜beī˜usedī˜inī˜placesī˜atī˜aī˜temperatureī˜ofī˜betweenī˜-5Ā°Cī˜andī˜+45Ā°C.
ā€¢ī˜ Theī˜lampsī˜connectedī˜toī˜theī˜masterī˜orī˜slaveī˜mustī˜allī˜beī˜theī˜same.
ā€¢ī˜ Notī˜suitableī˜forī˜controllingī˜motorsī˜(e.g.ī˜fans,ī˜ventilators).
ā€¢ī˜Theī˜ratedī˜powerī˜levelī˜shouldī˜neverī˜beī˜exceeded.
ā€¢ī˜ Overloading,ī˜ powerī˜ surgesī˜ andī˜ short-circuitsī˜ mayī˜ irreparablyī˜ damageī˜ dimmers.ī˜ Beforeī˜
installation check the circuit carefully and eliminate any of the above causes.
ā€¢ī˜ Theī˜ dimmerī˜ doesī˜ notī˜ haveī˜ aī˜ mechanicalī˜ circuitī˜ breakerī˜ inī˜ theī˜ mainī˜ circuitī˜ andī˜ soī˜ isī˜ notī˜
galvanically separated. The circuit load should be considered always powered.
For further instructions see the manual enclosed with the control panel.
CONFORMITY TO STANDARDS.
For MARINE use,ī˜thisī˜deviceī˜hasī˜beenī˜submittedī˜toī˜theī˜followingī˜tests:
IECī˜60068-2-52ī˜-ī˜Testī˜Kb:ī˜Saltī˜mist,ī˜cyclicī˜(sodium,ī˜chlorideī˜solution),
IECī˜60068-2-6ī˜-ī˜Testī˜Fc:ī˜Vibrationī˜(sinusoidal)
Thisī˜deviceī˜compliesī˜withī˜partī˜15ī˜ofī˜theī˜FCC Rules (with the limits for a Class B digital device).
Operationī˜ isī˜ subjectī˜ toī˜ theī˜ followingī˜ twoī˜ conditions:ī˜ (1)ī˜ Thisī˜ deviceī˜ mayī˜ notī˜ causeī˜ harmfulī˜
interference, and (2) this device must accept any interference received, including interference
that may cause undesidered operation.
FRONT VIEW
CONNECTIONS
Maximumī˜lengthī˜ofī˜cablesī˜connectingī˜universalī˜MASTERī˜dimmerī˜andī˜universalī˜SLAVEī˜dimmer:ī˜100ī˜m
Connect at least the minimum load required to the universal master dimmer.
A:ī˜Indicatorī˜LED
B:ī˜Switchingī˜onī˜andī˜increasingī˜brightness
C:ī˜Switchingī˜offī˜andī˜decreasingī˜brightness
D:ī˜LEDī˜andī˜configurationī˜button
CHANGING FUSE
OFF
1.
01985.120
MASTER DIMMER
120V~
60Hz
40-50 0W LE
40-300W T E
CONF.
NLS
By-me
NLS
BUS
NLS
2.
01986.12001985.120 01986.120
N L S
TE Flash
Soft
LE
01986.120
SLAVE
DIMMER
40-500W LE
40-300W TE
120 V~ 60 Hz
N L S
TE Flash
Soft
LE
01986.120
SLAVE
DIMMER
40-500W LE
40-300W TE
120 V~ 60 Hz
N L S
01985.120
MASTER DIMMER
120 V~ 60 Hz
40-500W LE
40-300W TE
L
N
Bus
MASTER SLAVE SLAVE
A
B
C
D
BUS TP
LN
S
N L S
01985.120
MASTER DIMMER
120 V~ 60 Hz
40-500W LE
40-300W TE
01985.120
49400502A0ī˜ī˜01ī˜ī˜1309
VIMAR - Marostica - Italy


Product specificaties

Merk: Vimar
Categorie: Dimmer
Model: 01985.120

Heb je hulp nodig?

Als je hulp nodig hebt met Vimar 01985.120 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Dimmer Vimar

Vimar

Vimar 19153.M Handleiding

1 December 2024
Vimar

Vimar 20137.B Handleiding

1 December 2024
Vimar

Vimar 20138.N Handleiding

1 December 2024
Vimar

Vimar 19135.1 Handleiding

1 December 2024
Vimar

Vimar 20138.B Handleiding

1 December 2024
Vimar

Vimar 19137 Handleiding

1 December 2024
Vimar

Vimar 20140.B Handleiding

1 December 2024
Vimar

Vimar 14137.120 Handleiding

1 December 2024
Vimar

Vimar 14166 Handleiding

1 December 2024

Handleiding Dimmer

Nieuwste handleidingen voor Dimmer