Viking RVCH336SB Handleiding

Viking Afzuigkap RVCH336SB

Lees hieronder de 📖 handleiding in het Nederlandse voor Viking RVCH336SB (2 pagina's) in de categorie Afzuigkap. Deze handleiding was nuttig voor 41 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/2

Settings and Functions

ALWAYS turn on your hood before you

begin cooking to establish airflow in the

kitchen. Also let the blower run for a few

minutes to clear the air after you turn off

your cooking appliance. This will help

keep the kitchen air cleaner.

ON/OFF switch—Starts and stops the

blower. When turned on, the blower will

operate at the previous setting of the

speed control.

Blower speed knob—Turn

counterclockwise to decrease the blower

speed and clockwise to increase the

speed. The type of cooking you are

doing will dictate the speed of the

blower you use.

Light switch—Controls the 50-watt

halogen lights located in the front of

the hood.

Dimmer knob—Turn the knob

clockwise to brighten the lights and

counterclockwise to dim.

Cleaning and Maintenance

Cleaning Mesh Filters

As air passes through the filter, grease

particles collect on the stainless steel

screen inside the filter. The filters should

be examined periodically to assure that

all surfaces and parts are clean. This unit

is equipped with an alarm. Once the unit

has been in operation for 48 hours, the

letters “FILT” will appear on the display.

The filters can then be washed in a

dishwasher or in a sink with hot, soapy

water. Simple periodic cleaning will

ensure maximum effectiveness. DO NOT

use caustic detergent to clean the filters.

An abrasive or corrosive cleaner may

damage the finish. take theDO NOT

filters apart to clean them. It is not

necessary and will void the filter warranty.

Once the filters have been cleaned and

placed back in the hood, the display is

canceled by holding the scroll up (+) and

the scroll down (-) buttons for 5 seconds.

Maintaining Charcoal Filter

(Recirculating Hoods Only)

Replace the charcoal filters every 6 months

to 1 year depending on the amount and

type of cooking you do.

To replace, remove the mesh/charcoal filter

assembly and slide the charcoal filter out of

the channel and replace with a new one.

DO NOT put the charcoal filters in the

dishwasher.

Replacement filters are available through

your local Viking Range dealer, or you can

call the Viking Online Store at

1-877-834-8222 or visit vikingrange.com

C A U T I O N

For general ventilating use only. DO NOT

use to exhaust hazardous or explosive

materials and vapors.

Slide filter front over front lip. Push filter

rear up, then slide back over rear lip.

Slide filter front over front lip. Push filter

rear up, then slide back over rear lip.

Replacing the Light Bulbs

When removing bulbs, use an oven mitt

to protect your hand in case the bulb

breaks.

Cleaning Hood Canopy

Finishes in enamel or stainless steel are

highly resistant to damage or discoloration

due to grease, steam, and heat—provided

that reasonable care is given to the

equipment. The following suggestions will

help keep your hood looking new.

1. DO NOT allow an excessive

accumulation of grease. For best results,

you should wipe your hood clean with a

cloth dipped in warm, soapy water.

DO NOT USE ABRASIVE CLEANSERS,

STEEL WOOL PADS, OR ABRASIVE

CLOTHS. DO NOT use cleansers that

contain chlorides; the chlorides in the

cleaner could damage the stainless steel

finish. If you need to scrape stainless

steel to remove encrusted materials, first

soak the area with hot towels to loosen

the material, then use a wooden or

nylon spatula or scraper. DO NOT use a

metal knife, spatula, or any other metal

tool to scrape stainless steel.

2. Every 3 months give your hood a

thorough cleaning. On painted surfaces,

use a new coat of wax. A good wax

cleaner—available at either a grocery or

hardware store—will do both jobs at

once. On stainless steel surfaces, use a

good stainless steel cleaner and polish.

Renewing Enamel Finish

If discoloration occurs, you should

thoroughly polish the finish on your hood

to renew its gloss and luster and to

remove any grease residue which may

have a yellowing effect. Use any good

enamel polish, refrigerator polish, or

automotive polish.

Renewing Stainless Steel Finish

Regular cleaning is the best way to assure

that your stainless steel finish stays bright

and unscratched. Use lemon oil or stainless

steel polish to coat and protect stainless

steel.

LIGHTS FAN

PUSH ON/OFF PUSH ON/OFF

HIGHLOW HIGHLOW

Light switch ON/OFF switch

Dimmer knob Blower speed knob

Unscrew halogen bulb.

Replace the bulb with a 120 volt, 50-watt

halogen bulb.

C A U T I O N

DO NOT use a porcelain cleaner or

rough abrasive cleaner.

C A U T I O N

All brass special ordered parts are

coated with an epoxy coating. DO NOT

use brass cleaners or abrasive

cleansers on the brass option parts.

F21206 EN (051513)

VIKING RANGE, LLC

111 Front Street • Greenwood, Mississippi

38930 USA • (662) 455-1200

Hoods

IMPORTANT– Please Read and Follow (cont.)

IMPORTANT– Please Read and Follow

QuickReference

Warning and Important Safety Instructions

appearing in this guide are not meant to cover all

possible conditions and situations that may occur.

Common sense, caution, and care must be exercised

when installing, maintaining, or operating the

appliance.

ALWAYS contact the manufacturer about problems or

conditions you do not understand.

Recognize Safety Symbols, Words, Labels

Read and follow all instructions before using this

appliance to prevent the potential risk of fire, electric

shock, personal injury or damage to the appliance as

a result of improper usage of the appliance. Use

appliance only for its intended purpose as described

D A N G E R

Hazards or unsafe practices which WILL result

W A R N I N G

Hazards or unsafe practices which COULD

result in death severe personal injury or death.

C A U T I O N

Hazards or unsafe practices which COULD

result in minor personal injury.

All safety messages will identify the hazard, tell you

how to reduce the chance of injury, and tell you what

can happen if the instructions are not followed.

W A R N I N G

To reduce the risk of fire, electric shock, or

injury to persons, observe the following:

• Use this unit only in the manner for which it is

intended. If you have any questions, contact the

manufacturer.

• Before servicing or cleaning unit, switch power off

at service panel and lock service panel to prevent

power from being switched on accidentally. When

the service disconnecting means cannot be

locked, securely fasten a prominent warning

device, such as a tag, to the service panel.

W A R N I N G

TO REDUCE THE RISK OF FIRE, ELECTRICAL

SHOCK, OR INJURY TO PERSONS,

RANGEHOODS MUST BE INSTALLED WITH

THE VENTILATORS THAT ARE SPECIFIED ON

THEIR CARTON INDICATING SUITABILITY WITH

THIS MODEL. OTHER VENTILATORS CANNOT

BE SUBSTITUTED.

W A R N I N G

To reduce the risk of fire, electric shock, or injury

when using your unit, observe the following:

• Installation work and electrical wiring must be

done by qualified person(s) in accordance with all

applicable codes and standards, including fire-

rated construction.

• Sufficient air is needed for proper combustion and

exhausting of gases through the flue (chimney) of

fuel burning equipment to prevent back drafting.

Follow the heating equipment manufacturer’s

guideline and safety standards such as those

published by the National Fire Protection

Association (NFPA), and the American Society for

Heating, Refrigeration and Air Conditioning

Engineers (ASHRAE), and the local code

authorities.

• When cutting or drilling into wall or ceiling, do not

damage electrical wiring and other hidden

utilities.

• Ducted fans must always be vented to the

outdoors.

W A R N I N G

To reduce the risk of fire, use only metal ductwork.

C A U T I O N

To reduce risk of fire and to properly exhaust air,

be sure to duct air outside. vent exhaustDO NOT

air into spaces within walls or ceilings, or into

attics, crawl spaces, or garages.

C A U T I O N

For general ventilating use only. use toDO NOT

exhaust hazardous or explosive materials and vapors.

C A U T I O N

If the power to the hood is not disconnected during

cleaning, the heat sensor thermostat can cause the

blower to turn on.

W A R N I N G

To reduce the risk of fire, electric shock, or

injury to persons, observe the following:

• Use this unit only in the manner for which it is

intended. If you have any questions, contact the

manufacturer.

• Before servicing or cleaning unit, switch power off

at service panel and lock service panel to prevent

power from being switched on accidentally. When

the service disconnecting means cannot be

locked, securely fasten a prominent warning

device, such as a tag, to the service panel.

W A R N I N G

To reduce the risk of a rangetop grease fire:

• NEVER leave surface units unattended at high

settings. Boil-overs cause smoking and greasy

spillovers that may ignite. Heat oils slowly on low

or medium settings.

• ALWAYS turn hood ON when cooking at high

heat or when cooking flaming foods.

• Clean ventilating fans frequently. Grease should

not be allowed to accumulate on fan or filters.

• Use proper pan size. use cookwareALWAYS

appropriate for the size of the cooking area.

W A R N I N G

To reduce the risk of injury to persons in the

event of a rangetop grease fire, observe the

following: (Based on “Kitchen Firesafety Tips,”

published by NFPA.)

1. SMOTHER FLAMES with a close fitted lid,

cookie sheet, or metal tray, then turn off the

burner. BE CAREFUL TO PREVENT BURNS.

If the flames do not go out immediately,

EVACUATE AND CALL THE FIRE

DEPARTMENT.

2. NEVER PICK UP A FLAMING PAN. You may

be burned.

3. DO NOT USE WATER, including wet dishcloths

or towels–a violent steam explosion will result.

4. Use an extinguisher ONLY if:

• You know it is a Class ABC extinguisher, and

you already know how to operate it.

• The fire is small and contained in the area

where it started.

• The fire department is being called.

• You can fight the fire with your back to an exit.

C A U T I O N

Unplug power cords from control panel before

cleaning or servicing hood.

C A U T I O N

DO NOT place flammable material on warming

shelves when using heat lamps.

C A U T I O N

All brass special ordered parts are coated with an

epoxy coating. use brass cleaners orDO NOT

abrasive cleansers on the brass option parts.

C A U T I O N

DO NOT use a porcelain cleaner or rough abrasive

cleaner.

Product specificaties

Merk:	Viking
Categorie:	Afzuigkap
Model:	RVCH336SB

Heb je hulp nodig?

Als je hulp nodig hebt met Viking RVCH336SB stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Afzuigkap Viking

Viking VCIH56608SS Handleiding

30 Augustus 2023

Viking TVWH360FW Handleiding

19 Juni 2023

Viking VWH3010AR Handleiding

6 Juni 2023

Viking TVWH660AW Handleiding

5 Juni 2023

Viking VBCV54838 Handleiding

24 Mei 2023

Viking VDD5480SS Handleiding

22 Mei 2023

Viking VWH530481SS Handleiding

15 Mei 2023

Viking VDD5450SS Handleiding

11 Mei 2023

Viking VCIH55408VC Handleiding

10 Mei 2023

Viking VCWH53048CB Handleiding

9 Mei 2023

Handleiding Afzuigkap

Nieuwste handleidingen voor Afzuigkap

Smeg SA940CXA Handleiding

21 November 2024

Smeg K181X90 Handleiding

21 November 2024

Smeg KSET66VSE2 Handleiding

21 November 2024

Smeg KSP90XE Handleiding

21 November 2024

Smeg KQR45NE Handleiding

21 November 2024

Smeg KSP60HXE Handleiding

21 November 2024

Smeg KSC90B Handleiding

21 November 2024

Smeg KI70E Handleiding

21 November 2024

Smeg KSC120B Handleiding

21 November 2024

Smeg KSGT56B Handleiding

21 November 2024